American Dynamics VM2000 Manual de usuario

Remove the appropriate video output board by

loosening the lower mounting screw and gently lifting

up on the BNC bracket (c) until the board disengages

from the motherboard connector (d) . Move the

board slightly toward the rear of the unit until it

disengages from the backplane connector (e). Lift

the board from the unit. Refer to diagram 2.

VM2000 Text Overlay Board 1-1

Sensormatic

SENSORVISION SYSTEMS

VIDEO MANAGER 2000

Text Overlay Board

Installation Instructions

V8000-0750-01 Rev A

WARNING SHOCK HAZARD!

CAUTION STATIC

SENSITIVE COMPONENTS!

DISCONNECT AC POWER TO

THE VM2000 CONSOLE.

FOLLOW PROPER HANDLING

PROCEDURES TO PREVENT

COMPONENT FAILURE.

Parts

The following steps are the procedures for the

installation of the Text Overlay Board:

a. left top cover

b. video output board

Refer to Diagram 3 for connecting the correct text

overlay board to the correct connectors on the video

output board and setting the appropriate jumper pins.

Insert the top edge connector (a) on the video

output board into the backplane connector while

aligning the two bottom edge connectors (b) with the

motherboard connectors as shown in Diagram 4.

Shut the console OFF and uplug the power cord.1.

Remove the left top cover (a) located over the

video output board (b) as shown in diagram 1.

c. BNC bracket

d. motherboard connector

e. backplane connector

Sensormatic

Description Qty. Part No.

0301-0337-011PCB ASSY, VIDEO

MGR2, TEXT OVERLAY

8000-0750-01 Rev A1

VM2000 Text Overlay Board1-2

Sensormatic

SENSORVISION SYSTEMS

Installation Instructions, continued

V8000-0750-01 Rev A

Press down on the BNC bracket of the board until

the board is seated in the motherboard connectors

as shown by diagram 4 .

a. top edge connector

b. bottom edge connector

Replace the right top cover plate and tighten the

fastening screws.

Connect the video output cables to the appropriate

video output connectors.

Note: If you are unsuccessful booting up the

system, then refer to the Service section of the

VM2000 Installation and Service Manual under

Boot Failures. For checking operation of the new

video inputs, refer to the User's Manual.

6. Verify that the edge connector on the video output

board is properly seated into the backplane

connector and that the bottom edge connectors are

aligned with the motherboard connectors.

Notes:

Plug in the power cord and switch the power ON to

reboot the system.

10.

OUTPUT #4 TEXT OVERLAY OUTPUT #3 TEXT OVERLAY OUTPUT #2 TEXT OVERLAY OUTPUT #1 TEXT OVERLAY

PLACE JUMPER

HERE IF NO OVERLAY

PLACE JUMPER

HERE IF NO OVERLAY

PLACE JUMPER

HERE IF NO OVERLAY

PLACE JUMPER

HERE IF NO OVERLAY

111 1

1 111

OUTPUT #1

OUTPUT #2

OUTPUT #3

OUTPUT #4

Sensormatic

8000-0750-01 Rev A1

Este manual sirve para los siguientes modelos

Otros manuales de Cambiar de American Dynamics

American Dynamics

American Dynamics AD168 Manual de usuario

American Dynamics

American Dynamics AD2031 Manual de usuario

American Dynamics

American Dynamics RJ860AP Series Manual de usuario

American Dynamics

American Dynamics AD1476-C Manual de usuario

American Dynamics

American Dynamics AD1985A Manual de usuario

American Dynamics

American Dynamics MegaPower AD1024HS Manual de usuario

American Dynamics

American Dynamics SensorNet RJ6SN Manual de usuario

American Dynamics

American Dynamics AD2033 Manual de usuario

American Dynamics

American Dynamics RJ860AP Series Manual de usuario

American Dynamics

American Dynamics RJ1SNUD Series Manual de usuario

American Dynamics

American Dynamics ADQUAD47 Manual de usuario

American Dynamics

American Dynamics AD168 Manual de usuario

American Dynamics

American Dynamics RJ856UD Series Manual de usuario

American Dynamics

American Dynamics RJ1SNUD Series Manual de usuario

American Dynamics

American Dynamics AD1416 Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario