WARNINGS
WARNINGS
READ THIS PAGE!
*WARNING!
Federal law
49 cfr
art 571
re
uires that the Final Sta
e Manufacturer of a vehicle
certify that the vehicle complies with all applicable federal regulations. Any modifications performed
on the vehicle prior to the final state are also considered intermediate stage manufacturing and must
be certified as to compliance. The installer of this crane and body is considered on of the manufac-
turers of the vehicle. As such a manufacturer, the installer is responsible for compliance with all
applicable federal and state regulations, and is required to certify that the vehicle is in compliance.
*WARNING!
It is the further res
onsiblit
of the installer to com
l
with the OSHA Truck Crane
Stability Requirements as specified by 29 CFR part 1910.180 (C) (1).
* WARNING! NEVER OPERATE THE CRANE NEAR ELECTRICAL POWER LINES!
Death or serious in
ur
will result from boom
line
or load contactin
electric lines. Do not use
crane within 10 feet (3.05m) of electric power lines carrying up to 50,000 volts. One foot additional
clearance is re
uired for ever
additional 30
000 volts or less. SEE DANGER DECAL
P/N 040529
in this Owner's Manual.
* WARNING! NEVER.........................................
* EXCEED load chart ca
acities
centerline of rotation to hoist hook
.
* Un-reel last 5 wraps of cable from drum!
* Wrap cable around load!
* Attempt to lift or drag a load from the side! The boom can fail far below its rated capacity.
* Weld, modify, or use unauthorized components on any Auto Crane unit! This will void any
warranty or liability. Also failure of the crane may result.
* Place a chain link on the tip of the hook and try to lift a load!
* Use a sling bar or anything larger than the hook throat that could prevent the hook latch from
closing, thus negating the safety feature!
* Hold on any pendant Select Switch that will cause unsafe operating conditions!
* WARNING! In usin
a hook with latch
ALWAYS make sure that the hook throat is closed before
lifting a load! Proper attention and common sense applied to the use of the hoist hook and various
slings will prevent possible damage to material being hoisted and may prevent injury to personnel.
*WARNING!
Failure to correctl
lumb and wire crane can cause inadvertent o
eration and dama
e
to crane and/or personnel!
* WARNING! Auto Crane Com
an
remote controlled cranes are not desi
ned or intended to be
used for any applications involving the lifting or moving of personnell.
* WARNING! ALWAYS o
erate the crane in com
liance with the load ca
acit
chart. DO NOT
USE the overload shutdown device to determine maximum rated loads
if the crane is e
ui
ed
with this t
e of device.
