APS iBoard Manual de usuario
iBoard®
Rev. 20210301
1
PART#: IB-R048
READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION. REMOVE CONTENTS
FROM BOX AND VERIFY ALL PARTS ARE PRE-
SENT. ASSISTANCE IS RECOMMENDED.
PART LIST Front
iBoard® by APS
Fastener Size Tightening Torque (ft-lbs)
6mm 6-7
8mm 16-18
10mm 31-32
12mm 56-58
14mm 92-94
*ROCKER PANEL MOUNT
*DRILLING IS REQUIRED
Note: *(6) Support Brackets Are Universal
Driver/Passenger Front Mounting
Bracket (DFM/PFM)
Support Bracket
Driver/Passenger Center Mounting
Bracket (DCM/PCM)
Driver/Passenger Rear Mounting
Bracket (DRM/PRM)
DFS/PFS
Driver/Passenger
Front Support
Bracket (DFS/PFS)
Support Bracket
Support Bracket
Support Bracket
Support Bracket
Support Bracket
iBoard®
Rev. 20210301
2
STEP 1
M6 Nylon Lock
Nut
X16
M6 Large Flat
Washer
X16
M6X1-20mm
Square Head Bolt
X16
Start installation from the driver side of the vehicle. Locate (8)
mounting positions along the rocker panel.
Insert (4) M8 Bolt Plates into the oval holes (Use the 2nd, 4th,6th
and 8th holes), (Fig 1).
M8 Flat Washer
X24
(Fig 1) Insert the M8 Bolt Plate
(Use the 2nd, 4th,6th, 8th holes)
M8 Bolt Plate
STEP 2
Assemble Driver Front Mounting Bracket (DFM/PFM) and the
Driver Front Support Bracket (DFS/PFS) with (1) M8X1.25-
20mm Hex Bolt, (2) M8 Flat Washers and (1) M8 Hex Flange
Nut. Don’t fully tighten at this time, (Fig 2).
Attach the assembled Driver Front Mounting Bracket onto the
rocker panel. According to the position of Driver Front Support
Bracket (DFS/PFS), mark and drill 2 holes on the pinch weld,
(Fig 3).
(Fig 2) Driver Side Front Mounting Bracket Assembly
(1) M8X1.25-20mm Hex Bolt
(2) M8 Flat Washers
(1) M8 Hex Flange Nut
DFM/PFM
DFS/PFS
Front
(Fig 3) Mark And Drill 2 Holes on The Pinch Weld
Mark and Drill 2 Holes
Pinch Weld
Rocker Panel
DFS/PFS
M8X30 Bolt Plate
X8
M8X1.25-20mm Hex Bolt
X24
M8 Hex
Flange Nut
X32
iBoard®
Rev. 20210301
3
STEP 3
STEP 4
Move to the driver side 4th & 6th & 8th of the vehicle. Repeat
Steps 1-3 for (2) Driver Center Mounting Brackets (DCM/PCM),
(1) Driver Rear Mounting Bracket (DRM/PRM) and (3) Support
Brackets assembly and installation. Do not fully tighten at this
time.
Note: (6) Support Brackets are universal.
Install the assembled Driver Front Mounting Bracket on the
rocker panel and pinch weld with (1) M8 Bolt Plate, (2)
M8X1.25-20mm Hex Bolts, (5) M8 Flat Washers, (3) M8 Hex
Flange Nuts, (Fig 4). Do not fully tighten at this time.
(Fig 4) Driver Side Front Mounting Bracket Installed
DFM/PFM
DFS/PFS
Front
(1) M8 Bolt Plate
(1) M8 Flat Washer
(1) M8 Hex Flange Nut
STEP 5
Select a Running Board. Slip (4) M6x1-20mm Square Head
Bolts into each bottom channel (Fig 5). Carefully position the
Running Board onto the (4) Mounting Brackets.
IMPORTANT: Do not slide the Running Board on the Brackets
or the bottom surface of the board will be damaged. Attach the
Running Board to each Mounting Bracket with (2) M6x1-20mm
Square Head Bolts, (2) M6 Large Flat Washers and (2) M6 Ny-
lon Lock Nuts (Fig 6). Do not fully tighten at this time.
(Fig 5) Slip M6X1-20mm Square Head Bolts Into The Bottom
Channels
M6X1-20mm Square Head Bolts
(Fig 6) Running Board Installed Onto Mounting Bracket
(2) M6X1-20mm Square Head Bolts
(2) M6 Large Flat Washers
(2) M6 Nylon Lock Nuts
(2) M8X1.25-20 Hex Bolts
(4) M8 Flat Washers
(2) M8 Hex Flange Nuts
iBoard®
Rev. 20210301
4
STEP 7
Repeat Steps 1-4 for the other side Running Board installation.
The installation is completed.
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use only
mild soap/non-abrasive products for cleaning.
STEP 6
Level and adjust the Running Board and fully tighten all hard-
ware.
Important: Please follow the recommended Tightening Tor-
ques shown in the table on page 1. Don’t over tighten, or
the nuts/bolts will be damaged.
Este manual sirve para los siguientes modelos
2
Otros manuales de Accesorios para automóviles de APS
APS
APS iBoard IB-R911 Manual de usuario
APS
APS iArmor Manual de usuario
APS
APS iBoard IB-R922 Manual de usuario
APS
APS iBoard IB-R004 Manual de usuario
APS
APS iBoard IB-R009 Manual de usuario
APS
APS IA20SJI8B Manual de usuario
APS
APS iBoard IB-R921 Manual de usuario
APS
APS IA06SAG5B Manual de usuario
APS
APS iBoard IB-R046 Manual de usuario
APS
APS iBoard IB-R094 Manual de usuario
APS
APS iBoard IB-R062 Manual de usuario
APS
APS iArmor IA-S926 Manual de usuario
APS
APS IA06SJD4B Manual de usuario
APS
APS iBoard IB-R001 Manual de usuario
APS
APS IA06SJA1B Manual de usuario
APS
APS iBoard IB-R934 Manual de usuario
APS
APS IA06SIB6B Manual de usuario
APS
APS iBoard IB-R054 Manual de usuario
APS
APS iBoard IB-R296 Manual de usuario
APS
APS iBoard IB-R905 Manual de usuario
