Aube Technologies TH115 A/F/AF Manual de usuario

TH115 (120S/240S/240D)

Programmable thermostat

Thermostat programmable

Termostato programable

Owner’s Guide

Guide du propriétaire

Guía para el usuario

69-2617EFS-03

Read before installing

Lire avant l’installation

Leer antes de instalar

Models/Modèles/Modelos:

• TH115-A-120S/U

• TH115-A-240D-B/U

• TH115-A-240S-B/U

• TH115-AF-024T/U

• TH115-AF-120S/U

• TH115-AF-12VDC/U

• TH115-AF-240S/U

ENGLISH

TH115 (120S/240S/240D models)

Overview

Before you start..................................................2

About your thermostat........................................3

Controls..............................................................4

Display ...............................................................5

Installation

Installing the thermostat .....................................6

Wiring diagrams .................................................7

Connecting the floor sensor / remote control .....8

Setting the configuration switches......................9

Setup

Time and day....................................................10

Daylight Saving Time .......................................11

Floor temperature limits ...................................12

Preset temperatures.........................................13

Default schedule ..............................................14

Modifying the schedule ....................................15

Operation

Running the schedule (Automatic mode) .........16

Temporary override of schedule.......................16

Permanent override (Manual mode) ...............17

Before going on vacation (Vacation mode) ......17

Appendices

Error messages................................................18

Technical specifications....................................19

Warranty...........................................................20

Table of contents

Owner’s Guide

ENGLISH

Read the entire document

CAUTION:

• Installation must be carried out by a certified electrician and must comply with national and local

electrical codes.

• To prevent severe shock or electrocution, always cut the power at the service panel before working

with wiring.

• Use this thermostat for resistive loads only.

• Do NOT install the thermostat in an area where it can be exposed to water or rain.

• Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a

door), direct sunlight or concealed chimney or stove pipes (except for floor heating systems).

• For a new installation, choose a location about 1.5 m (5 ft.) above the floor.

• Install the thermostat on an inside wall facing the heating system (except for floor heating systems).

• Install the thermostat onto an electrical box.

• Use special CO/ALR solderless connectors if you connect the thermostat to aluminum wires.

• Keep the thermostat's top and bottom air vents (openings) clean and unobstructed at all times..

Before you start

TH115 (120S/240S/240D models)

ENGLISH

The TH115 programmable thermostat has three temperature control modes:

See page 9 on how to change the temperature control mode setting.

* Select models only; required for floor heating applications only.

About your thermostat

A mode: controls the ambient air temperature

F mode: controls the floor temperature using an external temperature sensor

AF mode: controls the ambient air temperature

maintains the floor temperature within desired limits using an external temperature

sensor

Supplied Parts

• One (1) thermostat

• Two (2) mounting screws

• Four (4) solderless connectors for copper wires

• One (1) floor sensor *

• One (1) flat-tip screwdriver *

Owner’s Guide

ENGLISH

Controls

On/Off or

On/Standby

switch*

Day button

Temperature adjustment buttons**

Program button

Mode selection / program exit

Preset temperature buttons

(see page 13)

Backlight button**

Program clear button

Hour button

Minutes button

Place at Off/Standby to cut power to the heater (e.g., in the summer). This will not affect the time and temperature settings.

** When the backlight button or either of the buttons is pressed, the display illuminates for 12 seconds.

TH115 (120S/240S/240D models)

ENGLISH

Display

Temperature*

Operation mode icon

(see pages 16 & 17)

Period (see page 14)

Time

Number of flames varies

according to heating intensity

Preset temperature icon (see page 13)

Appears when the setpoint

temperature is displayed*

Temperature control mode

(see pages 3 & 9)

Day

* The thermostat normally displays the actual (measured) temperature. To view the setpoint temperature, briefly press

either of the buttons. The setpoint will appear for 5 seconds. To change the setpoint temperature, press one of the

buttons until the desired temperature is displayed. To scroll faster, press and hold the button.

