1. 1.
3. 3.
5.
4. 4.
6.
2. 2.
Feed the paper into the
entry and release.
The machine will start
the shredding process
automatically.
3 | ajproducts.com
Capabilities Maintenance
Operation
Will shred:
Paper, CD/DVD’s, credit cards, staples
Will not shred:
Continuous forms, adhesive labels, transparencies,
newspaper, paper clips, cardboard, wet paper, laminates or
plastics other than noted above
Paper shred size:
Micro-cut ............................................................ 2x15mm
Maximum:
Sheets per pass ....................................................8 (70g)
Passes per day:..................................................... 50-100
Cards per pass............................................................... 1
Cards per day .............................................................. 50
Paper width .......................................................... 230mm
Duty cycle.................................................. 10-15 minutes
( Heavier paper, humidity or other than rated voltage
may reduce capacity)
Lubricate when or immediately, if:
- Capacity decreases
- The motor sounds different, or shredder stops running
Set to ” ”
Shred one sheet.
Only use a non-aerosol vegetable oil in long
nozzle container
Set to ”Rev” for 2-3
seconds.
Apply oil across entry. Press ”Fwd”.
For paper: For credit cards/CD:
Please check the voltage
of your shredder carefully
before using and then plug
in the cable, set the switch
to ”I” position.
Please check the voltage
of your shredder carefully
before using and then plug
in the cable, set the switch
to ”I” position.
Feed the credit cards/
CD into the marked entry
and the machine will start
the shredding process
automatically.
If you want to stop the
shredding process, press
the ”Rev” button for 2-3
seconds.
The machine will reverse
and eject the papers.
Press ”Power ON/OFF”, the
Power LED lamp should
be turned on green and
indicate standby mode.
Press ”Power ON/OFF”, the
power LED lamp should
be turned on green and
indicate standby mode.
Set switch to ”O” and
unplug the cable after use.
Set switch to ”O” and
unplug the cable after use.
Press ”Power ON/OFF”, the
power LED lamp should
be turned off and indicate
sleep mode.
