Albalá Ingenieros, S.A. TLE3100C02 Manual de usuario
TLE3100C02
ETHERNET/EIA-TIA-232-F/EIA-TIA-485-A COMMUNICATIONS CONTROLLER
WITH POE
Version 1.0
Albalá Ingenieros, S.A.
Medea, 4 - 28037 Madrid - Spain
02 December 2014 - © Albalá Ingenieros S.A. - All rights reserved
TLE3100C02
TLE3100C02
ETHERNET/EIA-TIA-232-F/EIA-TIA-485-A COMMUNICATIONS CONTROLLER
WITH POE
Version 1.0
1. DESCRIPTION ...................................................................................................................... 5
1.1. The TLE3100C02 ............................................................................................................................. 5
1.2. Features ............................................................................................................................................. 5
1.3. Block diagram .................................................................................................................................. 6
2. SPECIFICATIONS ................................................................................................................. 7
3. INSTALLATION .................................................................................................................... 9
3.1. Initial inspection ............................................................................................................................. 9
3.2. Safety instructions ......................................................................................................................... 9
3.3. Safety information regarding lithium batteries ............................................................... 10
3.4. Environmental considerations ................................................................................................ 10
3.5. Installing the module in the mounting frame ................................................................... 10
3.6. Interconnection ............................................................................................................................ 12
3.6.1. GPI connections ................................................................................................................... 14
3.6.2. GPO connections ................................................................................................................. 15
4. OPERATION ...................................................................................................................... 17
4.1. Front panel description .............................................................................................................. 17
4.2. IP configuration ............................................................................................................................ 18
4.3. Module remote control and supervision ............................................................................. 19
4.3.1. The TL3000 protocol .......................................................................................................... 20
4.3.2. The SNTP protocol ............................................................................................................... 22
4.3.3. Static addressing ................................................................................................................. 22
4.3.4. The TFTP protocol ................................................................................................................ 23
4.3.5. Details of the TLE3100C02 registers ............................................................................ 25
5. GLOSSARY ........................................................................................................................ 29
6. REGULATIONS .................................................................................................................. 31
7. VERSIONS ......................................................................................................................... 33
TLE3100C02
Albalá Ingenieros | Manual TLE3100C02
1. DESCRIPTION
1.1. The TLE3100C02
The TLE3100C02 module is a communications controller for the TL3000 family of
modular equipment from Albalá Ingenieros. This module allows control of any TL3000
family modules capable of remote control installed in a mounting frame via a serial port
or via an Ethernet LAN.
Serial port communication can be configured for TIA-EIA-232-F or TIA-EIA-485-A levels.
The TLE3100C02 module includes four optically isolated general purpose inputs and four
outputs with contact closure to ground that can be controlled from a computer.
In addition to providing communications to any TL3000 family modules installed in the
same mounting frame, the TLE3100C02 module can operate as an SNTP time server
when the mounting frame has a GPS reception module installed.
The TLE3100C02 is a TL3000 terminal line module and can be housed in a three rack unit
(3 RU) UR3000 mounting frame or a 1 RU UR3100 mounting frame.
1.2. Features
• Communications controller module that provides:
- One 10/100Mbit/s Ethernet port for connection to a LAN.
-One TIA-EIA-232-F or TIA-EIA-485-A serial bus for connection to a computer or to
TL3000-terminal line control panels.
-One high speed internal serial port for communication with all modules within
UR3000 and UR3100-type mounting frames using their internal data buses.
• Ethernet communications are established via TCP/IP and UDP/IP protocols.
• Four opto-isolated general purpose inputs.
• Four general purpose outputs via contact closure to ground.
•Front panel indicators for transmitted and received data and errors in any of the
Ethernet, TIA-EIA-232-F or TIA-EIA-485-A interfaces. There are also indicators for the
link, speed and communications mode of the Ethernet interface.
• Low power.
