10
Note.The heating and flame function can only be operated by the remote control.
The remote control needs 2 pcs AA batteries (not included).
Note:When the heater is turned on for the first time, it may release a slight, harmless odor. This
odor is a normal occurrence caused by the initial heating of the internal heating elements and
should not occur after the initial burn off. (This odor may occur again if dust or debris has been
trapped in the unit.)
2. When operating the remote make sure you point the remote to the centre of the heater unit and make
sure each time you press the button the LED indicator located on top right hand corner of the remote
blinks. If the LED fails to blink check the batteries. It takes some time for the receiver to respond to the
transmitter. Do not PRESS the buttons more than once within two seconds for correct operation.
3. Power on button: The power –on button at top left corner of the remote is the mains ON/ OFF
power button. This will turn off all the functions and the heater will be in standby mode.
4. Flame Power On button ”DISPLAY ON OFF”: This button controls both the ember and flame effect.
Once the flame effect is ON use the + and –buttons as explained below to adjust the flame brightness
as desired. Press this button again to turn OFF the flame effect.
a. The –or + buttons control the brightness of EMBER.
To increase the brightness of ember bed, press and release the + button. Each time you
press this button the brightness will increase by a small amount, until the maximum is reached.
To decrease the brightness of ember bed, press and release the –button. Each time you
press this button the brightness will decrease by small amount, until the minimum brightness is
reached.
b. The FLAME INTENSITY–or + buttons control the brightness of FLAME.
To increase the brightness / flame height, press and release the + button. Each time
you press this button the brightness will increase by a small amount, until the maximum is reached.
To decrease the brightness / flame height, press and release the –button . Each time
you press this button the brightness will decrease by small amount, unitl the minimum brightness is
reached. You can mix the ember and the flame to create a realistic flame effect.
5. Heater On/off button: This button is the heater ON / OFF button. Press this button to turn the heater
ON. The heater will always start at high heat setting 1500W. To turn OFF the heater press this button
again.
HIGH button: Press the high button to switch the heater to high heat setting 1500W.
LOW button: Press the low button to switch the heater to LOW heat setting 750W.
TEMP button: Press the TEMP. button to switch the heater to AUTO mode. Under this mode the
heater will operate in similar way as explained below for the manual o0peration.
