Congratulations. Your vehicle is protected by an
Autowatch vehicle security system designed to give
years of trouble free operation, made with only the
highest quality components and using state of the
art technology you can be assured that your vehicle
has the best electronic protection available.
INTRODUCTION DISARM
ARM
ANTI HIJACK IMMOBILISER (OPTIONAL)
1 arming tone and park lights flash once.
The status light flashes armed sequence.
3 flashes – pause – 3 flashes…
2 disarming tones and the park lights flash
twice. The status light extinguishes.
The status light illuminates for 1 second to
indicate that hijack has been cancelled.
A “door open” warning tone can be programmed by your Autowatch dealer.
The “on” and “off” tones may be de-selected by your Autowatch dealer.
Failure to do so will result in warning tones, slowing down of the vehicle followed by immobilization
and siren/hooter at full volume with park lights flashing, press the cancel button at any stage to exit.
HIJACK SERVICE MODE
With the alarm disarmed, press and hold the
hijack cancel button. While depressed, press the
arm or disarm button on the remote.
To re-select hijack, repeat the above procedure.
2 tones will be heard indicating the hijack
feature is disabled.
1 tone will be heard indicating the hijack
feature is enabled.
(Use this feature to avoid revealing the location of the cancel button)
If the vehicle is bumped. The siren/hooter will sound momentarily and
the park lights will flash.
EARLY WARNING DETECTION (OPTIONAL)
A tone is heard indicating the feature is
deselected for this arm cycle.
EARLY WARNING ISOLATION
Press the Arm button a second time within one
second after turning the alarm on.
Each zone will trigger the alarm a maximum of 3 times per “on” cycle.
INTRUSION DETECTION
The Alarm will detect a significant impact to the
vehicle, the ignition being switched on and doors,
bonnet or trunk opening.
The siren/hooter will sound and the hazards
flash for 30 seconds, unless the remote is
pressed.
ARMING OF THE ALARM
DISARMING OF THE ALARM
Press the Arm button momentarily.
Press the Disarm button momentarily.
Press the hidden cancel button after switching
the ignition on, or opening the hijack door/s.
IMPACT SENSOR ISOLATION
REMOTE PANIC
A tone is heard indicating the feature is deselected
for this arm cycle.
The siren/hooter will sound and the hazards flash,
unless the remote is pressed.
The doors will lock.
The doors will lock/unlock.
The doors will unlock.
The passenger doors will unlock.
The driver’s door will unlock.
The doors will lock.
Press the Arm button a third time within 1
second after isolating early warning..
Press and hold the Arm or Disarm button
on the remote for 3 seconds.
Turn the alarm on.
With the ignition on, press the remote.
Turn the alarm off.
CENTRAL LOCKING (OPTIONAL)
SELECTIVE UNLOCKING (OPTIONAL)
Turn the alarm off.
Press the Disarm button again.
LOCK WITH IGNITION (OPTIONAL)
Switch the ignition on with doors closed.
Inside Pages 1 Inside Pages 2
Inside Pages 3
