YOUR NEW SUPERCAPACITOR
STARTER IS FULLY PROTECTED:
CHARGING TIME
7
6
Dynamic voltage display;
Working status display:
Charging, Full charge, Under voltage piease charge
Press START button screen display "TURN ON NOW". screen
display "TURN ON NOW". the device is entering working
conditions. start engine within 10S. it will entering standby
mode after 10S without operations.
Language selecting
Press START delays screen display "TURN ON NOW". screen
display "TURN ON NOW". the device is entering working
conditions. start engine after 10S. it will entering standby
mode after 10S without operations.
•
•
•
•
•
•
MODEL NO.
VIA 12V BATTERY
VIA 12V CIG. PORT
VIA 5V/2V USB
EM 335
<3minutes
<10minutes
<10minutes
WARNING
Modern vehicles contain extensive electronic systems, it is
strongly recommended to check with vehicle manufacturer for
any specific instructions regarding the use of supercapacitor
starter.
When charging by externala power source, do not charge the
appliance with 12V and 5 VAT the same time, it will damage the
appliance and the exteral power sources.
Over Load & Short Circuit Protection:
For overload & short circuit (start procedures are
unsuccessful), the appliance generates alert (sharp beep) to
warn the user, the “ENGINE” symbol will flash, please check if
there is any internal fault or the engine is out of the jump
start’s capability. Once remove the alligator clamps, the
appliance will stop beeping.
•
Reverse Electron Polarity Protection:
If the reversed electron polarity is connected, the appliance
generates alert (hurried beep) to warn the user, the “CAR
BATTERY” symbol will flash alternating, please remove
alligator clamps are removed and reconnect correctly. Once
the alligator clamps, the appliance will stop generating beep.
•
Over-charging Protection:
If the DC input or the alligator clamps receive abnormal high
voltage from external sources, the appliance generates alert
beep to warn the user, the “BAD BATTERY” symbol will flash,
please remove alligator clamps or DC input source and double
check to ensure the input voltage is correct. Once the alligator
clamps are removed, the appliance will stop generating beep.
•
Over Temperature Protection:
If the appliance is used intensively or under extreme high
temperature, micro-processor controlled electronic circuitry will
prohibit the emergency start feature. Please try again after a
moment or use the device under suitable environment.
•
