Analog Devices ADSP-21369 EZ-KIT Lite Manual de usuario

ADSP-21369 EZ-KIT Lite®

Evaluation System Manual

Revision 2.4, July 2012

Part Number

82-000196-01

Analog Devices, Inc.

One Technology Way

Norwood, Mass. 02062-9106

ment may not be reproduced in any form without prior, express written

consent from Analog Devices, Inc.

Printed in the USA.

Disclaimer

Analog Devices, Inc. reserves the right to change this product without

prior notice. Information furnished by Analog Devices is believed to be

accurate and reliable. However, no responsibility is assumed by Analog

Devices for its use; nor for any infringement of patents or other rights of

third parties which may result from its use. No license is granted by impli-

cation or otherwise under the patent rights of Analog Devices, Inc.

Trademark and Service Mark Notice

The Analog Devices logo, CrossCore, EngineerZone, EZ-Extender,

EZ-KIT Lite, SHARC, and VisualDSP++ are registered trademarks of

Analog Devices, Inc.

All other brand and product names are trademarks or service marks of

their respective owners.

Regulatory Compliance

The ADSP-21369 EZ-KIT Lite is designed to be used solely in a labora-

tory environment. The board is not intended for use as a consumer end

product or as a portion of a consumer end product. The board is an open

system design which does not include a shielded enclosure and therefore

may cause interference to other electrical devices in close proximity. This

board should not be used in or near any medical equipment or RF devices.

The ADSP-21369 EZ-KIT Lite has been certified to comply with the

essential requirements of the European EMC directive 2004/108/EC and

therefore carries the “CE” mark.

The ADSP-21369 EZ-KIT Lite has been appended to Analog Devices,

Inc. EMC Technical File (EMC TF) referenced DSPTOOLS1, issue 2

dated June 4, 2008 and was declared CE compliant by an appointed

Notified Body (No.0673) as listed below.

Notified Body Statement of Compliance: Z600ANA1.025

Issued by: Technology International (Europe) Limited

60 Shrivenham Hundred Business Park

Shrivenham, Swindon, SN6 8TY, UK

The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)

sensitive devices. Electrostatic charges readily accumulate on the human

body and equipment and can discharge without detection. Permanent

damage may occur on devices subjected to high-energy discharges. Proper

ESD precautions are recommended to avoid performance degradation or

loss of functionality. Store unused EZ-KIT Lite boards in the protective

shipping package.

ADSP-21369 EZ-KIT Lite Evaluation System Manual v

CONTENTS

PREFACE

Product Overview .......................................................................... x

Purpose of This Manual .............................................................. xiii

Intended Audience ...................................................................... xiii

Manual Contents ......................................................................... xiv

What’s New in This Manual ......................................................... xiv

Technical Support ......................................................................... xv

Supported Processors .................................................................... xvi

Product Information .................................................................... xvi

Analog Devices Web Site ........................................................ xvi

EngineerZone ........................................................................ xvii

Related Documents .................................................................... xviii

Notation Conventions ................................................................ xviii

USING THE ADSP-21369 EZ-KIT LITE

Package Contents .......................................................................... 1-2

Default Configuration ................................................................... 1-3

CCES Install and Session Startup .................................................. 1-4

Session Startup ........................................................................ 1-6

Contents

vi ADSP-21369 EZ-KIT Lite Evaluation System Manual

VisualDSP++ Install and Session Startup ....................................... 1-8

Session Startup ........................................................................ 1-8

CCES Evaluation License ........................................................... 1-10

VisualDSP++ Evaluation License ................................................. 1-11

External Memory ........................................................................ 1-11

ELVIS Interface .......................................................................... 1-13

Analog Audio ............................................................................. 1-14

LEDs and Push Buttons .............................................................. 1-15

Example Programs ...................................................................... 1-17

Board Design Database ............................................................... 1-17

ADSP-21369 EZ-KIT LITE HARDWARE REFERENCE

System Architecture ...................................................................... 2-2

External Port ........................................................................... 2-3

DAI Interface .......................................................................... 2-4

DPI Interface .......................................................................... 2-5

FLAG Pins .............................................................................. 2-6

External PLL ........................................................................... 2-7

Expansion Interface ................................................................. 2-7

JTAG Emulation Port ............................................................. 2-8

Switches ....................................................................................... 2-9

Boot Mode and Clock Ratio Select Switch (SW2) .................. 2-10

Codec Setup Switch (SW3) ................................................... 2-11

Electret Microphone Select Switch (SW4) .............................. 2-12

UART Enable Switch (SW5) ................................................. 2-12

ADSP-21369 EZ-KIT Lite Evaluation System Manual vii

Contents

Loopback Test Switches (SW6 and SW14) ............................. 2-12

Push Button Enable Switch (SW7) ......................................... 2-13

SPI Disable Switch (SW15) ................................................... 2-13

ELVIS Oscilloscope Configuration Switch (SW1) ................... 2-13

ELVIS Function Generator Configuration Switch (SW13) ...... 2-14

LEDs and Push Buttons .............................................................. 2-15

General Purpose LEDs (LED1–8) .......................................... 2-16

Power LED (LED9) ............................................................... 2-16

Reset LEDs (LED10) ............................................................. 2-16

USB Monitor LED (ZLED3) ................................................. 2-16

Push Buttons (SW8–11) ........................................................ 2-17