5
Albalá Ingenieros | Manual TLE3100C02
1.3. Block diagram
6
Albalá Ingenieros | Manual TLE3100C02
2. SPECIFICATIONS
Ethernet interface
Connector RJ45
Encoding and electrical characteristics:
100BASE-T According to IEEE std 802.3u standard
10BASE-T According to IEEE std 802.3i standard
Operating modes Auto-Negotiation speed,
full duplex/half duplex
Supported protocols IP, ARP, ICMP, TCP, UDP, SNTP, HTTP,
TFTP
Power over Ethernet output
Nominal voltage 48V ± 5 %
Nominal current 100 mA
Instantaneous current 150 mA
Positive output pin numbers 4 & 5
Negative output pin numbers 7 & 8
TIA/EIA-232 interface
Connector 9 pin subD male
Encoding and electrical characteristics According to TIA-EIA-232-F standard
Communication mode Asynchronous, full duplex, no
handshake
Baudrate 38400 baud
Communication parameters 8 data bits, 1 stop bit, no parity
TIA/EIA-485 interface
Connector 9 pin subD male
Encoding and electrical characteristics According to TIA-EIA-485-A standard
Communication mode Asynchronous, full duplex, no
handshake
Baudrate 38400 baud
Communication parameters 8 data bits, 1 stop bit, no parity
GPI input
Connector Plug-in terminal,
3.81mm pitch
Type Optocoupled
Number of inputs 4
Activation Closing contact to ground
Allowed voltage range ±50 V
7
Albalá Ingenieros | Manual TLE3100C02
GPO output
Connector Plug-in terminal,
3.81mm pitch
Type Relay closing contact to ground
Number of outputs 4
Allowed voltage range ±50V 250mA max.
Power supply output
Connector Plug-in terminal,
3.81mm pitch
Nominal voltage +6VDC unregulated
Maximum current 750 mA
Protection re-setteable fuse
General
Maximum power supply current + 300 / - 50 mA
Operating temperature range 0 .. 50 °C
Approximate weight 300 g
8
Albalá Ingenieros | Manual TLE3100C02
3. INSTALLATION
THE TLE3100C02 MODULE CONTAINS ELECTRONIC DEVICES SENSITIVE TO
ELECTROSTATIC DISCHARGE. Always use antistatic bags clearly identified
with a high degree of shielding for storage and transportation.
The TLE3100C02 module is composed of two parts: one TLE3100P01 main board and one
TLE3000P02 rear board. Both parts must be installed in a UR3000 or UR3100 mounting
frame following the instructions in the corresponding section of this chapter.
3.1. Initial inspection
Verify that the package has been properly handled during transport. After opening the
packaging, check that one TLE3100P01 main board and one TLE3000P02 rear board are
inside.
You must notify your Albalá Ingenieros distributor or dealer of any damage or defects
observed.
Follow the instructions in this manual to install this module in the mounting frame.
3.2. Safety instructions
•This equipment must be connected to a mains outlet with a protective
earth connection. Never use extension cords that do not have protective
earthing connection. The lack of an effective electrical connection between
the ground pin in the mains input connector of the equipment and the
protective earth of the electrical power distribution can cause serious harm.
•All modules of the Albalá Ingenieros TL3000 terminal line can be
hot-plugged or unplugged without suffering any damage or affecting the
processes that are currently taking place in other modules in the same
mounting frame. When a module is installed in an empty bay of a mounting
frame, it is necessary to mount the rear board that is part of that module.
Prior to installing this board, the mounting frame must be disconnected
from the power supply network. This is required because in addition to the
risk of electrocution for the person handling the device it is possible that a
high instantaneous current coming from the power supply could damage
the connectors and components of the mounting frame and/or the rear
board.
9
Albalá Ingenieros | Manual TLE3100C02
•The TLE3100C02 module and the mounting frame should always be
installed, maintained, operated and removed by personnel with sufficient
technical qualifications. The equipment should never be placed in damp
areas, near splashing liquid, or in explosive or corrosive atmospheres.
Neither modules nor mounting frames can be used in applications that
could endanger human life.
3.3. Safety information regarding lithium batteries
The TLE3100C02 module contains a lithium battery to keep the internal clock running
while the equipment remains off.
•Danger of explosion exists if the battery is replaced incorrectly. The battery
contains lithium and can explode if misused, handled or installed
incorrectly. Replace only with an equivalent CR2032 type.
In no case should the battery be:
- Thrown or immersed in water.
- Heated to more than 100° C.
- Repaired, disassembled or recharged.
Dispose of used batteries according to local laws. If there are no regulations on the
matter, deposit the battery in a the appropriate container for this type of waste for
recycling.
3.4. Environmental considerations
This symbol indicates that this equipment must be deposited at a collection
point for proper waste treatment once it has reached the end of its useful
life.
3.5. Installing the module in the mounting frame
The steps needed to install the TLE3100C02 module with the rear board in the mounting
frame are:
1 - Disconnect all power cords from the power supplies of the mounting frame.
2 - Remove the blank panels covering the front and rear of the empty bays chosen for
installing the TLE3100C02 in the mounting frame.
3 - Install the TLE3000P02 rear board ensuring that its 12-pin connectors are properly
aligned with the mounting frame´s mating connectors. Check that the orientation of
the board is correct by looking at the placement of the text printed on it according to
10
Tabla de contenidos
Otros manuales de Controladores de Albalá Ingenieros, S.A.
