Atlantic Technology ICTS-6.1 Manual de usuario

Installation Instructions

Thank you for purchasing Atlantic Technology speaker products.These

high quality 2-way speakers solve a myriad of surround sound and

distributed audio installation problems. We work very hard to ensure

that all of our speakers consistently deliver exceptional performance

and value.

We hope you enjoy them to their fullest. Please take a moment to read

these instructions so you can get the most from your speakers.

Mounting Speciﬁcations

These speakers are intended for mounting in a ceiling,in material rang-

ing from ½ inch to 1 inch thick.They require at least 4 5

⁄8inches of depth

as measured from the front surface of the ceiling .The cutout opening

for the ICTS-6.1 is 7 3

⁄8inches in diameter (3 11

⁄16 inches radius). These

speakers will work equally as well in a wall as in a ceiling; however note

that they require more mounting depth than is normally available in a

2x4 studded wall.

Mounting Locations

Generally, it’s best to keep the speaker at least 24 inches away from any

nearby wall boundaries (wall/corner), since placing any speaker in

close proximity to other boundary surfaces will artiﬁcially reinforce

the upper bass/lower midrange sound, adversely “coloring” the sound

that the speaker produces.

The ICTS-6.1’s 1-inch dome tweeter is mounted in a pivoting housing,

so it to can be directed precisely towards the listening area for best

sound.

Model ICTS-6.1

When painting the grille...

™

ICTS-6.1-IP

Ceiling Speakers

Speciﬁcations

Dimensions 8 9⁄16” (220 mm)

Cutout Dimensions 7 3⁄8” (188 mm)

Mounting Depth (from front surface of ceiling) 4 5⁄8” (118 mm)

New Construction Bracket (optional) IC-NC-6.1

In-ceiling Back Box (optional) IC-BOX-6/8

Frequency Response 59-20kHz +/- 3dB

Sensitivity 88dB 1Watt/1 Meter

Recommended Ampliﬁer Power 10-100 Watts RMS

Impedance 6 ohms

Woofer 6 ½” Polypropylene cone

Tweeter 1” Pivoting soft dome

Net Weight 4.6 Lbs (2.1 kg)

1. Remove Scrim

2. Paint Grille

3. Reapply Scrim

For Connection to an IP-type system,like NetStreams®:

Unscrew the 4 setscrews

on top of the built-in

Phoenix connector and

pull the wires away from

the connector. See Figure

3 (You may tie or clip the

wires that used to connect

here.)

Connect the wires from

the NetStreams ampliﬁer

to the ICTS-6.1's Phoe-

nix connector and screw

down tightly.Consult your

NetStreams manual for

wiring details.

Atlantic Technology

343 Vanderbilt Avenue Norwood, MA 02062

(781) 762-6300 www.atlantictechnology.com

015-1061

New Construction and Retroﬁt Installations

Note: A new construction rough-in kit and back box kit are optionally

available from Atlantic Technology. Please refer to the instructions included

in those kits for their use. If the rough in kit has been used please go directly

to Step 2 below.

Mounting Hole Speciﬁcations:

ICTS-6.1: Diameter = 7 3⁄8in., 188mm; Depth = 4 5⁄8 in., 118mm

1Cut an appropriately sized opening in the ceiling material.Be sure that the

ceiling material can support the weight of the speaker.Also be sure that

the sides of the opening are at least 1 ½ inches away from any beams or

studs within the cavity.If it is not,the rotating clamps will be restricted

in their movement and may not clamp properly.

No less than 1 ½”

Joist

or Stud Joist

or Stud

Figure 1

2Be sure that all foreign material in the ceiling is kept out of the speaker

assembly,particularly the back of the woofer cone.There is a cloth shield

on the rear of the woofer, but please use care anyway.

3For conventional Connection to an audio ampliﬁer/receiver:

Attach the speaker wires that have been already run through the ceiling

to the speaker terminals. Simply remove ½ inch of insulation from the

end of each input wire. Push down on the terminal connector and an

opening will appear in the connector that is capable of holding up to 14

gauge wire.Insert the bare wire into the opening and release the terminal.

