Assistive Technology Services SERVICE ANIMAL ALERT Manual de usuario

BATTERY PRECAUTION

 Necklace Panic Button Battery: (1)A23S Battery

 Wrist Panic Button Battery: (2) CR2016 Batteries

 When red LED is on (base unit), the backup batteries are low.

 If the LED on Necklace Panic Button turns red when Necklace Panic Button is pressed, it is

time to change the battery.

 If the LED on the Wrist Panic Button dims when the Wrist Panic Button is pressed and held,

it is time to change the battery.

Pairing the Pendants to the Base: If the base does not beep when the pendant is pressed it may need

to be ‘re-paired’ to the Base. Follow the instructions below to pair both pendants to the Base.

1. Turn power Off. (on

Base

Unit)

2. Turn power On

3. Within

seconds, press

and hold

the Big Blue Help Button on the

Base

Unit.

4. Then while still holding down the Big Blue Help Button on the Base

Unit, press the Panic Button

on the Necklace Pendant or the Wrist Pendant. (In one second, you will hear a small beep) This

means the pa

ring was successful.

5. Pairing will automatically erase other pendants that were previously paired, so you will have to

perform

the steps again for each pendant.

6. Turn

Base

Unit off.

7.Turn

Base

Unit O

n. Wait for Red LED to stop flashing.

8. Press

Pendant to Activate Alarm.

(This is to test the pa

ring process)

Assistive Technology Services

“Our mission is to provide evaluation, consultation,

spiritual

guidance and assistive devices to make

the quality of life better

for those that need a little help.”

Visit our website: AtsCares.com

SERVICE ANIMAL ALERT

email: [email protected]

Phone: 615-562-0043 v050819d

INSTRUCTION MANUAL

POWER AND TELEPHONE CONNECTION

 Open the cover at the top of Base unit (will see DC jack and

telephone plug socket)

 Insert one end of adaptor (included) to DC jack and other end

to AC power supply outlet

 Insert one end of telephone cable (included) into telephone jack

and other end into Base unit

For backup power, insert 4 AAA batteries (not included) into battery

compartment located on back of unit.

Turn ON unit with switch located at side of unit. The green LED (power

indicator) and red LED will flash for 3 seconds to indicate unit is ready to

record and store numbers.

PERSONALIZE EMERGENCY MESSAGE

Press and hold the above buttons on the keypad – at the same time.

The Red LED light will come on. You have (6) seconds to record your

personal message.

To playback your recorded message, press button:

NOTE: To change the recorded message, repeat steps above

Example: “I need help, please press a button to accept the call”

(If calling from a landline, 911 already has your location)

STORE TELEPHONE NUMBERS

To store telephone numbers, follow these steps:

Press button + 1 + phone number + to store first number

Press button + 2 + phone number + to store second number

Press button + 3 + phone number + to store third number

For Example: to store 1-615-562-0043 as the First contact

Press the following keys * 1 1 6 1 5 5 6 2 0 0 4 3 *

NOTE: If you make a mistake, simply repeat the process above.

*If storing only one number you must program that same number in all three

memory locations or unit will stop dialing after the first call.

OPERATION

When the Big Yellow Button is pressed the case will press down on the

Blue button contained inside and activate the alert system. Pressing the

button on the Wrist Panic Button or on Base unit will also activate the

alert system. Upon activation, the Base unit will dial the (3) preset

numbers automatically in the order they were programmed. It will call

each number for (45) seconds. The system will repeatedly play the

outgoing message until the receiver presses ANY button on their phone. If

the receiver does not answer the phone, it will keep dialing for (5) cycles

and then will stop and no longer call any numbers.

When the receiver answers the call from the system, they will hear the pre-

recorded message. The receiver of the call can then open up two-way

communication and listen to the caller’s surroundings by pressing ANY

number on their telephone keypad. After communicating for

approximately (45) seconds, the receiver will hear (3) “beep” tones to

advise the receiver to extend the talk and listen time. Receiver can extend

the time by pressing any number on their keypad to extend for another

(60) seconds. When the conversation is over, the Base unit will go back to

standby mode. The time to go back into standby mode can take up to

several minutes. If the call is answered, the Base unit will stop dialing the

remaining contacts.

Big Yellow Service Animal Alert

Button with Activation Necklace

Button inside. 3 white Styrofoam

Springs.

End view of

Big Yellow Service

Animal Alert Button with Activation

Necklace Button inside.

extra

hite Styro

foa

Springs

and Necklace Lanyard.

Power Supply, Telep

hone C

ord

and

Telephone Line Splitter.

Otros manuales de Sistema de seguridad de Assistive Technology Services

Assistive Technology Services

Assistive Technology Services Touch N Talk Manual de usuario

Assistive Technology Services

Assistive Technology Services SkyAngelFriends Manual de usuario

Assistive Technology Services

Assistive Technology Services SKY Angel 911 FD Manual de usuario

Assistive Technology Services

Assistive Technology Services TOUCH N TALK FD Manual de usuario

Manuales populares de Sistema de seguridad de otras marcas

Inner Range

Inner Range Concept 2000 Manual de usuario

Climax

Climax Mobile Lite R32 Instrucciones de montaje

CADDX

CADDX NX-6 Manual de usuario

FBII

FBII XL-31 Series Manual de usuario

Johnson Controls

Johnson Controls PENN Connected PC10 Manual de usuario

Aeotec

Aeotec Siren Gen5 Manual de usuario

Blaupunkt

Blaupunkt SA 2700 Manual de usuario

IDEAL

IDEAL Accenta Manual del propietario

AJAX

AJAX DoubleButton Manual de usuario

Swann

Swann SW-P-MC2 Manual de usuario

Ecolink

Ecolink Siren+Chime Manual de usuario

Digital Monitoring Products

Digital Monitoring Products XR150 Manual de usuario

EDM

EDM Solution 6+6 Wireless-AE Manual de usuario

Highway Safety Group

Highway Safety Group EA401 Manual de usuario

Siren

Siren LED GSM Manual de usuario

Detection Systems

Detection Systems 7090i Instrucciones de montaje

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manual de usuario

Siemens

Siemens FDM273 Manual de usuario