Altronics A 3217B Manual de instalación
1
A 3217B HDMI and Infrared Extender Balun
Over single 50m UTP Cables with IR Control
Operation Manual
2
I. Introduction
The HDMI extender over one UTP cable of up to 50m length with IR control is the best way to send
your HDMI signal over long distances. Instead of using expensive HDMI cables, this device lets
you use your existing Cat5e/ 6 cables/sockets while retaining the same performance characteristics
like transferring HDMI video and new lossless compressed (Dolby TrueHD, Dolby Digital Plus and
DTS-HD Master Audio) digital audio, all with a bandwidth up to 165MHz. You can also use your
existing remote to control your device through an enclosed IR blaster.
II. Features
1. Compliant with HDMI 1.3, HDCP 1.1 and DVI1.0 standards. Supports HDMI 1.4 with 3D,
ARC function.
2. Supports digital video formats in 1080p and new lossless compressed (Dolby TrueHD, Dolby
Digital Plus and DTS-HD Master Audio) Digital audio over UTP Cable of up to 50m length.
3
3. Equalizes and recovers incoming TMDS data before re-transmitting it at high quality,
regardless of the incoming signal quality.
4. Super IR control system, IR transport channel can be forward or backward.
5. Support HDMI loop out.
III. Package Contents
HDMI Transmitter
HDMI Receiver
5 Vd.c. 1A power adaptor 2pcs
Operation Manual
Wideband IR Tx 2pcs
Wideband IR Rx 2pcs
4
IV. Specifications
Transmitter Ports
2 × HDMI (Female type),1x Cat5e/6,2x3.5mm
phone
Receiver Ports
1x HDMI (Female type), 1xRCA, 1x
Cat5e/6,2x3.5mm phone
Support Resolution
480i ~1080p50/60, VGA~UXGA
ESD Protection
Human Body model: ±8 kV (air-gap discharge)
±4 kV (contact discharge)
Power Supply
5 Vd.c. 1A
Dimensions
65 mm (W) × 118mm (D) × 26mm (H)
Weight
410 g (TX+RX)
Chassis Material
Metal
5
Silkscreen Color
Black
Operating Temperature
0 °C~40 °C/ 32 °F~104 °F
Storage Temperature
−20 °C ~ 60 °C/−4 °F ~140 °F
Relative Humidity
20~90 % RH (non-condensing)
Power Consumption
3.2W (Transmitter)
2.2 w (Receiver)
V. Connect and Operate
1. Connect the signal source such as Blu-Ray Player, Play Station 3, audio/video receiver, or
satellite receivers and computers equipped with HDMI output interfaces, with a short
high-speed HDMI cable to the HDMI Transmitter input. HDMI cable length should not
exceed 5 metres.
2. Connect the HDMI Transmitter output RJ-45 ports using single Cat 5e or Cat 6 UTP cable to
included Receiver. It is strongly recommended that factory terminated cable assemblies be
6
used, and their length shall not exceed 50 metres respectively for the extenders.
3. Connect the HDMI output from the Receiver to high-definition display devices such as
HD-LCD, HD-DLP and HD projectors with HDMI input interfaces. Use high-speed HDMI
cables that are recommended for the distances that are required for each connection. HDMI
cable length should not exceed 5 metres.
4. The source can be controlled from the display. This is accomplished by using an optional IR
Receiver pigtail pointing away from the display, which can be connected to the receiver
portion of the extender. The IR Transmitter pigtail is then connected to the Transmitter of the
extender and pointed at the source.
7
VI. EDID control Table
The Splitter has 16 positions to select EDID on rear panel. Refer to the appendix EDID description.
Position
EDID Description
0
1080p, 2CH AUDIO
1
1080p, DOLBY/DTS 5.1
2
1080p, HD AUDIO
3
1080i, 2CH AUDIO
8
4
1080i, DOLBY/DTS 5.1
5
1080i, HD AUDIO
6
3D,1080p, 2CH AUDIO
7
3D, 1080p,DOLBY/DTS 5.1
8
3D,1080p, HD AUDIO
9
Copy EDID from the Transmitter HDMI loop out
A
Copy EDID from the Receiver HDMI out
B
1080p, 2CH AUDIO
C
1080p, 2CH AUDIO
D
1080p, 2CH AUDIO
E
1080p, 2CH AUDIO
F
1080p, 2CH AUDIO
9
VII. Connection Diagram
10
NOT FIELD SERVICEABLE.
Distributed by: Altronic Distributors Pty. Ltd. Perth. WesternAustralia.
Phone: 1300 780 999 Fax: 1300 790 999
Internet: www.altronics.com.au
Otros manuales de Extensor de Altronics
