Audiovox 50-0300A-002 SERIES Manual de usuario

INSTALLATION INSTRUCTIONS

FOR

50-0300A-014 SERIES 1181282

50-0300A-002 SERIES 1181284

FORD EXPLORER / MERCURY MOUNTAINEER w/ SUNROOF

OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM

These instructions are intended for use only by experienced professionals in the automotive

customizing business. Special tools and equipment, as well as specialized handling and care

of product during installation, may be required. Before beginning this installation, carefully read

through the following instructions. Use extreme care when cutting headliner material.

Check for wiring or other componentry above headliner material. Cut only where indicated.

Materials/ Tools required for this installation:

1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter

3. Awl or similar tool 4. Razor knife or similar tool

5. 18 GA wire 4'-6' 6. 7mm Hex Socket Bit

7. Test Light 8. Audiovox Series 640/650 Video Module

Nov. 8, 1999

Printed in the U.S.A

INSTALLATION INSTRUCTION # 44-0039A

MATERIALS PROVIDED FOR INSTALLATION:

ITEM Description QTY 1

1SCREW, 6-32 X 3/4" PPH 6

2WASHER, 3.5 mm 42

3SCREW, # 8 X 1 1/2" PWH 1

4SCREW, # 6 X 1/2" PPH 2

5MOUNTING BRACKET 13

6SPEAKER GRILLE 1

7CONSOLE 14

8COVER PLATE 1

9COVER PLATE DECAL 1

INSTALLATION INSTRUCTION # 44-0039A Nov. 8, 1999

Printed in the U.S.A.

I. PREPARATION OF VEHICLE INTERIOR

1. Using the rear edge of O.E. sunroof opening as a

reference location, carefully measure & trim

headliner as shown. Caution: Before cutting

headliner material, check for wiring or other

componentry above headliner. Cut only where

indicated. Make sure that the 7" cut is centered

left to right in vehicle. See Figure 1.

DO NOT OVERCUT HEADLINER.

2. Remove and retain lens from middle O.E. dome light.

3. Remove and retain (3) three screws which secure

middle O.E. dome light. See Figure 2.

4. Construct a jumper harness that will connect

the vehicle’s dome light wires to the lights in

video system. Connect the white wire from

video system to the O.E. black/blue wire.

Connect the black wire from video system to

the chassis ground. See Figure 3.

5. Using a test light, test function of lights.

6. Install O.E. dome light in original manner.

FIGURE 1

FIGURE 2

FIGURE 3

7. Remove and retain (2) two O.E. screws from bracket.

See Figure 4.

8. Carefully pull back edge molding from rear of

sunroof opening. See Figure 4.

9. Insert mounting bracket (item 5 pg. 2) into headliner.

Slide bracket forward between headliner and roof

until tab engages O.E. roof panel. Align hole in

bracket with center rivet on roof panel.

See Figure 5.

10. Secure rear of bracket using (2) two O.E. screws,

previously removed.

11. Slide edge molding back into original position

around sunroof opening.

FIGURE 5

FIGURE 4

12. Install and route all video and audio cables, and

any other added component requirements to

their respective places in the vehicle. Refer to

component installation instructions for wiring

diagrams. The suggested routing of the video

system cable is as follows: Above the headliner

from video system to C-pillar. Down the C-

pillar to the floor. Route the power lead to an

accessory controlled source. Connect the

ground lead to the vehicle chassis. Route the

remaining wiring (RCA plugs, Remote Sensor

extension, etc.) to the VCP location. See

Figure 6. Connect per instructions included

with the video system. If video system if to be

used as a television, install an appropriate

antenna per instructions included with the

antenna.

II. INSTALLATION OF CONSOLE

IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED.

13. Raise console (item 6 pg.2) into approximate

position against headliner. Loosely install using (2)

two 6-32 x 3/4" screws (item 1 pg. 2) through the

smaller holes in bracket on console into threaded

clips on front of mounting bracket.

See Figure 7.

14. Using a scribe or similar tool, align hole in rear of

console with slot in rear of mounting bracket.

Loosely secure rear of console using (1) one # 8 x

1 1/2" screw (item 3 pg. 2). Make sure console

alignment is straight then tighten (2) two 6-32

screws previously installed. See Figure 7.

