Manual Halo 3.0 7 of 13
14.06.2019
Preparation:
Mount the fan(s) in a suitable location in your case using the included screws.
Place the controller to a suitable location in your chassis. Pay attention to the length
of the connection cables, which must be routed from each fan to the controller.
Connect the fans to the controller.
The fan connections are marked Fan 1-10 and for the strips (optional) LED 1-2.
1. Fan connection
2. Strip connection
3. Connection for external switch (fan speed)
4. Power connection
5. Connection for external switch (RGB effects)
Once all fans / strips have been connected, connect the controller to a Molex
connector on your power supply.
5 Operation
Control
You can control all functions of the LEDs with the radio remote control and some of
the functions also via a switch.
Control via switch
Connect a suitable switch to control the LED functions via a switch. E.g. take the
reset switch on the front of your case (In that case you will lose the reset function via
the switch) or another unused switch on your front panel or an additional switch that
you install anywhere on your case. If you have connected the controller with the
switch, you can switch to the lighting mode by pressing the switch. The control
option via the remote control is retained.
To control the fan speed via a switch, connect a suitable switch to your case. E.g.
take the reset switch on the front of your case (In that case you will lose the reset
