Arada BK736 Instrucciones de montaje
BK736 Rev 03 ISSUE DATE: 16/01/2023
EN13240:2011 +A2:2004
Rear Heat Shield Kit
Fing Guide
Oponal Accessory Instrucons
PLEASE RETAIN THIS GUIDE FOR FUTURE REFERENCE
23
Page 2 BK 736
1. Contents Of Kit :
2 no. Heat Shield Mount Brackets
(Stainless Steel—Unpainted)
2. Warnings :
IMPORTANT—Please ensure the appliance is cold and unlit before commencing fitting this
accessory kit.
Please refer to the main instruction booklet, relevant to your stove, for guidance on the installation
and operation of the appliance.
Please consult Health & Safety guidelines for advice on handling heavy and / or large items. When
lifting, we recommend you always obtain assistance
Arada Ltd will not be responsible for any consequential or incidental loss or injury however caused.
Please note, this accessory kit can only be fitted prior to the appliance (stove) being installed and
connected to the flue system, within the property.
When handling the components of the kit, it is recommended to wear suitable gloves to prevent
hand injuries.
1 no.
Heat Shield (Stainless
Steel—Unpainted)
REAR HEAT SHIELD FITTING GUIDE
Holborn /
Ecoburn S3
OR
M Series
PLEASE NOTE : All fixings are factory fitted to the
appliance during manufacture.
Page 3
BK 736
PLEASE NOTE: Images show Ecoburn S3, however procedure is the same
regardless of appliance model.
3. Fitting Procedure :
Before starting this process, please ensure that the stove is cold and unlit
Step 1 : Working on the rear of the appliance, remove the 4x screw, indicated in figure 1.
Figure 2. Mounting Brackets
4 No. Fixing
Locations
Figure 1. Fixing Locations
Step 2 : Take one of the mounting brackets and fix in
place using 2no. Of the screws removed in step 1.
See figure 2.
Please note the orientation of the bracket
REAR HEAT SHIELD FITTING GUIDE
BK 736 Rev 03
Step 3 : Repeat step 2 for the remaining mounting bracket.
Step 4 : Take the heat shield and position the mounting slots over the corresponding lugs
on each side mounting bracket. Gently engage the lugs and push down, to locate the heat shield
onto the mounting brackets as shown in figure 3.
Step 5 : With the heat shield fitted, please observe the revised distance to combustible
materials, as stated in the instruction manual or product fiche on web site.
Figure 3. Heat Shield Layout
Flue Pressure Test Point Location.
This can be accessed whilst the
heat shield is in situ.
Detailed View Of Engaged Lug
Locating The Heat Shield
REAR HEAT SHIELD FITTING GUIDE
3. Fitting Procedure Continued:
Date Of Issue: 16/01/2023
Arada Ltd, The Fireworks, Weycroft Avenue, Axminster, Devon, United Kingdom, EX13 5HU
Technical Help : +44 (0)1297 632052, www.aradastoves.com
Tabla de contenidos
Otros manuales de Accesorios para chimeneas de Arada
Manuales populares de Accesorios para chimeneas de otras marcas
Bronpi
Bronpi KIT-1 Manual de usuario
Town & Country Fireplaces
Town & Country Fireplaces 22150051 Manual de usuario
Travis Industries
Travis Industries 33 DVI Manual de usuario
Superior
Superior ASD3628-TI Manual de usuario
pleasant hearth
pleasant hearth OFP28WG Manual de usuario
IHP
IHP Astria Series Manual de usuario