Be sure to observe correct polarity, connecting the positive (+) leads to

the red terminals and the negative (-) leads to the black terminals.Also

be sure that no stray strands of wire touch across any terminals. See

Figure 2.

Figure 2

Grille

Ceiling

Figure 3

4Mount the speaker in the ceiling.

Tighten the mounting screws one at a time. As you tighten the screws,

the clamps on the back of the assembly will turn and lower, grabbing

the back of the ceiling and sandwiching the ceiling between themselves

and the frame’s circular trim ring.

5Snug all four mounting screws in this manner. Be careful not to over-

tighten them.

IMPORTANT: If you are using an electric screwdriver, make sure it is

set to the“low torque”position.

6You may now install the grille into the frame by gently pushing it into

the recess.

Figure 4

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Oradores de Atlantic Technology

Atlantic Technology

Atlantic Technology IWCB-52 Manual de usuario

Atlantic Technology

Atlantic Technology IWTS-4 LCR Manual de funcionamiento

Atlantic Technology

Atlantic Technology 8200 System Manual de usuario

Atlantic Technology

Atlantic Technology ICTS 6.3e Manual de funcionamiento

Atlantic Technology

Atlantic Technology 251.1 LR Manual de usuario

Atlantic Technology

Atlantic Technology In-Wall Loudspeakers Manual de usuario

Atlantic Technology

Atlantic Technology lcr2 Manual de usuario

Atlantic Technology

Atlantic Technology IW Series Manual de usuario

Atlantic Technology

Atlantic Technology Atlantic FS-4000 Manual de usuario

Atlantic Technology

Atlantic Technology IWTS-14 SR Manual de usuario

Atlantic Technology

Atlantic Technology IWTS-14 LCR Manual de usuario

Atlantic Technology

Atlantic Technology IC Series Manual de usuario

Atlantic Technology

Atlantic Technology Atlantic FS-4000 Manual de usuario

Atlantic Technology

Atlantic Technology ICTS-6.3 Manual de usuario

Atlantic Technology

Atlantic Technology IWTS-6 CMS Manual de usuario

Atlantic Technology

Atlantic Technology IWCB-727 THX Manual de funcionamiento

Atlantic Technology

Atlantic Technology 6200C Manual de usuario

Atlantic Technology

Atlantic Technology 44-DA Manual de usuario

Atlantic Technology

Atlantic Technology 370IN-SRTHX Manual de usuario

Atlantic Technology

Atlantic Technology AT-1-S-GLF Manual de usuario

Atlantic Technology

Atlantic Technology 2200 C Manual de usuario

Atlantic Technology

Atlantic Technology IWTS-155 LCR Manual de usuario

Atlantic Technology

Atlantic Technology Gatecrasher 1 Manual de usuario

Atlantic Technology

Atlantic Technology 3.1 HSB Manual de usuario

Manuales populares de Oradores de otras marcas

argon audio

argon audio IE20 Manual de usuario

Denon

Denon SC-N7 Manual de usuario

Gemline

Gemline Ace 3952 Manual de usuario

Focal

Focal ON WALL 300 Manual de instrucciones

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manual de usuario

SoundLogic

SoundLogic BCCS-6/6395 Manual de usuario

Peavey

Peavey DTH 218 Manual de usuario

Avantree

Avantree Pluto Air Manual de usuario

Morel

Morel Integra Series INTEGRA OVATION 4 Manual de usuario

Oppo

Oppo SONICA Manual de usuario

Bose

Bose SoundLink Wireless Music System Manual de usuario

Rocksteady

Rocksteady Stadium Manual de usuario

Bowers & Wilkins

Bowers & Wilkins 4 Manual de usuario

Sonance

Sonance SONOS OUTDOOR Series Manual de usuario

Electro-Voice

Electro-Voice EVID FM4.2 Manual de usuario

Pioneer

Pioneer XW-HTD630 Manual de usuario

Onn

Onn BWA16AA002 Manual de usuario

HP GL313AA - USB Speakers PC Multimedia Manual de usuario