En - 7
unpackIng & aSSembly InStructIonS
• After unpacking the BLUE CLEAN POWER WASHER,
lay out the parts and accessories. Familiarize yourself
with the parts in the package by comparing them to
those listed on the “PACKAGE CONTENTS” page.
• The BLUE CLEAN POWER WASHER requires some
minor assembly, the accessory holder and the electric
power cord holder (Fig. 1). Slide these pieces onto the
grooves on the either side of the power washer.
High Pressure Hose
• Screw the high pressure hose (clockwise) on the back
of the unit at the bottom (Fig. 2). The end of the hose
must be inserted into the water outlet far enough so the
collar can thread onto the outlet threads until hand tight.
Do not use pliers or vice grips to tighten. If it takes fewer
than six or so turns you have not properly tightened the
high pressure hose tting. It is easier to position the
power washer in front of you to ensure that the threads
are started correctly. Failure to properly tighten the high
pressure hose will result in the hose slipping or popping
off immediately upon turning the unit on. Do not worry
about damage if this occurs - just reinstall and take extra
care at screwing on the high pressure hose tting.
• Connect the other end of the high pressure hose to the
spray gun by inserting the silver metal tip of the high
pressure hose into the tting under the trigger guard. It
will lock into the spray gun with a “click” (Fig. 3). Conrm
the hose is locked into the spray gun by pulling slightly
on the hose. The hose is now securely attached to the
spray gun.
• To release the hose from the spray gun, press the thumb
tab on the underside of the spray gun toward the trigger
guard. The hose will slide out from the connection.
Spray Gun
• To lock the trigger of the spray gun aim the spray gun
away from you and push the lock button from left to
right, (Fig. 4) after doing so, squeeze or pull the trigger
to make sure it is locked and will not move. Get in the
habit of leaving the lock button in the “locked” position
when the power washer is not in use. This ensures the
gun is in “safe” mode until it is ready for use.
Lance and Detergent bottle
• While the spray gun is in the locked position, insert the
adjustable lance, or the detergent bottle directly into the
end of the spray gun by inserting, pushing together and
Pump
High Pressure Hose
Fig. 1
Fig. 2
Fig. 3
2
Trigger
Safety Lock
1
Fig. 4
