2.
Center the arm on the back of the panel and position the clamps under the edges of the panel's flange.
3.
Attach a solar panel clamp to one of the slots of the arm as follows:
A. Insert a 1/4" bolt, washer and solar panel clamp through one of the slots in the arm.
NOTE: Pay close attention to the orientation of the solar panel clamp.
B. Place a washer, split lock washer and hex nut on the other end of the bolt and tighten loosely.
4.
Repeat the previous step to attach the other solar panel clamp to the other slot in the arm.
5.
Make sure that the clamps are resting against the flange then tighten the bolts to hold the solar panel in
place.
NOTE: The image above shows the arm installed lengthwise on a 50W panel. For a 100W solar panel,
install the armwidthwise.
Step 2 - Attach the Arm and Solar Panel to the Pole Bracket
You will need the following items to complete this procedure:
» Arm and solar panel assembly
Mounting Bracket Installation Guide
