Aquatic AQ-MP-5UBT Guía
products with a watertight reputation
®
PLEASE READ THIS INSTRUCTION MANUAL BEFORE
INSTALLATION AND OPERATION
WATERPROOF MEDIA PLAYER
USER / INSTALLATION MANUAL
AQ-MP-5UBT - WATERPROOF MEDIA PLAYER
for iPhone, iPod, USB, Bluetooth & MP3 devices
1 Getting Started.........................................................................................................................
1.1 Contents.............................................................................................................................
1.2 Connections........................................................................................................................
1.3 12-pin Harness Connection.................................................................................................
1.4 Wiring Diagram...................................................................................................................
1.5 Mounting Precautions.........................................................................................................
1.6 Mounting the Media Player..................................................................................................
1.7 Power On............................................................................................................................
2 Location of Controls.................................................................................................................
2.1 Media Player Controls..........................................................................................................
3 Listening to Devices..................................................................................................................
3.1 Listening via Bluetooth.......................................................................................................
3.1.1 Pair with Bluetooth Device...........................................................................................
3.1.2 Listening via Bluetooth Device.....................................................................................
3.2 Listening via USB...............................................................................................................
3.2.1 Listening via USB (Apple Devices)...................................................................................
3.2.2 Listening via USB Flash Drives........................................................................................
3.2.3 USB Search......................................................................................................................
3.2.4 Device Charging...............................................................................................................
3.3 Listening via Auxiliary Input (3.5mm Jack).........................................................................
3.4 Adjusting Volume Level.......................................................................................................
4 Listening to FM/AM Radio.........................................................................................................
4.1 Enter FM Radio Mode..........................................................................................................
4.2 Scan or Navigate FM Radio Channels.................................................................................
4.3 Saving Radio Channel to Memory.......................................................................................
4.4 Listening to Saved Radio Memory.......................................................................................
4.5 Switch between U.S. and European FM Modes.....................................................................
5 Settings Operation....................................................................................................................
5.1 Audio Menu.........................................................................................................................
5.2 Menu...................................................................................................................................
5.3 AS/PS (Auto Scan/Preset Scan)...........................................................................................
5.4 Local/Distant Tuning...........................................................................................................
5.5 Stereo/Mono........................................................................................................................
5.6 FM Tuning Area...................................................................................................................
5.7 Beep Tone...........................................................................................................................
5.8 System Reset......................................................................................................................
6 Specifications & Dimensions....................................................................................................
4.1 Specifications.....................................................................................................................
4.2 Dimensions........................................................................................................................
7 Warranty Information...............................................................................................................
3
3
3
3
4
5
6
8
9
9
10
10
10
10
10
10
11
11
11
11
11
12
12
12
12
12
12
13
13
13
13
13
13
13
13
13
14
14
14
15
Table of Contents Media Player AQ-MP-5UBT
2www.aquaticav.com
• AQ-MP-5UBT Digital Media Player
• Wiring Harness (AQ-UNH-2)
• Four (4) Stainless Steel Mounting Screws
• Spare Fuse
• Mounting Template
• Mounting Bracket
• DIN Cage
• User/Installation Manual
1.1 Contents
1. 12-pin Watertight Harness
The 12-pin harness supplies power and ground connections to the Media Player and four (4)
speaker channel output connections from the Media Player (see also 1.3 below).
Do not cut or modify the 12-pin harness on the Locker side or warranty will be void.
2. FM/AM Radio Antenna Jack
Allows connection of FM/AM radio antenna. For best FM/AM performance make sure the
antenna is extended to the highest achievable position.
3. Auxiliary Outputs
Allows external amplifiers to be connected to power additional speakers.
4. Auxiliary Inputs
Allows an additional RCA input, from a standalone unit or another stereo source.
5. 8-pin DIN Cable
Allows connection of the wired Remote Control (AQ-WR-5F sold separately) or wireless
Remote Control (AQ-RF-34 sold separately) RF receiver.
6. Subwoofer Output
Allows powered (active) subwoofer to be connected via RCA connector.
7. 12V DC External Trigger (x2)
Allows for external lighting or relays to be triggered (350mA max load).
