Alpha Alpha CB Boiler Manual de usuario

Installation Instructions

Alpha CB/C/SY Boiler

Vertical FlueTerminal Assembly

Twin Pipe (80 mm) Flue System

(Kit Part No. 6.1000369)

KIT CONTENTS

1. GENERAL

a. The flue system must be installed in accordance with BS 5440:1:1990.

b. The boiler must be installed in accordance with the installation instructions supplied with the boiler and the twin

pipe flue instructions supplied with the boiler conversion kit.

c. The vertical flue terminal assembly is equivalent to 1.0 m of flue length.

d. Refer to the vertical flue options in Fig. 1 and ensure that the flue length (H) does not exceed the equivalent of

7.0 m.

e. Each 45° bend is equivalent to 0.5 m of length of flue and no more than four bends must be used in each flue

exhaust or air inlet duct.

Note: 90° bends must not be used with the vertical flue.

f. Additional flue/air ducting is available in 1.0 m lengths for extending the flue up to a maximum equivalent flue

length of 7.0 m.

g. The vertical terminal may be connected directly to the boiler via the conversion kit. However, under no

circumstances must the terminal be shortened in length.

h. To determine the total length (A) of flue/air ducting required (refer to Fig. 1).

Measure the distance (X) from the top of the boiler side panel to the weathering slate position and subtract 640

mm for the terminal assembly, i.e. C = X - 640 mm

A = 2 x C + (50 mm for each connection in straight ducting).

Compiled and designed by Publications 2000, Tel (01670) 356211 08/04/D131

Fig. 1

H = Equivalent length of flue or air duct

The Vertical terminal assembly is equivalent to 1.0 m of flue length and each 45° bend is equivalent to 0.5 m of flue length.

Note: 90° bends must not be used with the vertical flue.

2. INSTALLATION

Refer to the Twin Pipe Flue installation instructions supplied with the boiler conversion kit (Part No. 6.1000368).

a. Refer to Fig. 1 for positioning of the vertical terminal in the roof.

b. To enable direct connection of the flue and air ducts to the terminal the duct centres must be 120 mm apart.

c. At the required position cut a hole and/or remove tiles so that there is at least a 170 mm diameter hole in the roof.

Ensure there is at least a 25 mm gap between the outer duct and any combustible material.

d. Fit a weathering slate, suitable for a 125 mm outside diameter flue, over the hole in the roof. A suitable weathering

slate (Part No. 6.1000380) is available from Alpha Therm Ltd.

e. Fit the terminal assembly into the weathering slate and place it in position, ensuring the minimum distances given in

Fig. 1 are maintained.

f. After assembly of the ducts to the terminal, ensure it is not possible to disengage any part of the flue assembly.

Check that the weathering slate is fitted correctly and ensure that the flue assembly is supported at roof level using

suitable brackets.

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

Nepicar House,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001 964

email: info@alphatherm.co.uk

website: www.alpha-innovation.co.uk

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Caldera de Alpha

Alpha

Alpha Alpha HE25 Manual de usuario

Alpha

Alpha al357i-b Manual de usuario

Alpha

Alpha 47 532 45 Guía del usuario

Alpha

Alpha E-Tec 28 Guía del usuario

Alpha

Alpha Evoke 28NX Manual de usuario

Alpha

Alpha InTec 40GS2 Guía del usuario

Alpha

Alpha Alpha 240 Boiler Range Guía del usuario

Alpha

Alpha ARES 150 Tec Guía del usuario

Alpha

Alpha Alpha CD13R Guía del usuario

Alpha

Alpha 280E Manual de usuario

Alpha

Alpha Alpha C23 Manual de usuario

Alpha

Alpha 240eco Guía del usuario

Alpha

Alpha Alpha CD50 Manual de usuario

Alpha

Alpha E-Tec 28 Manual de usuario

Alpha

Alpha E-Tec 15R Guía del usuario

Alpha

Alpha InTec 12S (NG) Guía del usuario

Alpha

Alpha 41 532 05 Guía del usuario

Alpha

Alpha Alpha Plus DH Units Guía

Alpha

Alpha Alpha CD25X Guía del usuario

Alpha

Alpha Alpha HE25 Guía del usuario

Alpha

Alpha 47 532 69 Guía del usuario

Alpha

Alpha Alpha 240X Guía del usuario

Alpha

Alpha Alpha CB Boilers Manual de usuario

Alpha

Alpha Alpha CombiMax 350 Hoja de instrucciones

Manuales populares de Caldera de otras marcas

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manual de usuario

Radijator

Radijator BIO max 23.1 Manual de usuario

Brunner

Brunner BSV 20 Manual de usuario

Buderus

Buderus Logamax GB062-24 KDE H V2 Manual de usuario

Potterton

Potterton 50e Hoja de datos

UTICA BOILERS

UTICA BOILERS TriFire Manual de usuario

Joannes

Joannes LADY Series Manual

ECR International

ECR International UB90-125 Manual de instrucciones

Froling

Froling FHG Turbo 3000 Manual de usuario

Froling

Froling P4 Pellet 8 - 105 Manual de usuario

U.S. Boiler Company

U.S. Boiler Company K2 Manual de usuario

Henrad

Henrad C95 FF Manual de usuario

NeOvo

NeOvo EcoNox EF 36 Manual de usuario

Potterton

Potterton PROMAX SL 12 Manual de usuario

Eco Hometec

Eco Hometec EC 25 COMPACT Manual de usuario

Viessmann

Viessmann VITODENS 200 Guía

Baxi

Baxi Prime 1.24 Manual de usuario

REXNOVA

REXNOVA ISA 20 BITHERMAL Manual de usuario