Introduction
The Auto-Maskin NMEA2000® to
J1939 CANbus Gateway is designed to
convert Latitude, Longitude, Compass
Direction and Vehicle Speed messages
on the NMEA2000® network onto the
J1939 network.
This unit is designed to operate in a
protected marine environment such as
an engine room. It is very important
that it is installed and set up correctly
according to this manual.
Please read the entire manual before
starting the installation, and follow the
setup instructions carefully to achieve
the best results.
Firmware Revisions
The information in this manual
corresponds to the gateways firmware
revision 1.0.0.
Note! The Auto-Maskin Marine Pro
engine panels require firmware 2.11
and above to support this gateway.
Product Features
Connection to J1939 CANbus
network using a 3-pole Wago cage
clamp connector
Green LED confirming valid J1939
CANbus message transmission
NMEA2000® micro C interface plug
User settable NMEA Device Instance
using rotary switch
User settable NMEA GPS Device
Instance using rotary switch
Blue LED confirming NMEA GPS
data reception
NMEA2000® interface optically
isolated from the J1939 CANbus
Power drawn only from the
NMEA2000® interface
Panel or DIN-rail mounting option