8. USB Input
USB for connection of Apple devices USB flash drives. Charges USB devices when
connected.
1.2 Connections (see Wiring Diagram 1.4)
The AQ-MP-5UBT includes the universal harness AQ-UNH-2 in order to connect the stereo to
power and speakers.
All open wire connections should be soldered and protected against water and dust for best long-
term performance.
1.3 12-pin Harness Connection (see Wiring Diagram 1.4)
Getting Started Media Player AQ-MP-5UBT
3www.aquaticav.com
1.4 Wiring Diagram
4
5
1
2
3
No lower than a 2 Ohm load should be used
or damage may occur to the Media Player.
Make sure the polarity of speakers are
connected correctly.
6
7
Getting Started Media Player AQ-MP-5UBT
4www.aquaticav.com
1. A mounting template is included. Aquatic AV recommends using the ‘measure twice,
cut once’ method!
2. Once the mounting hole is complete, make sure the outside surface is clean and
clear of debris. The Media Player has an external water/dust proof gasket, but this
requires a clean and at surface for best performance.
3. The Media Player has four (4) front screws. Drive the screws using a screw driver.
During nal mounting apply equal pressure to all points for the best water/dust outer
seal performance. Make sure screws are snug and do not over tighten.
4. Review all outside surfaces of the Media Player to ensure a proper water/dust seal.
This is important for long-term environmental protection performance for your digital
media device.
1.5. Mounting Precautions
69.8mm
214.4mm
69.8mm
214.4mm
36.6mm
210.8mm
182.2mm
188.6mm
178mm
48.8mm
52.2mm
Getting Started Media Player AQ-MP-5UBT
5www.aquaticav.com
1. Check clearances on both sides of a planned installation before drilling any holes or
installing any screws.
2. When routing RCA cables, keep them away from power cables and output speaker wires.
3. Due to the design for a multi environment application, always support the back of the unit
with the supplied back strap.
1.6 Mounting the Media Player
1.6.1 Slide mounting sleeve into DIN opening
The AQ-MP-5UBT is designed for a multi-environment application. For an easy system setup,
mount the Media Player so the front controls will be easily accessible. In addition, observe the
following precautions:
Getting Started Media Player AQ-MP-5UBT
6www.aquaticav.com
1.6.2 Slide mounting brackets into position and tighten center bolts. Remove mounting bracket
handles by bending backing brackets handles until they break off.
1.6.3 Slide Media Player into mounting sleeve. Secure Media Player using supplied hardware and
mounting strap.
Getting Started Media Player AQ-MP-5UBT
7www.aquaticav.com
The AQ-MP-5UBT requires +12V DC to both the red and yellow wires. When both of these wires
have power the AQ-MP-5UBT is always powered on. Ground is connected to the black wire.
Once all connections are made press the rotary knob and the stereo will turn ON.
In a spa application this requires the red and yellow wires to be jumped together and then con-
nected to the +12VDC output of the power source. In this set up the AQ-MP-5UBT will always be
on, with a very low current draw when idle.
In a boat, ATV or other application requiring power from a battery, the yellow wire (constant
power) should be connected to the battery, and the red wire should be connected to the ignition
or a switch.
For detailed instructions you can check out our online video:
‘How to wire your Aquatic AV stereo system’
http://www.aquaticav.com/support/videos
1.7 Power On
Getting Started Media Player AQ-MP-5UBT
8www.aquaticav.com
2.1 Media Player Controls
If your music player is connected via the Auxiliary input you will not be able to control track or receive track informa-
tion.
