Anvil HDR1011 Manual del propietario

www.anvilworld.com

HOT DOG ROLLER

ALL ANVIL EQUIPMENT COMES WITH A

ONE YEAR WARRANTY ON COMPONENTS

AND DEFECTIVE WORKMANSHIP.

www.anvilworld.com

NB:

NO WEB ACCESS

If you do not have access to the Web. Kindly register by completing

the warranty registration form and fax it to the ANVIL ofce in the

country of purchase.

Failure to do so will invalidate your warranty.

HOT DOG ROLLER

INSTALLATION OPERATION AND CARE OF

HOT DOG ROLLER

MODEL: HDR1011

4-INS-HDR1011

LIMITED WARRANTY

All equipment which is sold under ANVIL trademark and used for

commercial purposes is warranted against defects in materials and

workmanship. The warranty runs for one year from the date of

original installation and is for the benet of the original purchaser

only. All other Warranties ,expressed or implied , statutory or

otherwise, including without limitations any implied Warranty of

Merchantability or tness for purpose are excluded .The Seller shall

in no event be liable for direct,indirect or consequential damages in

connection with ANVIL commercial products.

The Sellers obligation under this Warranty is limited to the

repair of defects without charge. Defective units must be taken or

shipped,transportation charges prepaid,to ANVIL.

This Warranty is not effective if damage occurs because of

accident,carelessness,improper installation,lack of proper

set-up,supervision when required or if the equipment is installed or

operated in any manner contrary to the installation and

operating instructions. In these cases,repairs will be made at a

reasonable cost. Work performed by unauthorized personnel or

unauthorized service agencies using non Anvil spares voids this

Warranty.

Anvil hot dog rollers are medium duty electrical appliances capable

of grilling a variety of sausages. Temperature of the roller can be

controlled using the heat control switch on the front panel. The lamp

on the front panel indicates when the elements are on. The main

switch operates both the motor and allows the elements to be

energized.

1. Install the unit in the most convenient location for ease of

cleaning, maintenance and general operation. If the unit is to

be positioned in close proximity to a wall, partitions, kitchen

furniture, decorative nishes, etc. it is recommended that they

be made of a non-combustible material. If not, they shall be

clad with a suitable non-combustible heat insulating material,

and the closest attention be paid to re prevention regulations.

2 The unit must be placed in a level position for perfect

operation.

IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING

VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF

THE OF THE UNIT AS FOUND ON THE SERIAL PLATE.

THE SERIAL PLATE IS LOCATED AT THE REAR OF THE

UNIT ADJACENT TO THE INCOMING CABLE ENTRY.

THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO

GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR

PROTECTING AGAINST LOSS FROM CONCEALED

DAMAGE. THE FORM FOR FILING SUCH A CLAIM WILL BE

PROVIDED BY THE CARRIER.

UNPACKING

Unpack the product and check for any damage incurred

during transit. This should be reported to the responsible

carrier, railway or postal authority, and a request for a

damage report should be made.

GENERAL INSTALLATION AND OPERATION INSTRUCTIONS

3. The ends of the rollers should be coated with a small amount of

edible vegetable oil for lubrication and to ensure steady rolling.

4. The temperature of the rollers can be adjusted using the control

knob . The model HDR1011 has dual controls enabling use of

only the front 5 or rear 6 rollers respectively on one control or

all rollers if both controls are used.

5. The unit is provided with a removable drip tray for easy cleaning

beneath the rollers.

6. Only trained operators should operate these appliances.

580

170

480

POSITIONING DIAGRAM

HOT DOG ROLLER

MODEL: HDR1011

CLEANING

1. Always ensure that the unit is disconnected from the mains

power supply before cleaning

2. This hot dog roller should not be cleaned with a water jet or

immersed in water.

3. Using a moist cloth wipe each tube. Wipe the tubes from each

end to the centre. This will keep as much of the loosened par-

ticles out of the bearings as possible. Extend the cloth as far as

possible between the rollers.

4. With the rollers wiped with a moist cloth to loosen the particles,

now ,wipe clean with another cloth. Continue to wipe from the

end of the rollers to the centre. This will reduce the grease and

particles getting into the bearings and drive mechanism which

will extend the life of the unit and extend the period between

routine maintenance of the drive mechanism

4. Wipe off the unit with a dry cloth and wait at least half an hour

before re – connecting to the mains outlet.

5. Remove the drip pan and wash in hot,soapy water, then rinse

6. If stains are still present, add a light detergent to the cloth and

repeat.

WARNING

Burn Hazard.

Do not touch hot food,liquid or heating surfaces

while equipment is heating or operating

Hot surfaces and food can burn skin. Allow the hot surfaces to cool

before handling

THIS APPLIANCE SHOULD NOT BE CLEANED WITH

A WATER JET OR IMMERSED IN WATER. USE ONLY

A DAMP CLOTH OR SPONGE DIPPED IN SOAPY

WATER. DO NOT USE STEEL-WOOL WHICH WILL

MARK THE BRIGHT STAINLESS STEEL FINISH

NEVER USE ABRASIVE POWDERS OR PADS,THESE

CLEANERS MAY DAMAGE THE ROLLER FINISH.

ALSO,THE PARTICLES MAY GET INTO THE DRIVE

MECHANISM SHORTENING THE UNIT LIFE

EXPLODED DIAGRAM LEGEND

HOT DOG ROLLER

MODEL: HDR1011

Drawing

No.

