5. Functions Explanation
Please follow with the quick user guide carefully!
a.
Vibration Alert:
This vibration alert function just work under stationary
status. How to use this function:
* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Enable the device to enter into arm mode by this
sms command: 111
* Conifgure the alarm ways by thissms command:
vibalm123456
For example:
* Keep the device under stationary status more than 5min tolet it enter into sleep arm mode;
* Vibrate the device then the tracker willsend the vibration alarm messages
b. Cut Off Fuel/Resume Fuel
* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Send this sms command from the admin number tocut
off fuel:555
For example:
NOTE
:About the cut off fuel function, firstly please
make sure the fuel circuit isconnecting to main power. Secondly,
it has 3 different performance, please read it carefully:
* If the network signal and satellite signal both are available, when the equipment speed
exceeds 20km/h, the fuel circuit will not be cut off immediately, it will cut off intermittently
till the speed is below 20km/h, then just can becompletely cut off.
* In the tracker has network signal and but no satellite signal, the fuel circuit will becut
off intermittently, after 2, 3 minutes it will becut off completely;
* If the tracker stopped more than 5 minutes, the fuel circuit will be cut off immediately,
and then connected, butif you vibrate the tracker or vibrate the tracker the fuel cirsuit will
be cut off immediately;
