LIIMTUAKE0-00.fm 5 AUTEC - Air Series
A8 - Configuration Menu
PIN START UP submenu
PIN START UP submenu
As required by standards IEC 60204-1 and IEC 60204-32, non authorised use of the machine must be prevented. The
removable key “Key ID 0-1” and/or the PIN code used to start up the system make the radio remote control compliant
with such requirement.
Autec cannot be held responsible if this PIN is disabled.
The PIN START UP submenu is used to disable/enable the radio remote control start up with PIN code.
Carry out the following procedure with the transmitting unit switched off and the STOP pushbutton released.
1. Activate commands S0 and START and keep them activated until the green LED blinks (1 blink per second).
2. Activate in sequence the commands that compose the PIN code.
3. Activate command S1 repeatedly until LED 1 lights up.
4. Activate command S2 to confirm selection (the green LED blinks twice per second).
5. Activate command S1 repeatedly to choose the desired option:
- DISABLE: LED 1 blinks 3 times per second
- ENABLE: LED 2 blinks 3 times per second.
6. Activate commands S0, START and S2 and keep them activated until the green LED is steady on to save this setting.
PIN CODE submenu
The PIN CODE submenu is used to set a customised PIN code.
Note down the new customized PIN code in the technical data sheet; note down the three PIN pushbuttons.
Carry out the following procedure with the transmitting unit switched off and the STOP pushbutton released.
1. Activate commands S0 and START and keep them activated until the green LED blinks (1 blink per second).
2. Activate in sequence the commands that compose the PIN code.
3. Activate command S1 repeatedly until LED 2 lights up.
4. Activate command S2 to confirm selection (the green LED blinks twice per second).
You can choose the 3 commands you want to set as PIN code amongst all the commands on the unit.
If you want to start the radio remote control with:
- a single-command PIN code: activate the START command as first (PIN 1) and third (PIN 3) command
- a two-command PIN code: activate the START command as first (PIN 1) or third (PIN 3) command.
5. Activate the command you want to use as first command (PIN 1) of the PIN code (LED 1 and the green LED are steady on).
6. Activate the command you want to use as second command (PIN 2) of the PIN code (LED 2 and the green LED are steady
on).
7. Activate the command you want to use as third command (PIN 3) of the PIN code (LED 3 and the green LED are steady on).
PIN code is saved automatically.
SWITCH OFF submenu
The SWITCH OFF submenu is used to disable the transmitting unit's automatic switch off or to set the auto-switch off time;
after this time has elapsed, the transmitting unit switches off if no pushbutton is pressed.
Carry out the following procedure with the transmitting unit switched off and the STOP pushbutton released.
1. Activate commands S0 and START and keep them activated until the green LED blinks (1 blink per second).
2. Activate in sequence the commands that compose the PIN code.
3. Activate command S1 repeatedly until LED 1 and LED 2 light up.
4. Activate command S2 to confirm selection (the green LED blinks twice per second).
5. Activate command S1 repeatedly to choose the desired option:
- OFF: LED 1 blinks 3 times per second
- 2 min: LED 2 blinks 3 times per second
- 5 min: LED 1 and LED 2 blink 3 times per second
- 10 min: LED 3 blinks 3 times per second.
6. Activate commands S0, START and S2 and keep them activated until the green LED is steady on to save this setting.
