Analog Devices ADSP-BF526 EZ-Board Manual de usuario

ADSP-BF526 EZ-Board®

Evaluation System Manual

Revision 1.2, July 2012

Part Number

82-000208-01

Analog Devices, Inc.

One Technology Way

Norwood, Mass. 02062-9106

ment may not be reproduced in any form without prior, express written

consent from Analog Devices, Inc.

Printed in the USA.

Disclaimer

Analog Devices, Inc. reserves the right to change this product without

prior notice. Information furnished by Analog Devices is believed to be

accurate and reliable. However, no responsibility is assumed by Analog

Devices for its use; nor for any infringement of patents or other rights of

third parties which may result from its use. No license is granted by impli-

cation or otherwise under the patent rights of Analog Devices, Inc.

Trademark and Service Mark Notice

The Analog Devices logo, Blackfin, CrossCore, EngineerZone, EZ-Board,

EZ-Extender, Lockbox, and VisualDSP++ are registered trademarks of

Analog Devices, Inc.

All other brand and product names are trademarks or service marks of

their respective owners.

Regulatory Compliance

The ADSP-BF526 EZ-Board is designed to be used solely in a laboratory

environment. The board is not intended for use as a consumer end prod-

uct or as a portion of a consumer end product. The board is an open

system design which does not include a shielded enclosure and therefore

may cause interference to other electrical devices in close proximity. This

board should not be used in or near any medical equipment or RF devices.

The ADSP-BF526 EZ-Board has been certified to comply with the essen-

tial requirements of the European EMC directive 2004/108/EC and

therefore carries the “CE” mark.

The ADSP-BF526 EZ-Board has been appended to Analog Devices, Inc.

EMC Technical File (EMC TF) referenced DSPTOOLS1, issue 2 dated

June 4, 2008 and was declared CE compliant by an appointed Notified

Body (No.0673) as listed below.

Notified Body Statement of Compliance: Z600ANA2.030 dated June 4,

2008.

Issued by: Technology International (Europe) Limited

60 Shrivenham Hundred Business Park

Shrivenham, Swindon, SN6 8TY, UK

The EZ-Board evaluation system contains ESD (electrostatic discharge) sen-

sitive devices. Electrostatic charges readily accumulate on the human body

and equipment and can discharge without detection. Permanent damage may

occur on devices subjected to high-energy discharges. Proper ESD precau-

tions are recommended to avoid performance degradation or loss of func-

tionality. Store unused EZ-Boards in the protective shipping package.

ADSP-BF526 EZ-Board Evaluation System Manual v

CONTENTS

PREFACE

Product Overview ......................................................................... xiii

Purpose of This Manual ................................................................. xvi

Intended Audience ......................................................................... xvi

Manual Contents .......................................................................... xvii

What’s New in This Manual .......................................................... xvii

Technical Support ........................................................................ xviii

Supported Processors ...................................................................... xix

Product Information ...................................................................... xix

Analog Devices Web Site .......................................................... xix

EngineerZone ............................................................................ xx

Related Documents .................................................................. xxi

Notation Conventions .................................................................... xxi

Contents

vi ADSP-BF526 EZ-Board Evaluation System Manual

USING THE ADSP-BF526 EZ-BOARD

Package Contents ......................................................................... 1-3

Default Configuration .................................................................. 1-3

CCES Install and Session Startup .................................................. 1-5

Session Startup ........................................................................ 1-6

VisualDSP++ Install and Session Startup ....................................... 1-9

Session Startup ...................................................................... 1-10

CCES Evaluation License ........................................................... 1-12

VisualDSP++ Evaluation License ................................................. 1-13

Lockbox Key Security Features .................................................... 1-13

Memory Map ............................................................................. 1-14

SDRAM Interface ....................................................................... 1-16

Parallel Flash Memory Interface .................................................. 1-17

NAND Flash Interface ................................................................ 1-18

SPI Interface .............................................................................. 1-19

Parallel Peripheral Interface (PPI) ................................................ 1-20

Rotary Encoder Interface ............................................................ 1-20

Ethernet Interface ....................................................................... 1-21

Audio Interface ........................................................................... 1-22

USB OTG Interface .................................................................... 1-23

UART Interface .......................................................................... 1-24

ADSP-BF526 EZ-Board Evaluation System Manual vii

Contents

RTC Interface ............................................................................. 1-26

LEDs and Push Buttons .............................................................. 1-26

JTAG Interface ........................................................................... 1-28

Land Grid Array ......................................................................... 1-29

Expansion Interface II ................................................................. 1-29

Power Architecture ...................................................................... 1-30

Power Setup ................................................................................ 1-33

Power Saving Features ................................................................. 1-35

Power Measurements ................................................................... 1-36

Power-On-Self Test ..................................................................... 1-37

Board Design Database ............................................................... 1-37

Example Programs ...................................................................... 1-37

ADSP-BF526 EZ-BOARD HARDWARE REFERENCE

System Architecture ...................................................................... 2-2

Programmable Flags ...................................................................... 2-3

Push Button and Switch Settings ................................................... 2-9

Boot Mode Select Switch (SW1) ............................................ 2-10

SPORT0A ENBL Switches/I2C ENBL (SW2 and SW7) ........ 2-11

Gauge Signals Switch (SW4) .................................................. 2-11

Rotary Encoder with Momentary Switch (SW5) ..................... 2-11

Flash Enable Switch (SW6) .................................................... 2-12

MIC Gain Switch (SW9) ....................................................... 2-12