Owner’s Guide

ENGLISH

Turn the heating system off at the main electrical panel.

Loosen the bottom screw and remove the thermostat faceplate from its

wallplate. (The screw cannot be completely removed.)

Connect the thermostat to the load and to the power supply (see page 7).

If the thermostat will be used in F or AF Mode (see page 9), connect the

floor sensor (see page 8).

WARNING: For floor heating applications, you must install a separate

ground protection device at the main electrical panel or use a thermostat

with built-in ground protection device.

If you wish to connect a remote control device, see page 8.

Install the wallplate to the electrical box using the provided screws.

Set the configuration switches on the back of the faceplate (see page 9).

Install the faceplate back on the wall plate and tighten the screw.

Apply power to the heating system at the main electrical panel.

Installing the thermostat

Wallplate

Faceplate

TH115 (120S/240S/240D models)

ENGLISH

NOTE: Connect the wires using the provided solderless connectors for copper wires.

Wiring diagram

Power

Load

Power

Load

120S / 240D models 240S model

Black

Red

White (120S)

Red (240D)

Owner’s Guide

ENGLISH

Insert the floor sensor cable through one of the two

openings on the wallplate and connect the sensor

wires to terminals 3 and 4 (no polarity).

• The sensor wires must not come in contact with the

electrical wires and must be routed outside the

electrical box and follow the wall down to the floor.

• Position the sensor cable such that it does not come in

contact with the floor heating wires. The sensor must

be centered between two floor heating wires for best

temperature control.

• Do NOT staple the sensor head (the plastic end) to the

floor. Doing so might damage the sensor. Any damage

might not be noticeable during testing but can become

apparent several days later.

If you wish to connect a remote control device (see

page 17), insert the wires (use 18- to 22-gauge

flexible wires) through one of the two openings on the

wallplate and connect them to terminals 1 and 2 (no

polarity).

Connecting the floor sensor / remote control

Floor

temperature

sensor

Remote

control

device

Otros manuales para TH115 A/F/AF

Tabla de contenidos

Otros manuales de Termostato de Aube Technologies

Aube Technologies

Aube Technologies TH115 A Manual de usuario

Aube Technologies

Aube Technologies EConnect Wireless Thermostat Kit TA7210 Manual de usuario

Aube Technologies

Aube Technologies TH141A-HC-28 Manual de usuario

Aube Technologies

Aube Technologies TH115-A Manual de usuario

Aube Technologies

Aube Technologies TH131 Manual de usuario

Aube Technologies

Aube Technologies TH114 Manual de usuario

Aube Technologies

Aube Technologies TH134/U Manual de usuario

Aube Technologies

Aube Technologies TH303 Manual de usuario

Aube Technologies

Aube Technologies EConnect Wireless Thermostat Kit TA7210 Guía del usuario

Aube Technologies

Aube Technologies TH115 120S Manual de usuario

Aube Technologies

Aube Technologies TH114 Manual de usuario

Aube Technologies

Aube Technologies TH115 A/F/AF Manual de usuario

Aube Technologies

Aube Technologies TH147 Manual de usuario

Aube Technologies

Aube Technologies TH131AF Manual de usuario

Aube Technologies

Aube Technologies TH135-01 Manual de usuario

Aube Technologies

Aube Technologies TH114-A-024T Manual de usuario

Aube Technologies

Aube Technologies TH115-A Manual de usuario

Aube Technologies

Aube Technologies TH132-AF Manual de usuario

Aube Technologies

Aube Technologies TH140-28 Instrucciones de montaje

Aube Technologies

Aube Technologies TH401 Manual de usuario

Aube Technologies

Aube Technologies TH110 Manual de usuario

Aube Technologies

Aube Technologies TH131 Manual de usuario

Aube Technologies

Aube Technologies TH115 A/F/AF Manual de usuario

Aube Technologies

Aube Technologies TH101A Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario

Honeywell

Honeywell T6811 Manual de usuario