Aquavolta AGE2 GO 2.8 Manual de usuario
!
AGE2GO 2.8!
Hydrogen Water !
Generator!
Manual
2 - What ist AquaVolta®?
•The brand name Aquavolta ® derives from the latin term for
water(aqua) and the name of the inventor of the battery,
Alessandro Volta. It stands for electro activated water.
•In Germany one originally spoke of electrolyte-water, afterwards
of “activated water”. In english it is often referred to as
„reduced“ or „ionized“ water.
•The characteristic of AquaVolta® is that a negative electrical
tension with a measurement electrode shows a so-called
negative redox potential.
•The lower the redox potential, the higher the willingness water
has of giving off electrons. Per 0,018 Volt (18 Millivolt) lower
redox potential does the willingness double. AquaVolta®
produces about 400 to 800 Millivolt lower redox potential than
tap water or mineral water from a bottle.
•Because of its high willingness to give off electrons, AquaVolta®
is also described as antioxidant water. It is not only used by
doctors for therapy, it has also established itself because of its
good taste as a modern day to day drink.
•Responsible for the antioxidant power of AquaVolta® according
to the current scientific view is the content of dissolved
hydrogen, or D H2. The AquaVolta® AGE2GO 2.8 was
developed to enhance this.
3 - What does AGE2GO mean?
•AGE2sounds in English like H2, the formula for
molecular hydrogen, the "gas of life", whose role in
the human body was only recognized in the 21st
century.
•However, when it became clear that dissolved
hydrogen was the decisive factor for the effect of
electrolyte water, which until then had only been
produced in alkaline water ionizers, an industry
developed which pressed hydrogen at high
pressure into aluminium cans or bags, where the
H2content could be maintained for several
months. This is not only very expensive, but also
causes large waste problems.
•Nevertheless, it was clear that consumers would prefer a
solution that would allow them to enjoy the rapidly degassing
hydrogen water not only at home, but also on the move. The
market demanded a mobile solution, in modern English
abbreviated "2 go".
•The solution was a modern form of electrolysis: the PEM cell.
Unlike a stationary water ionizer, it does not increase the pH
value of the water, but bubbles pure hydrogen under
pressure into the water. It discharges the oxygen into the air.
H2
O2
H2 water
ˈeɪtʃ%ˈtu ɡoʊ
•The third part of the word game AGE2GO lies in the English meaning
of the word AGE. "Reverse Ageing" was one of the buzzwords for this
water that emerged with the rediscovery of electrolyte water. So the
name of the device also means: "Age, time to go!"
4 – Always fresh hydrogen – free choice of water
With a device for on the move it is clear: The smaller,
the better.
Therefore, we have designed the AquaVolta® Age2
Go in such a way that it does not depend on a single
type of water. If you do not want to trust the existing
tap water, you can use any trustworthy bottled water
and even water from a reverse osmosis system (RO
water).
You can fill one of the two supplied glass cylinders
with the mineral water. Thanks to different bottle
adapters you can also enrich the water directly in the
mineral water bottle with hydrogen.
Restriction: The bottle may only be made of
stretchable material, not of glass. Glass bottles do
not fit onto the bottle adapter.
The water must not contain carbon dioxide.
Otherwise the gas pressure will rise too much and
the bottle or glass vessel could burst.
Suitable!
for RO water
No carbonated
water
No
glass bottles
➢Only use the device once you have read and understood
the instruction manual.!
➢Before switching the device on, the water container has
to be filled with water.!
➢Otherwise the electrolysis cell can be damaged and the
guarantee claims expire.!
➢You cannot fill it with water over 60 Degrees C.!
➢Only operate the device with 220 Volt.!
➢Please ensure that children do not have access to this
device.!
➢Never place the device under water. A moist cloth is
enough to clean it. Do not use chemical cleaning
products.!
➢Never drop the device.!
➢You should use cold water (under 30º C)!
➢Do not place the device in direct sunlight or subject it to
temperatures over 50 Degrees.
5 - General Safety Instructions
➢Stop use if water leaks out of the device.!
➢Do not place the device outdoors.!
➢Do not use the power charger if it got damaged or the
cable got kinked.!
➢Do not place heavy or pointed objects on the cable.!
➢Do not touch any of the components connected to
the power grid with moist fingers.!
➢Only use water of the best drinking quality if you
want to drink the water afterwards.!
➢You cannot use carbonated water (fizzy water,
sparkling water). The device could explode.!
➢Do not open the charger nor the base unit if defect.
Do not try to repair it. !
➢Disconnect the device immediately from the power
supply and inform your dealer.
14 cm
11 cm
6 – Scope of Delivery
Production unit
with protective cap
2 x Production
containers made of
borosilicate glass
Bottle adapter for !
28 mm screw thread
USB plug + Micro
USB cable
Box
1 x Pressure !
compensation
lid
Replacement seal
7 – The two operating modes
Basically the AquaVolta® AGE2GO 2.8 offers two
possibilities to produce hydrogen water: Either you use
one of the supplied production containers made of
borosilicate glass with the white pressure lid (a), or you
use a mineral water bottle with a capacity of up to 1.5
litres as a pressure chamber (b).
Since no overpressure regulation can be carried out with
a screwed-on bottle and, in addition, the sealing of glass
bottles cannot be guaranteed by the adapters, the use
of glass bottles is not permitted. Please use only
suitable plastic bottles.
In order to screw in bottles of different sizes, an adapter
for smaller than 28 mm bottle screw threads is also
included. To insert it, first unscrew the screwed-in
standard adapter counterclockwise by, for example,
using a fork as a turning aid, as shown in the picture.
Then turn the smaller adapter upside down and screw
into the thread.
Then turn the device upside down, screw it firmly onto
the bottle thread and then turn it up-right again to start
production.
Attention: This applies to (a) and (b):
a
b
The water must have no
carbon dioxide
8 – Preparing operation mode 1
1. Remove the protective
cap from the production unit
2. Remove the moisture cap.
3. The (-) electrode
(cathode) is now
visible. The cathode
should always remain
moist with water. When
storing longer place a
bit of water on the
cathode and then a film
in between the glass
and the device.
4. Screw the desired
glass container into
the screw thread of
the generator.
14 cm
11 cm
0,4 Liter
0,3 Liter
9 – Preparing operation mode 2
6. After completing point 5, if you prefer to
produce in a bottle with a narrow 28 mm
thread, replace the built-in large bottle
adapter with the supplied small bottle
adapter.
7. During phase 5, you should fully charge
the battery. Lift the rubber tab on the back
and connect the Micro-USB plug.
8. Insert the USB plug of the charging cable
into the power supply unit and plug it into a
220 V socket. See next page for charging
instructions.
5. Before the first operation, fill the glass
container with max. 60º C warm water and let
it stand for at least 2 hours to completely
moisten the membrane cell. Finally, replace
the water and shake for about one minute.
Then you can fill it with the water that you
want to enrich with hydrogen. Only enough
water should be filled in so that the water
level does not touch the pressure cover and
no water can get through.
10 – Charging
1. Place the device on a dry, flat surface.
2. Open the rubber flap over the charging socket.
3. Plug the USB cable into the charging plug and the other end into the
production unit. Before first use the battery has to be fully charged.
4. The LED starts to blink red.
5. When charging is complete it will shine permanently red.!
!
6. Remove the cable and close the rubber flap above the charging socket.
During first time charging, no hydrogen water is to be produced.!
!
7. If the LED light starts to blink during production, it needs to be charged up
again until the battery is fully charged.
Tabla de contenidos