Contents

viii ADSP-BF526 EZ-Board Evaluation System Manual

Audio LPBK (Loopback) Switch (SW10) ............................... 2-13

ETH Mode/Flash CS Switch (SW11) .................................... 2-13

ETH Enable Switch (SW12) ................................................. 2-14

Rotary/NAND Enable Switch (SW13) .................................. 2-14

UART Setup Switch (SW14) ................................................. 2-15

Programmable Flag Push Buttons (SW15 and SW19) ............. 2-15

Power-Down and Wake Push Buttons (SW16–17) ................. 2-15

Reset Push Button (SW18) .................................................... 2-16

GPIO Enable Switch (SW20) ................................................ 2-16

SPORT1 Enable (SW21) ....................................................... 2-18

Battery Switch (SW22) .......................................................... 2-18

Jumpers ...................................................................................... 2-19

UART Loopback Jumper (JP2) .............................................. 2-20

UART Enable Jumper (JP3) .................................................. 2-20

LED Enable Jumper (JP5) ..................................................... 2-20

MIC Select Jumper (JP6) ...................................................... 2-21

CFG WP Jumper (JP7) ......................................................... 2-21

EXP 5V Select Jumper (JP8) ................................................. 2-21

VR7 Enable Jumper (JP9) ..................................................... 2-21

SENSE2 Select Jumper (JP10) ............................................... 2-22

RST/ETH LED Jumper (JP11) ............................................. 2-22

UART SD Jumper (JP14) ...................................................... 2-23

CHG GPIO Jumper (JP15) ................................................... 2-23

OTP Flag Enable Jumper (JP16) ........................................... 2-23

ADSP-BF526 EZ-Board Evaluation System Manual ix

Contents

CHG Control Jumper (JP17) ................................................ 2-24

VDDEXT Power Jumper (P11) .............................................. 2-25

VDDMEM Power Jumper (P12) ............................................ 2-25

VDDINT Power Jumper (P13) .............................................. 2-25

ETH PWR Jumpers (P21–22) ............................................... 2-25

R274 JMP Jumper (P23) ....................................................... 2-26

BATT Installed Jumper (P25) ................................................ 2-26

LEDs .......................................................................................... 2-27

Ethernet LEDs (LED1–2) ...................................................... 2-28

GPIO LEDs (LED3–5) ......................................................... 2-28

Reset LED (LED7) ................................................................ 2-28

Batt GD LED (LED8) ........................................................... 2-28

Batt Low LED (LED9) .......................................................... 2-29

Charging LED (LED10) ........................................................ 2-29

Connectors ................................................................................. 2-30

Expansion Interface II Connector (J1) ................................... 2-31

RS-232 Connector (J2) .......................................................... 2-31

Dual Audio Connectors (J3–4) .............................................. 2-31

Ethernet Connector (J5) ........................................................ 2-32

Battery Holder (J6) ............................................................... 2-32

JTAG Connector (P1) ........................................................... 2-32

Expansion Interface II Connectors (P2 and P4) ...................... 2-33

Expansion Interface II Connector (P3) ................................... 2-33

DMAX Land Grid Array Connectors (P5–7) .......................... 2-33

Contents

x ADSP-BF526 EZ-Board Evaluation System Manual

USB OTG Connector (P8) .................................................... 2-34

Host Interface Connector (P9) .............................................. 2-34

Power Connector (P14) ......................................................... 2-35

Battery Connector (P24) ....................................................... 2-35

Standalone Debug Agent Connector (ZP1) ............................ 2-35

ADSP-BF526 EZ-BOARD BILL OF MATERIALS

ADSP-BF526 EZ-BOARD SCHEMATIC

INDEX

Tabla de contenidos

Otros manuales de Placa madre de Analog Devices

Analog Devices

Analog Devices DC3164A-B Guía de configuración rápida

Analog Devices

Analog Devices EV1HMC6832ALP5L Manual de usuario

Analog Devices

Analog Devices EVAL-AD5680DBZ Manual de usuario

Analog Devices

Analog Devices MAX16165 Manual de usuario

Analog Devices

Analog Devices AD9161 Manual de usuario

Analog Devices

Analog Devices iMEMS ADXL345 Manual de usuario

Analog Devices

Analog Devices EVAL-ADIN1100EBZ Manual de usuario

Analog Devices

Analog Devices EVAL-AD7450A Manual de usuario

Analog Devices

Analog Devices ADV7281-M Manual de usuario

Analog Devices

Analog Devices EVAL-ADIN1300FMCZ Manual de usuario

Analog Devices

Analog Devices EVAL-ADF4150EB1Z Manual de usuario

Analog Devices

Analog Devices EVAL-ADAU1701MINIZ Manual de usuario

Analog Devices

Analog Devices EV-ADF4106SD1Z Manual de usuario

Analog Devices

Analog Devices EVAL-AD5344DBZ Manual de usuario

Analog Devices

Analog Devices EZ-KIT Lite ADSP-BF506F Manual de usuario

Analog Devices

Analog Devices ADZS-U4050LF-EZKIT Manual de usuario

Analog Devices

Analog Devices EVAL-ADV7282MEBZ Manual de usuario

Analog Devices

Analog Devices ADuC7024 Manual de usuario

Analog Devices

Analog Devices EVAL-SSM3302Z Manual de usuario

Analog Devices

Analog Devices SSM2167 Instrucciones de instalación y funcionamiento

Analog Devices

Analog Devices ADP5034 Manual de usuario

Analog Devices

Analog Devices Lite ADSP-21371 EZ-KIT Guía del usuario

Analog Devices

Analog Devices MAX77857Q Manual de usuario

Analog Devices

Analog Devices AD5282 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario