Asko TD25 Manual de usuario

Type: TD25

Service manual

This service manual describes tumble dryer type TD25 and is a supplement to the general service manual

for the 700 series.

Contents

Introduction .....................................................................................................................................................................................................3

Type overview .................................................................................................................................................................................................4

Programme.......................................................................................................................................................................................................5

Indication of programme sequence........................................................................................................................................................5

Options and settings.....................................................................................................................................................................................6

Variant settings ...............................................................................................................................................................................................8

Test programme..............................................................................................................................................................................................9

Troubleshooting...........................................................................................................................................................................................11

Components and measurement values...............................................................................................................................................13

Technical data................................................................................................................................................................................................15

Circuit diagram..............................................................................................................................................................................................16

Timer diagram TD25....................................................................................................................................................................................17

Service manual TD25

Revision history

Revision Date Description Initials

02 2008-04-28 TD25.1 can be speciﬁed with display. MW

Delayed Start 1-24h implemented W723 MW

Service manual TD25

Introduction

You are holding the service manual for the TD25 generation of tumble dryer.

There are two types of tumble dryer in the TD25 series: TD25.1 and TD25.3. The following page presents

the diﬀerent versions, to help you identify the machine types. The variants are named diﬀerently from mar-

ket to market. The type designation is the most important factor for identifying the machine type. The type

designation can be found on the machine plate, which is located inside the machine’s door.

It should be easy to service a tumble dryer. It is important that you, as a service technician, are given the

conditions to be able to carry out work in an eﬃcient and satisfactory way. Our hope is that this service

manual is a useful tool for your daily work.

Typbeteckning Produktnummer

Löpnummer

År Vecka

Type designation Product number

Week Serial number

Service manual TD25

TD25.3

Programme: 4 automatic programmes, 1 timer programme and 1 airing programme (For further infor-

mation, see the timer diagram at the foot of the document.)

Options: 4 (designations diﬀer depending on the market, see directions for use.)

Settings: Temperature.

Delayed Start 1-24h as of week 723

minmin

Airin

Normal dr

Iron dr

5 2

TTERFLY DRYIN

Type overview

TD25.1

Programme: 4 automatic programmes (For further information, see timer diagram at the foot of the

document.)

Options None.

Settings: Temperature.

T712

TTERFLY DRYIN

Program

Temperature

Extra dry

Dry Normal dry

Iron dry

TD25.3

Programme: 4 automatic programmes, 1 timer programme and 1 airing programme (For further infor-

mation, see the timer diagram at the foot of the document.)

Options: 2 (designations diﬀer depending on the market, see directions for use.)

Settings: Temperature.

Delayed Start 1-24h as of week 723

3 2

TTERFLY DRYIN

This type can be speciﬁed with display

Service manual TD25

Programme

When using tumble dryer TD25 it is possible to choose between four diﬀerent programmes that automati-

cally sense how damp the washing is. The machine dries to diﬀerent levels depending on which of the four

programmes has been selected on the front panel. The machine only has one automatic programme that

runs for diﬀerent lengths of time (and therefore dries to diﬀerent levels) depending on which of the four pro-

grammes has been selected on the front panel. The automatic programme runs for a maximum of 3 hours.

The machine has a Timer programme that runs for the time that is set (20 minutes – 2 hours), regardless of

whether the washing is dry or not.

The machine has an Airing programme that blows cold air for the time that is set (5 minutes – 2 hours).

Indication of programme sequence

During the programme, the current programme sequence is indicated by a ﬁxed light in the LEDs around

the start/stop button (see the image).

The cycle time is calculated during the start sequence.

Note!

If the door is opened whilst a programme is in operation, the programme will be interrupted and return to

the start position.

StartEnd

Cooling ¼ cycle time

¾ cycle time ½ cycle time

Service manual TD25

Options and settings

Options

Means that the drum will rotate 3 seconds per minute for 2 hours once the drying

programme has ﬁnished. The option prevents the fabrics from remaining in the

same position and becoming creased, which is good if you are unable to remove

them immediately after tumble-drying has ﬁnished.

If the Buzzer is also activated

a signal will sound each time the drum rotates, as a reminder that the drying pro-

gramme has ﬁnished.

