7
Light Switch operation – Momentary style
A momentary switch springs back to On when the lever is pressed down, an On/Off does not spring back (On/Off
see below) When installing a momentary switch type - the slider is on the left, LED outputs on the bottom.
unction Press How to trigger
On / Off
½ second
Push the switch down for under ½ second. The light will turn on and off
each time you press. See timer mode if enabled.
ade Override
½ second
If the light is in fading off slowly – the fade can be ended by pressing the
switch a 2
nd
time. or example – if the fade off time is 90 seconds, and you
wish the LED to turn off immediately – press the momentary switch twice –
the light will turn off without delay.
Adjust Color Temperature
hold
Press and hold the switch, the Slider now controls the color temperature –
release the switch when the color you like is reached. 1 second after
release, you can change the brightness
Reset to defaults:
Recalibrate the LED currents
Set switches to On/Off style
60
Press and hold the switch for 60 seconds. The switch will enter self
calibration mode the next time the light is turned on.
The LED operating mode after a reset will be Auto. The N-Way mode will
not be changed, and the N-Way switch will be changed from Momentary to
Rocker. The short address will not be changed
Restore to Momentary Style
5 times
½ second
Should the light not stay on when the momentary switch is pressed, the
device is in Rocker mode. Press the switch 5 times with less than 0.5
seconds each to change to Momentary operation.
Light Switch operation – On/Off style
A momentary switch springs back to On when the lever is pressed down, an On/Off switch does not spring back
When installing a On/Off switch type, the Slider is on the right. This mode requires a DALI master to enable
unction How to trigger
Exit Momentary Style
Should the not act like a simple On/Off switch, then it might be in Momentary style. A actory
reset will fix this.
actory reset – press switch top in, wait 60 seconds, turn switch off.
The device will return to On/Off style and will recalibrate.
Adjust Color Temperature
If the LED is off – move the slider. The light will turn on and you can adjust the color
temperature. After adjusting the color temperature – turn the switch ON, and you can adjust
the brightness. Turn the switch off and the color temperature and brightness will be saved.
Color mode will automatically end after 10 seconds.
Reset to defaults:
waiting to calibrate
switches are On/Off type
Set the dim to low dim. Turn the switch on for 2 seconds. Now off and on 8 times, quickly,
leaving it on after the last flip. The brightness will change to 50%, then go off
The switch will enter self calibration mode and the lights will flash.
