Ashly Ne8250c Manual de usuario

Advanced Simulation Technology inc.

500A Huntmar Park Drive

Herndon, Virginia 20170 USA

Tel. (703) 471-2104 • Fax. (703) 471-2108

asti-usa.com

Advanced Simulation Technology inc.

500A Huntmar Park Drive, Herndon, Virginia 20170 USA

Revision B, Version 0 (July, 2019)

Ashly Amplifier User Guide

Document: DOC-HW-ASH-UG-B-0

Product Name: Ashly Power Amplifier

Ashly Amplifier User Guide

Restricted Rights: Use, duplication, or disclosure by the Government is subject to restrictions as

set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software

clause at DFARS 252.227-7013.

This material may be reproduced by or for the U.S. Government pursuant to the copyright

license under the clause at DFARS 252.227-7013 (1994).

ASTi

500A Huntmar Park Drive

Herndon, Virginia 20170 USA

iii

Revision history

Date Revision Version Comments

7/26/2019 B 0 Converted content to XML. Updated content for gram-

mar, accuracy, and style.

Contents

1.0 Introduction 1

1.1 Dimensions 2

2.0 Getting started 3

2.1 Cooling 3

2.2 Set up an Ashly Power Amplifier 3

3.0 General information 5

3.1 Front indicator lights 5

3.2 Rear panel connections 5

3.3 Front panel controls 7

4.0 Technical specifications 8

4.1 Wiring 8

4.2 Minimum guaranteed power 8

4.3 Reliability 8

Appendix A: References 9

A-1 Ashly Power Amplifier part numbers 9

1.0 Introduction

Note: This document only pertains to Ashly Power Amplifiers and ASTi equipment. For gen-

eral information about the Ashly Power Amplifier, go to Ashly.com.

The Ashly Power Amplifier drives four to eight passive audio loudspeakers. Each amplifier is a

network device that integrates with ASTi’s Audio Communications Environment Network

(ACENet). ACENet provides a low-latency, network-based audio and I/O distribution archi-

tecture for ASTi’s Telestra and Voisus platforms. The amplifier also offers a full range of indic-

ators for accurate diagnostics. This document provides an overview of the ne8250c eight-

channel amplifier.

Figure 1, "New/old Ashly Power Amplifier chassis" below shows the new versus the old Ashly

Power Amplifier chassis:

Figure 1: New/old Ashly Power Amplifier chassis

Ashly Amplifier User Guide (Rev. B, Ver. 0)

1.1 Dimensions

Table 1, "Ashly Power Amplifier dimensions" below shows dimensions for ne8250c eight-chan-

nel Ashly Power Amplifiers:

Ashly Power Amplifier Depth Width Height

ne8250c (black chassis) 15.5 in 19 in 3.5 in

ne8250c (black chassis) 39.4 cm 48.3 cm 8.9 cm

ne8250c (silver chassis) 16.84 in 19 in 3.5 in

ne8250c (silver chassis) 42.77 cm 48.26 cm 8.89 cm

Table 1: Ashly Power Amplifier dimensions

Figure 2, "Ashly Power Amplifier front and rear panels" below shows the Ashly Power Ampli-

fier's front and rear panels:

Figure 2: Ashly Power Amplifier front and rear panels

Ashly Amplifier User Guide (Rev. B, Ver. 0)

2.0 Getting started

Important: Before installation, unplug the amplifier, and turn down the channel attenuators

on the front panel.

This chapter discusses the following topics:

lCooling

lSet up an Ashly Power Amplifier

2.1 Cooling

Do not block any of the amplifier ventilation vents. When using an equipment rack, mount the

units directly on top of each other. Do not block rear, front, or side air vents. The side walls of

the rack should be a minimum of one inch (2.5cm) away from the amplifier sides, and the back

of the rack should be open.

2.2 Set up an Ashly Power Amplifier

Figure 3, "Ashly Power Amplifier rear panel" below shows the Ashly Power Amplifier's rear

panel:

Figure 3: Ashly Power Amplifier rear panel

To set up an Ashly Power Amplifier, follow these steps:

1. Use the first or second port and a CAT5 cable to connect to the ACENet switch. Do not

connect both.

2. Connect the 10/100 Ethernet port to the ACENet switch.

3. Connect the alternating current (AC) power cord.

Ashly Amplifier User Guide (Rev. B, Ver. 0)

4. On the front panel, turn the channel attenuators all the way down.

5. Turn on the Power switch. The power indicator illuminates after a short boot-up

sequence.

6. After connecting the amplifier to the network, set up the amplifier on ACENet in the

Telestra Remote Management System.

Important: Disconnect the power cord before making any change to the installation or wir-

ing.

The analog input connectors are not used in the ASTi system setup.

Caution: Do not connect or disconnect speakers or ACENet while the amplifier is on.

Ashly Amplifier User Guide (Rev. B, Ver. 0)

Tabla de contenidos

Otros manuales de Amplificador de Ashly

Ashly

Ashly FTX-2001 Manual de usuario

Ashly

Ashly TM-360 Manual de usuario

Ashly

Ashly SRA-2075 Manual de usuario

Ashly

Ashly FET-2000C Manual de usuario

Ashly

Ashly PE Series Manual de usuario

Ashly

Ashly MA Series Manual de usuario

Ashly

Ashly mXa-1502 Manual de usuario

Ashly

Ashly CFT-1800 Manual de usuario

Ashly

Ashly MFA-6000 Manual de usuario

Ashly

Ashly FX Series Manual de usuario

Ashly

Ashly KLR 2000 Manual de usuario

Ashly

Ashly TM-360 Manual de usuario

Ashly

Ashly FA Series Manual de usuario

Ashly

Ashly NE 4200.25 Manual de usuario

Ashly

Ashly Electronic Amplifier none Manual de usuario

Ashly

Ashly 3.04 Manual de usuario

Ashly

Ashly SRA-2075 Manual de usuario

Ashly

Ashly CFT-1800 Manual de usuario

Ashly

Ashly PE-800 Guía de inicio rápido

Ashly

Ashly Power Amplifiers FET-200 Manual de usuario

Ashly

Ashly Pema 8250 Manual de usuario

Ashly

Ashly SRA-Series Manual de usuario

Ashly

Ashly INSTRUMENT PREAMP SC-40 Manual de usuario

Ashly

Ashly ne800 Manual de usuario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario

Ashly ne8250c Manual de usuario

Manuales populares de Amplificador de otras marcas