Machines without display

Delays the start of the machine by 5 hours.

Activated by pressing the Time-delayed start button and then the start/stop but-

ton.

The number 5 in the display indicates that Time-delayed start has been activated.

The number of hours to start is displayed with a countdown from 5 to 1.

Deactivated by pressing the start/stop button for 3 seconds until the red ﬁeld next to

Time-delayed start goes out.

Machines with display

Start machine with 5 hour delay

Activated by pressing the “Delayed Start” button and then the Start/Stop button

The number 5 is shown on the display to indicate that Delayed Start is activated.

The number of hours to start is shown in a countdown from 5 to 1.

1 - 24h delayed start successively from week 723

Start machine with 1-24 hour delay. Activated by pressing the Delayed Start option

button as many times as the number of hours’ delay desired before starting (1-24 h)

and then pressing the Start/Stop button. The number of hours to delayed start

is shown on the display. The number of hours to start is shown in a countdown that

decreases 1 hour at a time.

This means that a buzzer will sound for 3 seconds when the drying programme

ﬁnishes.

Reduces cooling to 3 minutes.

Cannot be used in the Airing programme.

(In ”normal cases”when Short cooling is deselected, the machine cools for 15

minutes. )

Service manual TD25

Settings

Possible to set to a high or low temperature.

Normal temperature Low temperature

Airing dryer: 57°C 43°C

Condenser dryer: 73°C 50°C

Temperature setting cannot be carried out in the airing programme.

Service manual TD25

Variant settings

The following version settings can be made after replacing the control unit.

Total reset

1. Hold the start/stop button (S1) in, start the machine by pressing the main power switch and keep the

start/stop button depressed until one of the LEDs on the panel lights.

Buzzer

1. Hold S5 or S6 pressed in, start the machine by pressing the main power switch and keep S5/S6

pressed in until L1, L13 and L15 start to ﬂash.

2. Change the setting by pressing J1/S2. L8 lights when the buzzer is activated.

3. Conﬁrm your selection by pressing the start/stop button (S1).

10 A or 16 A

1. Hold the start/stop button (S1) in, start the machine by pressing the main power switch and keep the

start/stop button depressed until one of the LEDs on the panel lights.

2. Press the start/stop button (S1) 5 times. L1 starts to ﬂash.

3. Change the setting by pressing S2 or J1. L8 lights when 16 A is activated.

4. Conﬁrm your selection by pressing the start/stop button (S1).

Adjusting drying time

1. Hold the start/stop button (S1) in, start the machine by pressing the main power switch and keep the

start/stop button depressed until one of the LEDs on the panel lights.

2. Press the start/stop button (S1) for a further 5 seconds until L1 starts to ﬂash.

3. Change the setting by pressing S2 or J1. The selected setting is indicated as follows:

No adjustment: no LED:

+ 5 minutes: L8

+10 minutes: L9

+15 minutes: L10

+20 minutes: L11

4. Conﬁrm your selection by pressing the start/stop button (S1).

The control unit detects and adjusts automatically to the panel layout and machine model when the option

buttons are pressed several times.

L19

L10

L11

L12

L13

L14

L15

L16

L17

L18

S8 S4S6

S10

S9 S3

J1/S2

Main power switch

S = Push button

L = LED

Service manual TD25

Total reset of programmes

To access the test programme, total reset of the programme must be carried out as follows:

1. Cancel the current programme and switch oﬀ the machine by pressing the main power switch.

2. Hold the start/stop button (S1) in and start the machine by pressing the main power switch.

3. Check that any of the LEDs around the programme knob (L7 – L12) lights. This indicates that total

reset has been carried out.

Starting the test programme

4. Press button S7 (left-hand button on divided options button) and keep it pressed for approximately 20

seconds.

Note! This must be done within 3 seconds after carrying out total reset.

• All LEDs light up continuously. This indicates that the test programme has been activated.

Testing the motor and condensing waterpump

5. Press the start/stop button (S1).

• LED L6 lights up and is lit for the entire test program-

me.

•Condenser dryer: LED L8 lights up.

• Airing dryer: LED L7 lights up.

• The motor and condensing waterpump starts.

• Water ﬁlls the housing for the water tank until the

machine stops (check that the switch for condensation

water works).