01 TAPPING SCREW

02 RUBBER FOOT

03 BOTTOM PLATE

04 RIGHT SIDE PLATE

05 LEFT AND RIGHT FRAME

06 SILICONE PAD

07 HEATING ELEMENT FIXED PLATE

08 LEFT AND RIGHT ROLLER FIXED PLATE

09 BUSH FOR ROLLER

10 RIGHT INSIDE PLATE

11 GROUND WIRE SCREW

12 FUSE

13 ELECTRIC CABLE

14 RUBBER GASKET

15 OIL TRAY

16 ROLLER

17 HEATING PIPE

18 LEFT SIDE PLATE

19 FIBRE WASHERS

20 INSULATION PAD

21 CHAIN

22 WHEEL GEAR

23 MOTOR

24 GROMMET

25 BADGE

26 SWITCH

27 TEMPERATURE CONTROLLER WITH KNOB

28 INDICTOR LIGHT

29 FASCIA PANEL

MODEL:11 ROLLER HOT DOG MACHNE

MODEL CODE : HDR1011

Description

SAFETY

1. When this hot dog roller is to be positioned in close proximity

to a wall, partitions, kitchen furniture, decorative nishes, etc.

it is recommended that they be made of non-combustible mate-

rial. If not, they shall be clad with a suitable non-combustible

heat insulating material, and the closest attention be paid to re

prevention regulations.

2. The appliances are designed to operate on alternating current

only (A.C).DO NOT CONNECT TO DIRECT CURRENT (D.C)

3. Ensure that the equipment and the power supply cord does not

come into contact with hot surfaces.

4. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance

by a person responsible for their safety. Children should be su-

pervised to ensure that they do not play with the appliance.

5. If the supply cord is damaged, it must be replaced with a new

cord assembly available from the suppliers agent.

6. Use only earthed outlets matching the serial plate voltage.

7. Have equipment installed by a qualied personnel in accordance

with local codes and ordinances.

WARNING

Electric Shock Hazard.

Keep water and other liquids from entering the inside

of the equipment. Liquid inside the equipment could

cause an electrical shock

Do not spray water or cleaning products. Liquid could contact the

electrical components and cause a short circuit or an electrical shock.

Do not use equipment if power cord is damaged or has been modied

READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO

FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO

YOURSELF AND OTHERS

EXPLODED DIAGRAM

HOT DOG ROLLER

MODEL: HDR1011

LEGEND DESCRIPTION PART NUMBER

T1 / T2 THERMOSTAT ET-11ROLLER-27

R ELEMENT 200W/230V ET-11ROLLER-17

D1/D2 CONTROL PILOT LIGHT ET-11ROLLER-28

K1 MAIN SWITCH ET-11ROLLER-26

MMOTOR ET-11ROLLER-23

WIRING DIAGRAM

HOT DOG ROLLER

MODEL CODE: HDR0011 R01

MODEL DESCRIPTION VOLTS

(V /Hz)

POWER

(W)

RPM

ROLLERS

HDR0011 HOT DOG ROLLER

11 ROLLERS

230/50 2200 7

ELECTRICAL CONNECTION INFORMATION

IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING

VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF

THE OF THE UNIT AS FOUND ON THE SERIAL PLATE.

THE SERIAL PLATE IS LOCATED AT THE REAR OF THE

UNIT ADJACENT TO THE INCOMING CABLE ENTRY.

230V

Tabla de contenidos

Otros manuales de Electrodoméstico de cocina de Anvil

Anvil

Anvil SLR7612 Manual de usuario

Anvil

Anvil VMA7200 Manual de usuario

Anvil

Anvil TSA8318 Manual de usuario

Anvil

Anvil SLR 7512 Manual de usuario

Anvil

Anvil Argenta SLR7009 Manual de usuario

Anvil

Anvil SLM0012 Manual de usuario

Anvil

Anvil POA1001 R02 Instrucciones de funcionamiento originales

Anvil

Anvil SLR7912 Manual de usuario

Anvil

Anvil TSI7001 Manual de usuario

Anvil

Anvil SLR7014 Manual de usuario

Anvil

Anvil TSA7012 Manual de usuario

Anvil

Anvil SLR7512 Manual de usuario

Anvil

Anvil TSA7209 Manual de usuario

Anvil

Anvil Argenta SLR7010 Manual de usuario

Anvil

Anvil SLR7014 Manual de usuario

Anvil

Anvil TSA7309 Manual de usuario

Anvil

Anvil SLR7712 Manual de usuario

Anvil

Anvil TSA7012 Manual de usuario

Anvil

Anvil SLR7612 Guía de inicio rápido

Anvil

Anvil SLR7412 Manual de usuario

Anvil

Anvil Argenta SLR7009 Manual de usuario

Anvil

Anvil SLR7012 Manual de usuario

Anvil

Anvil VMA7012 Manual de usuario

Anvil

Anvil SAA8003 Instrucciones de funcionamiento

Manuales populares de Electrodoméstico de cocina de otras marcas

Tayama

Tayama TYG-35AF Manual de usuario

AEG

AEG 43172V-MN Manual de usuario

REBER

REBER Professional 40 Guía del usuario

North American

North American BB12482G / TR-F-04-B-NCT-1 Manual de usuario

Presto

Presto fountain popper Manual de usuario

Westmark

Westmark 1035 2260 Manual de usuario

Zanussi

Zanussi ZCG64396XA Manual de usuario

HOFFEN

HOFFEN SM-9302M Manual de usuario

Philips

Philips HD3133 Manual de usuario

Ronco

Ronco Beef Jerky Manual de usuario

Hendi

Hendi 470411 Manual de usuario

Livoo

Livoo MEN386 Manual de usuario

Vogue

Vogue D446 Manual de usuario

croydon

croydon WR-10313-700 Manual de usuario

ADE

ADE AUTOMATIC-L Manual de usuario

Chefman

Chefman RJ43-SQ Series Manual de usuario

Vacmaster

Vacmaster VP680 Manual de usuario

Jetmaster

Jetmaster 900HG Manual de usuario