Board Reset Push Button (SW12) .......................................... 2-17

Jumpers ...................................................................................... 2-18

VCO Select Jumper (JP1) ...................................................... 2-19

ELVIS Select Jumper (JP2) .................................................... 2-19

ELVIS Voltage Selection Jumper (JP3) ................................... 2-20

ELVIS Programmable Flag Jumper (JP4) ................................ 2-20

Connectors ................................................................................. 2-21

Expansion Interface Connectors (J1–3) .................................. 2-22

Audio In RCA Connector (J10) ............................................. 2-22

Audio Out RCA Connector (J5) ............................................ 2-23

Headphone Out Jack (J9) ...................................................... 2-23

Power Jack (J4) ...................................................................... 2-23

RS-232 Connector (J6) .......................................................... 2-24

Contents

viii ADSP-21369 EZ-KIT Lite Evaluation System Manual

S/PDIF Coax Connectors (J7 and J8) .................................... 2-24

DPI Header (P3) ................................................................... 2-25

DAI Header (P4) .................................................................. 2-25

JTAG Header (ZP4) .............................................................. 2-25

ADSP-21369 EZ-KIT LITE BILL OF MATERIALS

ADSP-21369 EZ-KIT LITE SCHEMATIC

INDEX

ADSP-21369 EZ-KIT Lite Evaluation System Manual ix

PREFACE

Thank you for purchasing the ADSP-21369 EZ-KIT Lite®, Analog

Devices, Inc. evaluation system for SHARC®processors.

SHARC processors are based on a 32-bit super Harvard architecture that

includes a unique memory architecture comprised of two large on-chip,

dual-ported SRAM blocks coupled with a sophisticated I/O processor,

which gives a SHARC processor the bandwidth for sustained high-speed

computations. SHARC processors represents today’s de facto standard for

floating-point processing, targeted toward premium audio applications.

The evaluation system is designed to be used in conjunction with the

CrossCore®Embedded Studio (CCES) and VisualDSP++®development

environments to test capabilities of the ADSP-21369 SHARC processors.

The development environment aids advanced application code develop-

ment and debug, such as:

• Create, compile, assemble, and link application programs written

in C++, C, and ADSP-21369 assembly

• Load, run, step, halt, and set breakpoints in application programs

• Read and write data and program memory

• Read and write core and peripheral registers

• Plot memory

Access to the ADSP-21369 processor from a personal computer (PC) is

achieved through a USB port or an external JTAG emulator. The USB

interface provides unrestricted access to the ADSP-21369 processor and

Product Overview

x ADSP-21369 EZ-KIT Lite Evaluation System Manual

evaluation board peripherals. Analog Devices JTAG emulators offer faster

communication between the host PC and target hardware. Analog Devices

carries a wide range of in-circuit emulation products. To learn more about

Analog Devices emulators and processor development tools, go to

http://www.analog.com/dsp/tools.

The ADSP-21369 EZ-KIT Lite provides example programs to demon-

strate the product capabilities.

Product Overview

The board features:

• Analog Devices ADSP-21369 SHARC processor

• 256-pin SBGA package

• 400 MHz core clock speed

• Synchronous dynamic random access memory (SDRAM)

• 1M x 32-bit x 4 banks

• Synchronous random access memory (SRAM)

• 512K bit x 8-bit

• Flash memory

• 1M x 8-bit

• Serial peripheral interface (SPI) flash memory

•2Mbit

Otros manuales para ADSP-21369 EZ-KIT Lite

Tabla de contenidos

Otros manuales de Hardware de computadora de Analog Devices

Analog Devices

Analog Devices ADuCM322 Manual de usuario

Analog Devices

Analog Devices ADSP-219 Series Guía de aplicación

Analog Devices

Analog Devices EZ-KIT Lite ADSP-21364 Guía del usuario

Analog Devices

Analog Devices UG-397 Manual de usuario

Analog Devices

Analog Devices AD9866 Manual de usuario

Analog Devices

Analog Devices ADSP-BF53x Blackfin Manual de servicio

Analog Devices

Analog Devices iSensor ADIS/EVAL/USB Manual de instrucciones

Analog Devices

Analog Devices EZ-Extender PWM 180-Pin Manual de usuario

Analog Devices

Analog Devices AD9739 Manual de usuario

Analog Devices

Analog Devices EVAL-ADN4650EB1Z Manual de usuario

Analog Devices

Analog Devices EVAL-ADuCM420QSP1Z Manual de usuario

Analog Devices

Analog Devices Linear ADI Power LT1964 Guía de configuración rápida

Analog Devices

Analog Devices AD7194 Manual de usuario

Analog Devices

Analog Devices ADSP-2186 Manual de usuario

Analog Devices

Analog Devices ADSP-2106x SHARC Manual de usuario

Analog Devices

Analog Devices ADuCM355 Guía de inicio rápido

Analog Devices

Analog Devices LTC3728EG Manual de usuario

Analog Devices

Analog Devices EVAL-ADPD6000 Manual de usuario

Analog Devices

Analog Devices HPUSB Manual de usuario

Analog Devices

Analog Devices Blackfin Manual de usuario

Analog Devices

Analog Devices Linear LTM 4700 Manual de usuario

Analog Devices

Analog Devices AD9843A Manual de usuario

Analog Devices

Analog Devices ADSST-EM-3040 Manual de usuario

Analog Devices

Analog Devices ADICUP3029 Manual de usuario

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario