AirTek PCMH45 Manual de usuario
HUMIDIFIER
SERVICE MANUAL
CAUTION:
Before servicing the unit, read the “Safety Precautions” in this manual.
Only for authorized service.
MODEL NO.: PCMH45
2
CONTENT
1. Preface
1.1. Safety Precautions
1.2. Insulation Resistance Test
1.3. Specifications
1.4. Features
1.5. Warning & Safety Rules
1.6. Operations
1.7. Cleaning & Maintenance
2. Disassembly Instructions
2.1 How To Change Carbon Filter
2.2 How To Change PCBA
2.2.1 Top cap & air flow direction part
2.2.2 PCBA Box Cover & Wiring Holder
2.2.3 PCBA
2.2.4 PCBA Wiring Connection
2.2.5 Wiring Color Connection
2.3 How To Change Fan Motor
2.3.1 Wiring Connection Between The PCBA And Fan Motor
2.3.2 Water Wheel
2.3.3 Water Reservoir
2.3.4 Split pin & wheel Gear Of Synchronous Motor
2.3.5 Motor Cover
2.3.6 Wiring Holder & Cable Ties
2.3.7 Wiring Cap
2.3.8 Fan Blade & Motor
2.3.9 Wiring Color Connection
2.4 How To Change Drum Motor
2.4.1 Wiring Connection Between The PCBA And Drum Motor
2.4.2 Drum Motor
2.4.3 Drum Motor Wiring Connection
2.5 How To Change To New Water Wheel
2.5.1 Old Front Bearing Bracket And Old Spring;
2.5.2 New Front Bearing Bracket And New Spring;
2.5.3 New water wheel.
2.6 How To Change To New Motor Shroud
2.6.1 Power switch holder/power switch/water inlet connector with water inlet tube/motor
capacitor/synchronized motor
2.6.2 New Motor Shroud
3. Troubleshooting Guide
3.1. Outside Dimensions
3.2. How it works
3.3. Troubleshooting Guide
4. Schematic Diagram
4.1. Wiring Diagram
4.2. Wiring Color Description
5. Exploded View
6. Replacement Parts List
3
1. PREFACE
This manual is designed to provide you with important service information. Be sure to read the safety precautions
prior to servicing the unit.
1.1 Safety Precautions
1 When servicing, set the POWER of the CONTROL PANEL to OFF and unplug the power cord.
2 Observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or
damaged by the short circuit.
3 After servicing, make an insulation resistance test to prevent the customer’s exposure to shock hazards.
1.2 Insulation Resistance Test
1 Unplug the power cord and connect a jumper between 2 pins.
2 The grounding conductor (green or green & yellow) is to be open.
3 Measure the resistance value with an ohm meter between the jumper lead and each exposed metallic part on
the equipment at all MODES (except POWER OFF).
4 The value should be over 1 MΩ.
1.3 Specifications
MODELS
ITEMS
PCMH45
Power Supply 220-240V, 50Hz
Input (W) 70W
Running Current (A) 0.3A
Fan Type Fan Blade
Fan Speeds 3 (Hi/Med/Lo)
Operation Control Control Panel
Air Direction Control Horizontal Louver (Up & Down) - Manual
Timer Control 2 to 8 hours
Protector Fan Motor Internal Thermal Protector
Power Cord 1.8m (3 wire with grounding)
Water Fill System Manual (from top panel)
Auto (from tap water connector)
Drain System Manual empty water reservior
Evaporating Capacity 45 L/24h (at 21°C x 30% RH)
Water Tank Capacity 7.9 US Gallon / 30 L
Net Weight 27.3 lbs / 12.4 kg
Outer Dimension
(W x D x H)
29.5’’ x 17.3” x 29.3”
750 x 440 x 745 mm
4
1.4 Features
Very powerful airflow: up to 500 m3/hr or 294 CFM.
Carbon filter for air cleaning.
Adjustable humidification level to your comfort.
- L (low) the unit will keep the humidity level around the 30% RH
- M (medium) the unit will keep the humidity level around the 45% RH
- H (high) the unit will keep the humidity level around the 60% RH
- C (continuously) the unit will work continuously
Up to 8 hour timer.
Mounted with castors for easy mobility.
3 speeds: high, medium and low.
Low/High water alarm.
30 liter water tank capacity.
1.5 Warning & Safety Rules
WARNING - This appliance is intended for use in a domestic or office environment only. Any other use is
not recommended by the manufacturer and may cause fire, electrical shocks or other injury to person or
property.
When using electrical appliances, basic safety precautions should always be followed:
Your humidifier should run on 220-240 Volt AC, 50 Hz current only.
Check the household voltage to ensure it matches the appliance’s rate specification.
Extreme care should be taken when any product is used by, or near children, and whenever the product is left
operating and unattended.
Before operating the product remove it from its packaging and check it is in good condition.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
DO NOT operate any product with a damaged cord or plug.
DO NOT use an extension cord with this appliance.
DO NOT run power cord under carpeting, or cover with rugs or runners. Arrange the cord away from areas
where it may be tripped over.
Unplug the appliance during filling and cleaning.
Always unplug the appliance from the power source before servicing or removing the unit.
Disconnect the power supply before servicing or cleaning operation.
Remove the power cord from the electrical receptacle by grasping and pulling on the power cord plug-end
only, never from the cord.
DO NOT use the product in areas where gasoline, paint or other flammable goods and objects are stored.
DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit, as this may void
warranty. Take the unit to a qualified service engineer for inspection and repair.
Verify that the voltage power source matches the appliance electrical specifications. Improper voltage will
burn out the blower/fan, PCBA and will void the warranty.
DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage.
DO NOT insert or allow objects to enter any ventilation, exhaust opening or water tank as this may damage
the product and could cause an electrical shock or fire.
DO NOT operate with media removed as this will overload and damage the motor.
To reduce the risk of fire or electric shock, do not use this appliance with any solid state speed control device.
DO NOT leave the appliance operating unattended for any extended period of time.
This appliance is not intended for use by persons (including children or elderly) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety. People who have not
read this manual or are not use to this kind of product should not be allowed to use the unit.
5
DO NOT let children play with the packaging, for example plastic Bags, as there is a danger of suffocation.
Children should be supervised to ensure that they do not play with the appliance.
If the unit is damaged or it malfunctions, do not continue to operate it.
Only use in the upright position on a flat level surface.
This product is not intended for use in wet or damp locations. Never locate the product where it may fall into
a bathtub or other water container. DO NOT use in bathrooms. Do not use in outdoors. When it is not in use
always store in a dry area.
NOTE: OPERATE THE UNIT WHEN THE WATER TANK IS FILLED WITH CLEAN WATER
6
1.6 Operations
Control Panel:
Operation Instructions:
FILL WATER:
7
8
1.7 CLEANING & MAINTENANCE
9
4. Cleaning inside and outside
Use a soft cloth with mild soap to clean the outside and other inside parts with possible scale deposits
of your humidifier. Never use aggressive detergents to clean the unit. In order to extend the lifetime
of your humidifier we recommend to clean the unit inside, outside and the water reservoir regular.
10
2. DISASSEMBLY INSTRUCTIONS
WARNING – Before the following disassembly, POWER is set to OFF and disconnected the power cord.
2.1 How To Change Carbon Filter
Use screw driver to remove 1
SS screw with head (ST4*12)
on the air inlet grille.
Remove the air inlet grille. Get the carbon filter.
Tabla de contenidos
Otros manuales de Humidificador de AirTek