6. Press the start/stop button (S1) to start the motor and

pump out the condensation water.

•LED L 2 lights up and is lit for the remainder of the test

programme.

Indication of faults:

Fault indication/symp-

tom Cause

The condensing

waterpump pumps until

S1 is reactivated and

L7 lights up (applies to

airing dryers).

The rear thermistor

does not have any con-

tact or is damaged.

The motor will not start. Motor or cable fault

The condensing water-

pump does not start.

Switch or cable fault

Test programme

The entire test programme is run in a sequence as follows. You can cancel the test programme at any time

during the programme by opening the door or pressing the main power switch.

L19

L10

L11

L12

L13

L14

L15

L16

L17

L18

S8 S4S6

S10

S9 S3

J1/S2

Main power switch

S = Push button

L = LED

Service manual TD25

Testing the element, thermistor and temperature regulation

7. Press the start/stop button (S1).

• LED L3 starts to ﬂash and the large element loop acti-

vates.

8. Press the start/stop button (S1).

• LED L3 lights continuously and the machine runs heat

regulation for 15 minutes.

•LED L4 starts ﬂashing, which means that temperature

regulation is ﬁnished.

•Cooling runs for 5 minutes.

• The machine stops.

Indication of faults:

Fault indication/symp-

tom

Cause

The element does not

start.

Element or cable fault

The programme stops.

F9 is shown in the dis-

play (applies to machi-

nes with a display).

The front thermistor is

not connected.

Testing the interval time and buzzer tone

9. Press the start/stop button (S1).

• LED L4 lights up.

• The motor starts and runs at intervals at the same time

as a buzzer sounds.

Indication of faults:

Fault indication/symp-

tom

Cause

No buzzer tone Fault in control

Cancel the test programme.

10. Press the start/stop button (S1).

• The test programme stops and ”End”is shown in the display (applies to machines with a display).

Otros manuales para TD25

Tabla de contenidos

Otros manuales de Secadora de Asko

Asko

Asko T712C Manual de usuario

Asko

Asko DC 7171 Manual de usuario

Asko

Asko T793C Manual de usuario

Asko

Asko T712 Manual de instrucciones

Asko

Asko T753C Manual de usuario

Asko

Asko T743C Manual de usuario

Asko

Asko T702C Manual de instrucciones

Asko

Asko TL751 XXLW Manual de usuario

Asko

Asko T701 Manual de usuario

Asko

Asko T744C Manual de usuario

Asko

Asko T756HP Manual de usuario

Asko

Asko T208H.UK Manual de usuario

Asko

Asko TD75.B2 Series Manual de usuario

Asko

Asko T793C Manual de usuario

Asko

Asko T743 Instrucciones de montaje

Asko

Asko T761 Manual de usuario

Asko

Asko PROFESSIONAL TDC112VS MARINE Manual de usuario

Asko

Asko T712C Manual de usuario

Asko

Asko 7305 - Manual de usuario

Asko

Asko TDC145V Manual de usuario

Asko

Asko TD70.1 SPO Manual de usuario

Asko

Asko T884XLCHP Manual de usuario

Asko

Asko T701 Manual de usuario

Asko

Asko Professional TDC145HPS Manual de usuario

Manuales populares de Secadora de otras marcas

Bosch

Bosch WTA79200GB Manual de usuario

Amana

Amana W10233410A Manual de usuario

Miele

Miele TWH 780 WP Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manual de usuario

Bosch

Bosch Logixx 10 WTB76556GB Hoja de especificaciones

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Manual de instrucciones

Electrolux

Electrolux EW2H328R2 Manual de usuario

Beko

Beko DS8433RX1M Manual de usuario

Dawlance

Dawlance Spinner DS 6000 C Manual de usuario

Electrolux

Electrolux TP5080TW Manual de usuario

AEG

AEG TR838P4OB Manual de usuario

Indesit

Indesit IDV 75 Manual de usuario

Infiniton

Infiniton SD-DG85C Manual de usuario

BOMANN

BOMANN WT 5019 Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manual de usuario

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manual de usuario

Frigidaire

Frigidaire CAQE7077KW0 Manual del propietario

Bosch

Bosch WTX8HKM9SN Manual de usuario