Anest Iwata SLBE-2 Manual de usuario

INSTRUCTION MANUAL

OIL-FREE SCROLL BASE MOUNT

ENCLOSURE AIR COMPRESSOR

SLBE-2/3/5

SLBE-2H/3H/5H

Thank you for purchasing our oil-free scroll air compressor.

●Before operation, be sure to read this instruction manual thoroughly for safe

and efficient use for a long operating lifetime.

●After reading it, store in a convenient place for immediate and future

reading.

Before use, be sure to fill in the blank spaces below for future repair and after service.

MODEL

SERIAL No.

Purchased from

Date of purchase

Date of use

Important information-Safety precautions

▪Important information

Be sure to read and understand this instruction manual.

The operator shall be fully conversant with the requirements stated within this instruction manual including important

warnings, cautions and operation.

The marks and symbols have the following meanings.

•Indications of warnings and cautions

WARNING

Indicates a potentially hazardous situation which, if not avoided, will result in

serious injury or loss of life.

CAUTION

Indicates a potentially hazardous situation which, if not avoided, may result

in minor or moderate injury or property damage.

•Examples of warnings and cautions

Indicates「You must be careful」. We will explain briefly in or near the symbol.

（The example on the left is [Be careful about electric shock]）

Indicates「You must not do」. We will explain briefly in or near the symbol.

（The example on the left is [Do not touch]）.

Indicates 「You must do」. We will explain briefly in or near the symbol.

（The example on the left is [Be sure to ground it]）.

＊We shall not be responsible for any injury or damage caused by disregard of warnings, cautions or instruction.

Keep this booklet in an appropriate place for immediate reference.

Important information - Safety precautions

▪Safety precautions

WARNING

Install in a safe area.

Install in an area which is free of volatile, flammable gases or organic solvents.

They can cause explosion or fire.

Never install outdoors.

Do not install outdoors (This compressor is not water-proof)

If water splashes on electric equipment, it can cause electric shock or fire.

Turn off main electric source.

Be sure to turn off main electric source before inspection or wiring job.

If not, it can cause electric shock or serious bodily injury.

Ask qualified electrician.

Ask qualified electrician to perform electric wiring job.

If not, it can cause electric shock or fire.

Be sure to ground.

Be sure to do the grounding job.

If not, it can cause electric shock or fire.

Never use to compress other than air.

If done, it can cause explosion, fire or damage.

Never use with respiratory equipment which

directly intake compressed air.

If done, it can cause serious bodily injury.

Important information - Safety precautions

WARNING

Never use with equipment which is directly

concerned with human life.

If done, it can cause serious bodily injury.

Never touch

Never touch turning section (fan, pulley and belts) while main electric source is turned on.

If done, it can cause serious injury including entanglement of fingers or hands.

Release pressure

Be sure to release pressure from air receiver and make sure there is no pressure inside before

conducting any maintenance and inspection.

If not, parts can scatter and can cause serious injury.

Conduct maintenance and inspection

Conduct maintenance and inspection according to maintenance standards.

If not, it can cause fire and failure.

Important information - Safety precautions

CAUTION

Use at ambient temperature of 36 degree F to 104

degree F (during operation)

Drain will freeze at less than 36 degree F and cause failure.

More than 104 degree F will cause shorter lifetime or damage.

Use at an area which is free of dirt or dust.

If done, it can cause failure.

Use at an area which is free of corrosive gas.

If done, it can cause failure.

Ask specialist to perform repairs.

If not, it can cause failure and shorter lifetime.

Never touch.

Never touch each section of compressor during operation or soon after operation.

If done, it can cause burns.

Never alter the compressor.

If done, it can cause damage or shorter lifetime.

Use genuine parts.

Be sure to use our genuine parts when replacing parts during maintenance.

If not, it can cause failure or shorter lifetime.

Contents

Important information-Safety precautions

Appendix

▪Important information ------------------------------1

▪Outer dimensions -------------------------------------------18

▪Safety precautions------------------------------------2

▪Circuit diagram -----------------------------------------------19

Contents

Warranty

▪Contents ------------------------------------------------5

▪Warranty and remedies -----------------------------------22

Before use

▪Check the product -----------------------------------6

Installation

▪Precaution about installation ------------------------7

▪Piping ----------------------------------------------------8

▪Electrical wiring ---------------------------------------9

Operation

▪Before start up ----------------------------------------11

▪Start-up and operation -----------------------------11

Maintenance and inspection

▪Maintenance standards --------------------------------13

▪How to carry out maintenance ----------------------15

Troubleshooting guide

▪Compressor ------------------------------------------------16

Specifications

▪Compressor specifications -----------------------------17

Before use

▪Inspect the product

•Check that model name of the product is as you ordered.

Model name description;

•Check that there is no deformity or damage which occurred during shipment. Any shipping damage must be

immediately filed with the freight carrier.

•Check that the following accessories are included.

oCompressor instruction manual

oScroll pump instruction manual

SL; Scroll 2; 2HP 208; 208V

3; 3HP 230; 230V

BE; Base mount 5; 5HP 460; 460V

Enclosure

S; Single phase

T; Three phase

N/A;

115psi (Maximum pressure)

145psi (Maximum pressure)

230

Installation

▪Precautions about installation

WARNING

Do not use in an area which is exposed to rain, steam or high humidity.