Turn off DSP to access control of Bass and Treble
1. Front face release
2. Preset/Search
3. Fast Rewind/Forward
4. Mode button
5. Band/2-Zone
6. LCD screen
7. Menu/Info
8. Function/XBS
9. Play/Pause/Subwoofer
10. ESC/Dimmer
11. 12V Triggers
12. Rotary Select Knob
Button AM/FM Mode Aux In Bluetooth USB
Rotary Select Knob Short Press: Mute
Long Press: Power Off
In menu: Select
Mode Short Press: Enter mode select screen
Long Press: No Function
Rotary Knob Clockwise When turned clockwise the volume increases
Rotary Knob Counter
Clockwise When turned counter clockwise the volume decreases
Fast Forward Short Press: Scans to the next station No Function Changes to next song Changes to next song
Long Press: Switches into manual seek mode No Function No Function No Function
Fast Rewind Short Press: Scans to the previous station No Function Changes to Previous Song Changes to Previous Song
Long Press: Switches into manual seek mode No Function No Function No Function
Play/Pause/Subwoofer Short Press: Toggles between Play and Pause No Function Short Press: Toggles between Play and Pause
Long Press: Displays subwoofer volume
Band/2 Zone Short Press: Switches between AM/FM Bands No Function No Function No Function
Long Press: Toggles 2 Zone selection menu
12V Trigger Short Press: Toggles 12V Trigger menu
Func/XBS Short Press: Toggles applicable functions for each mode
Long Press: Toggles XBS ON/OFF
ESC/DIM Short Press: Returns you to the previous screen
Long Press: Toggles between dimmer modes
ESC/Info Short Press: Returns you to the Default Screen
Long Press: Displays info if any available No Function No Function
Preset/Search Short Press: Displays your presets No Function Toggles Search feature* Toggles Search feature*
Long Press: Autosets presets No Function No Function No Function
Menu/Info Short Press: Toggles system menu
Long Press: Changes the information displayed on
screen
Changes the information
displayed on screen*
Changes the information
displayed on screen*
* iPod & iPhone only
6
35
42
13
7
91011 8
12
Location of Controls Media Player AQ-MP-5UBT
9www.aquaticav.com
1. Enable Bluetooth mode by pressing MODE and selecting Bluetooth.
2. Switch on your Bluetooth device.
3. Select ‘AQUATIC AV’ from the list of available devices to pair (no password is needed).
4. A Bluetooth logo will illuminate on the Media Player LCD to verify Bluetooth is activated.
3.1.1 Pair with Bluetooth Device
Only one Bluetooth device can be paired with the Media Player at any time.
3.1 Listening via Bluetooth
3.1.2 Listening via Bluetooth Device
1. Bluetooth mode will be activated once a Bluetooth device is linked.
2. Play the song from device and the sound will play through the Media Player.
3. Press PLAY/PAUSE to play/pause the song.
4. Press FAST REWIND/FORWARD buttons to play previous/next song le.
5. Previous/next track and volume up/down can be controlled directly from your Bluetooth
device or directly from the Media Player controls.
The Bluetooth menu is accessible via the in the ‘Menu/Info’ button and is used to connect or
disconnect a Bluetooth device that has already been paired.
IAP (Information Apple Protocol) Bluetooth connectivity allows device information, such as
song, playlist and album titles, to be streamed wirelessly and viewable on the AQ-MP-5UBT-
H screen. This feature is available for Apple devices only.
1. Remove the faceplate and press the lever in the lower right corner of the unit to release
the mechanism.
2. Set the iPod/iPhone in the mechanism and adjust the clamps to hold it secure.
3. Plug the iPod/iPhone cable into the USB input, and tuck the cable in so the faceplate can
be reattached.
4. Replace the faceplate. If the stereo was previously on it will come back on. If not press
the Rotary Knob to power the unit on.
5. Press the Mode button and select USB Mode.
3.2 Listening via USB
3.2.1 Listening via USB (Apple Devices)
Listening to Devices Media Player AQ-MP-5UBT
10www.aquaticav.com
Tabla de contenidos
Otros manuales de Reproductor multimedia de Aquatic
Aquatic
Aquatic AQ-DVD-3 Manual de usuario
Aquatic
Aquatic 6500-915 Manual de usuario
Aquatic
Aquatic AQ-BC-6BT-X Guía
Aquatic
Aquatic AQ-BC-6BT Guía
Aquatic
Aquatic BLUECUBE+ AQ-BC-6UBT-X Guía
Aquatic
Aquatic AQ-MP-5BT-H Manual de usuario
Aquatic
Aquatic BLUECUBE6 BC6 MINI Guía
Aquatic
Aquatic AQ-BC-5UBT Manual
Aquatic
Aquatic AQ-MP-5UBT-H Guía de solución de problemas
Aquatic
Aquatic AQ-BC-6BT Guía