FIGURE 6

FIGURE 7

15. Release video screen from locked position.

Lower video screen to viewing position for

access to mounting location in top of video

system housing.

16. Raise video system into approximate position

and connect all wiring to components. Connect

wiring and cabling to video system per

instruction included with video system.

17. Check function of all component and lights. See

operating instruction for video system operations

check. For further assistance, refer to the video

system manual for the technical support phone

number listed for your area.

18. Insert video system into opening in console.

Note : Make sure wires do not get pinched between video system and console.

Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32x 3/4" screws (item 1

pg.2) and (4) four 3.5mm washers (item 3 pg. 2). See Figure 8.

Caution : Do not overtighten screws.

19. Tighten screw previously installed to secure rear of

console to headliner. Caution: Do not overtighten

screws or damage to vehicle roof may occur.

20. Raise video screen into locked position.

21. Install speaker grille (item 7 pg. 2). Align clips in

grille with holes in console and press firmly.

See Figure 9.

22. If speaker upgrade kit was not installed, install cover

plate (item 8 pg. 2) at front of console and secure

using (2) # 6 X 1/2" screws (item 4 pg. 2).

23. Install cover plate decal (item 9 pg 2).

FIGURE 8

FIGURE 9

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Sistema de vídeo para coche de Audiovox

Audiovox

Audiovox VODEXL10 A Manual de usuario

Audiovox

Audiovox FP1210 Manual de usuario

Audiovox

Audiovox MMD85 - 8.5 Inch Dropdown Video Monitor Manual de usuario

Audiovox

Audiovox AVXMTG10U Manual de usuario

Audiovox

Audiovox HR7008PKG Manual de usuario

Audiovox

Audiovox VOH1041DL Manual de usuario

Audiovox

Audiovox VOD285P Manual de usuario

Audiovox

Audiovox VDS102T Manual de usuario

Audiovox

Audiovox MMD 70 Guía de inicio rápido

Audiovox

Audiovox 50-0311x-015 Series Manual de usuario

Audiovox

Audiovox VOH704 - VOH 704 - LCD Monitor Manual de usuario

Audiovox

Audiovox HR7012 Manual de usuario

Audiovox

Audiovox Mobile Video 128-8342 Manual de usuario

Audiovox

Audiovox AVXMTGHR9HD Manual de usuario

Audiovox

Audiovox Mobile Video VOD128A Manual de usuario

Audiovox

Audiovox VOH802 - VOH 802 - LCD Monitor Manual de usuario

Audiovox

Audiovox VME 9325 BTA Manual de usuario

Audiovox

Audiovox Movies 2 Go AVXMTGHR1M Instrucciones de instalación y funcionamiento

Audiovox

Audiovox VME 9314 TS Manual de usuario

Audiovox

Audiovox ADV200 Manual de usuario

Audiovox

Audiovox HRDV700 Manual de usuario

Audiovox

Audiovox VME 9315BTA BTM 10 Manual de usuario

Audiovox

Audiovox Mobile Video VOD128A Manual de usuario

Audiovox

Audiovox VME 9120 TS Manual de usuario

Manuales populares de Sistema de vídeo para coche de otras marcas

Stinger

Stinger HEIGH10 RB10RAM13B Manual de usuario

Eonon

Eonon E1057 Manual de usuario

Milion

Milion D2223 Manual de usuario

Metra Electronics

Metra Electronics 99-8153 Manual de usuario

Voxx Electronics

Voxx Electronics HR8MA1 Manual de usuario

Axxera

Axxera AV604Bi Manual de usuario

Clarion

Clarion NX706E Manual de usuario

Pyle view

Pyle view PLDN74BTi Manual de usuario

Clarion

Clarion NX602 Manual de usuario

PowerAcoustik

PowerAcoustik PTID-5850N Manual de usuario

RCA

RCA DRC6296 - Twin 9" Mobile DVD System Guía del usuario

Lanzar

Lanzar SVDVD5 Manual de usuario

Kia

Kia MTXM100YPPE Manual de usuario

Eonon

Eonon E1060 Manual de usuario

Macrom

Macrom M-AN900 Manual de usuario

Hyundai

Hyundai BAPE-L3000N Manual de usuario

r.LiNK

r.LiNK RL2-UCON8-SM Manual de usuario

Blaupunkt

Blaupunkt DVP 01C Manual de usuario