1. Position the Physician Scale on an even floor and press the ON/OFF key.
2. The instrument performs a self-test after which it is ready for operation.
3. Press the ON/OFF key and the machine switches off.
4. The person to be weighed can sit on to the chair once the scale shows 0.0 on the display.
The weight will be display in Kg. or lb. depending on the units chosen by the user.
5. If the weighing value is to be tared press the tare key to remove the weight value from the display.
6. Press the UNIT key for changing the weighing unit to kg or lb. The LED will indicate the
chosen weighing unit.
7. Overload display: When “FULL” appears on the display, it shows that the load on the chair
is over the maximum capacity. Under these circumstances, it is necessary to reduce the load
otherwise the sensor or the chair will be damaged.
8. Hold Function: To lock the weighing result, press the PRINT/HOLD key. The LED will flash
until a stable reading has been obtained and then it will light up constantly. The weight will
be displayed until the hold time has expired (see Sec 6.0) or to manually release the function,
press the PRINT/HOLD key again.
9. Print Function: To send the weighing result to a printer or computer press the
PRINT/HOLD key when the PRINT/HOLD key has been set up in the parameter section to
work as print function.
1. While measuring the height, it is necessary to pull up the measuring board at a right angle
with the inside tube.
2. When the tube is pulled out straight, it is sufficient to measure the height from
24"-45.5" / 60-115cm. The number can be obtained upon the conjoint place where the upper
part of middle tube screw meets with the inside tube scale.
3. Further, if the middle tube is pulled out straight, it is possible to measure the height from
45.5"- 83" / 115-212cm. The reading can be obtained at the conjoint place where the upper
part of outside tube screw meets with the middle tube scale.
1. Once the height has been determined it is possible to enter the height reading into the display
ready for the scale to compute the BMI.
2. Press and hold the UNIT/BMI key to enter the BMI mode. The display will show the last height
value used, or depending on which weighing unit you are currently using.
3. The height entry unit (in. or cm) will be flashing to show you which unit you are currently in, use
the Up arrow key to change the height entry unit between in. to cm as required
4. Enter your height using the arrow keys, the PRINT/HOLD will increment the flashing digit, the
right arrow, the UNIT/BMI key, will move the flashing digit to the adjacent digit.
5. Press the TARE key to confirm the value.
6. The display will now show the BMI based on the current weight on the scale and the height entered.
7. Press the UNIT/BMI key to exit the BMI mode and return to normal weighing.
8. The Hold function will work as described above whilst in the BMI mode.
OPERATIONS & SETTINGS
7.
WEIGHING
MEASURING HEIGHT
MEASURING BMI (BODY MASS INDEX)
