Alba CR-07PL Manual de usuario
Alarm Clock Radio
Instruction manual
CR-07PL
You’ll soon be up and running
Looking forward to your new Alba alarm clock radio? Great. Then
let’s get you started.
Just follow this simple step-by-step guide and you’ll be good to
go.
Help and Guidance
We’re here to help you get the most from your <enter product name>. Should
you require any guidance, a simple solution can often be found online at:
www.argos-support.co.uk
If you still require further assistance, call one of our experts on 0345 604 0105.
If you require any technical guidance or find that your product is not operating as
intended, a simple solution can often be found in the Troubleshooting
Contents
1. Safety information
Safetyinformation 1
Batteryhandlingandusage 2
UK Mains plug information 2
2. Getting to know your alarm clock radio
Accessories 3
Functions&Control 3
Batterybackup 4
Standbymode 4
3. Using your alarm clock radio
Settingtheclock 4
Radiooperation 5
Presetting your favourite radio stations 5
4. Dual alarms operation
SettingAlarm1orAlarm2 6
Checkingalarmtime 6
Snoozefunction 6
5. Sleep timer operation
Settingsleeptimer 7
6. Other information
Technical specification 7
7. Product support
Help and assistance 8
Disposal 9
Troubleshooting 9
Guarantee 10
section of these instructions, or online at www.argos-support.co.uk If you still require
further assistance, call one of our experts on 0345 604 0105
1
Safety Information
Important – Please read these instructions fully before
installing or operating
This appliance is intended for domestic household use only and should not
be used for any other purpose or in any other application, such as for
non-domestic use or in a commercial environment.
The ventilation should not be impeded by covering the ventilation openings
with items, such as newspapers, table-cloths, curtains, etc.
No naked flame sources, such as lighted candles, should be placed on the
apparatus.
The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on the apparatus.
Ventilation
Allow at least a 10 cm gap all around the product.
This apparatus is not suitable for use in a tropical climate.
Prior to cleaning or other maintenance, the appliance must be disconnected
from the supply mains.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
To protect the environment, use local recycling facilities for battery disposal.
Where the MAINS plug is used as the disconnect device, the disconnect
device shall remain readily operable.
The marking plate is located at the bottom of the apparatus.
This means of disconnecting this apparatus from the mains supply is the
mains plug. This should be unobstructed and readily operable at all time.
2
Battery handling and usage
Only adults should handle battery. Do not allow a child to use this
apparatus unless the battery cover is securely attached to the unit.
The battery type used in the unit is 2 x 1.5V AAA size batteries (not
included) which are accessible and can be replaced.
Remove the battery cover located at the bottom of the unit to remove the
batteries.
UK Mains plug information
This appliance must be connected to a AC 230-240 volts 50Hz. AC supply by
means of a three pin socket, and should be protected by a 3 Amp fuse.
If the mains plug is unsuitable for the socket outlet in your home or is removed
for any other reason, then the cut off plug should be disposed of safely to
prevent the hazard of electric shock.
The wires in the mains lead on this appliance are coloured in accordance with
the following code:
Blue – Neutral
Brown – Live
Under no circumstances should Neutral or Live wires be connected to the ‘E’
(Earth) terminal.
Please read and retain these instructions for future reference.
3
Getting to know your Alarm clock radio
You’ll be up and running in no time
Ready? Let’s begin
Please read these instructions carefully. They contain important information
which will help you get the best from your product and ensure safe and correct
installation and operation.
If you require any further assistance, our technical experts are happy to help.
For full details, refer to the product support section at the end of these
instructions.
Accessories included
1 x CR-07PL
1 x Instruction manual
Functions & Control
1. POWER
2. Display
3. VOL / AL1 button
4. VOL / AL2 button
5. FM ANTENNA
6. TU / HOUR button
7. TU / MIN button
8. SLEEP
9. SET
10.SNOOZE
11.BAND
12.MEM (Memory)
13.Battery Door
4
Indicator lights
14.PM indicator (12 hour version)
15.Alarm 1 buzzer
16.Alarm 1 radio
17.Alarm 2 buzzer
18.Alarm 2 radio
Battery Backup
The clock, alarm and preset settings can be protected against AC power
failure with the battery for a short period of time. If no backup battery is
installed or the power failure is prolonged, you will need to set the clock, alarm
and preset settings again.
Standby mode
Place the unit on a flat stable surface and plug the power cord into the mains
socket.
The unit is in standby mode
“12:00” will flash on the display.
Using your Alarm clock radio
Setting the clock
1. In standby mode, while the display flashes repeatedly press HOUR / MIN
to set the hours and minutes.
Press and hold HOUR / MIN to advance the hour and minute until the
correct time is reached.
2. Press SET to confirm.
The display will stop flashing.
5
Power on/Radio mode
Press POWER to switch the unit on and enter the radio mode.
The radio frequency will briefly appear on the display and then return to
clock time.
Radio operation
1. Press POWER to turn on the radio.
The default FM radio frequency is 87.5 MHz.
2. Press BAND once to enter the AM radio mode.
The default AM radio frequency is 522 KHz.
3. Repeatedly press BAND to select the desired radio band.
4. Adjust the volume by repeatedly pressing VOL+ / VOL-.
5. Repeatedly press TU+ / TU- to tune into the desired station.
Press and hold TU+ / TU- for auto forward or backward radio station
searching.
Note:
For the best FM reception, extend the FM aerial to its full length.
For the best AM reception, rotate the unit slowly and horizontally.
Presetting your favourite radio stations
Up to 10 FM and 10 AM radio stations can be preset.
1. Follow steps in "RADIO OPERATION" and tune into
the station that you wish to preset.
2. Press and hold SET for about 2 seconds, “P01” will
flash on the display.
3. Press SET again to store the station.
4. Repeat steps 1 to 3 to store desired stations.
To listen to preset radio stations, repeatedly press MEM to select the desired
radio station.
6
Dual alarms operation
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
1. In standby mode, press and hold AL1 / AL2 until “12:00” flashes on the
display.
2. While “12:00” is flashing, set the alarm time by repeatedly pressing HOUR /
MIN.
Press and hold HOUR / MIN respectively for fast advance.
3. Repeatedly press AL1 / AL2 to select the desired alarm mode (buzzer or
radio).
Checking alarm time
Press and hold AL1 / AL2 for 2 seconds, the alarm time will flash briefly then
return to clock time.
To turn off the alarm, press POWER and the alarm will come on again at the
set time on the following days.
To cancel the alarm, in standby mode, press AL1 / AL2 until the alarm
indicator light goes out on the display.
Snooze function
This function can be used to stop the alarm temporarily for about 9 minutes
once the alarm is activated. When the snooze button is pressed, the alarm
sounds will stop and sound again after about 9 minutes.
The alarm indicator light will flash.
Tabla de contenidos