High Humidity can cause electric shock or fire.

Do not install in an area with corrosive gas (ammonia, acid, salinity, ozone gas and sulfur dioxide).

If done, it can cause shorter lifetime.

湿度が高と感電・発火の原因になります。

WARNING

Install in an area which is free of explosive, flammable gases or organic solvents.

If done, it can cause explosion and fire.

Ambient temperature

Use at ambient temperature of 36 degree F to 104 degree F.

Less than 36 degree F will cause failure or freezing.

４０℃ よび年平均 30℃以上では故障の原因になります。

CAUTION

Install this product on a flat floor.

If not, it may cause vibration and noise and shorten life.

CAUTION

Install in an area which is free of dust.

Dust can cause increase temperature and wear, resulting in shorter lifetime and failure.

Installation

•Installation space

Secure the space around compressor for safe, inspection and maintenance.

Installation space

(inch)

Above

24 inches

Each Side

20 inches

•Ventilation

When using in totally closed room, install fan for ventilation.

Model

British Thermal Unit

BTU

SLBE-2**

5160

SLBE-3*

7570

SLBE-5*

12730

▪Piping

•Do not use any steel pipe and a smaller size than the compressor outlet connection.

•If the compressor stops and starts frequently, we recommend you to install air receiver. (option)

•When there is any riser piping, be sure to install drain collector or drain valve.

WARNING

Be sure to install the check valve on the downstream piping from the compressor outlet.

If not, it can cause serious failure.

WARNING

Be sure to install the safety valve on the downstream piping from the compressor outlet.

The pressure setting of the safety valve must be no higher than the maximum working pressure of

the tank and maximum designed pressure of the compressor.

If not, it can cause serious failure.

Installation

▪Electrical wiring

•Precautions about wiring

Turn off main electric source.

Be sure to turn off main electric source before inspection or wiring job.

If not, it can cause electric shock or serious bodily injury.

Ask qualified electrician.

Ask qualified electrician to perform electric wiring job.

If not, it can cause electric shock or fire.

Be careful about wiring.

Do not use cable of less than designated size.

If done, overheat of cable can cause fire.

Be sure to ground.

Be sure to do the grounding job.

If not, it can cause electric shock or fire.

•Wiring

Be sure to use the ring terminal to firmly connect the electric source to the designated place of the motor

terminal box. Please refer to the rating plate on the motor.

o115V/208V-230V, 1PH, 60Hz

Motor

Size

Power

Motor

Load

Non-time

Delay Fuse

Time Delay

Fuse

Inverse-time

circuit breaker

V/PH

FLA

115V/1PH

208V/1PH

13.2

230V/1PH

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Compresor de aire de Anest Iwata

Anest Iwata

Anest Iwata SL-205-US Manual de usuario

Anest Iwata

Anest Iwata SLE-2 Manual de usuario

Anest Iwata

Anest Iwata SLE-10 SLE-15 Manual de usuario

Anest Iwata

Anest Iwata SLT-2D Manual de usuario

Anest Iwata

Anest Iwata OFB-1 Manual de usuario

Anest Iwata

Anest Iwata SLB-7.5 Manual de usuario

Anest Iwata

Anest Iwata SLE-30 Manual de usuario

Anest Iwata

Anest Iwata SL-140EB-US Manual de usuario

Anest Iwata

Anest Iwata OFT-1 Manual de usuario

Anest Iwata

Anest Iwata Iwata SILVER JET IS 50 Manual de instrucciones

Anest Iwata

Anest Iwata IS875HT Manual de usuario

Anest Iwata

Anest Iwata iwata SMART JET PLUS Manual de instrucciones

Anest Iwata

Anest Iwata SLT-7.5 Manual de usuario

Anest Iwata

Anest Iwata SLBE-7.5 Manual de usuario

Anest Iwata

Anest Iwata SLB-2 Manual de usuario

Anest Iwata

Anest Iwata EPM Series Manual de usuario

Anest Iwata

Anest Iwata SLTE-7.5 Manual de usuario

Anest Iwata

Anest Iwata IS-975MB Manual de usuario

Manuales populares de Compresor de aire de otras marcas

Sparmax

Sparmax DC-25XR Manual de usuario

KAESER

KAESER M122 Manual de usuario

GMC

GMC GAC1500 Manual de usuario

Briggs & Stratton

Briggs & Stratton Air Compressor Manual de usuario

Fini

Fini F3GST2TK Manual de usuario

Industrial Air

Industrial Air CP1580325 Manual de programación

Campbell Hausfeld

Campbell Hausfeld RP3300 Guía de inicio rápido

Ingersoll-Rand

Ingersoll-Rand UP6 20 HP Manual de usuario

Hitachi

Hitachi EC99S Manual del operador

Parkside

Parkside PKO 270 A1 Manual de usuario

Sullair

Sullair 185 Manual de usuario

Clas Ohlson

Clas Ohlson QIE-ZTH-15 Manual de usuario

Ferm

Ferm CRM1046 Manual de usuario

BE AC153 Manual de usuario

RIDGID

RIDGID OF25150A Manual de usuario

Johnson Controls

Johnson Controls QUANTUM LX Manual

Sears

Sears Craftsman 919.167463 Manual de usuario

Ring Automotive

Ring Automotive RAC700 Manual de usuario