AIPTEK Pocket DVT300LE Manual de usuario

English

Safety Notice:

1. Do not drop, puncture or disassemble the camera; otherwise the warranty will be voided.

2. Avoid all contact with water, and dry hands before using.

3. Do not expose the camera to high temperature or leave it in direct sunlight. Doing so may

damage the camera.

4. Use the camera with care. Avoid pressing hard on the camera body.

5. For your own safety, avoid using the camera when there is a storm or lightning.

6. Do not use batteries of different specications. Doing so may lead to the potential for serious

damage.

7. Remove the battery during long periods between usage, as a deteriorated battery may affect the

functionality of the camera.

8. Remove the battery if it shows signs of leaking or distortion.

9. Use only the accessories supplied by the manufacturer.

10. Keep the camera out of the reach of infants.

FCC Compliance Statement:

This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with limits for a Class B digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in residential installations. This equipment generates, uses, and can

radiate radio frequency energy, and if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause interference to radio or television equipment reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Move the equipment away from the receiver.

-Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/television technician for additional suggestions.

You are cautioned that any change or modications to the equipment not expressly approved by

the party responsible for compliance could void Your authority to operate such equipment.

*Environment:

Do not throw the appliance away with the normal household waste at the end of its life, but hand it

at an ofcial collection point for recycling.

By doing this you will help to preserve the environment.

Loading the battery

Please use two AA batteries.

1. Slide open the battery compartment cover as indicated.

2. Load the batteries into the battery compartment wtih + and - ends correctly installed.

3. Replace the cover.

Inserting the SD/MMC card (optional)

1. Lift the SD card cover.

2. Insert the card in the direction of indication until it reaches the end of the slot.

3. When using a SD card, the built-in memory will become inaccessible.

4. To remove the SD card, gently push the card until it pops up.

The serial number of the ﬁle name (PICTxxxx) will be counted continuously even

you delete all ﬁles on the SD card or insert a new one. If you want to restart the serial

number, plese use the camcorder “Format” function to format the card.

open

Turning on the camcorder

Open the LCD panel.

Press and hold down the Power button ( ) for 3 seconds.

Turning off the camcorder

Close the LCD panel.

Press and hold down the Power button ( ) for 3 seconds.

Press the Power button ( ) shortly will turn the video light on/off.

Setting Language

Power-on → Press the Mode button → Enter the Setting ( ) mode → Use the Zoom buttons

( ) to select the Language ( ABC ) item → Use the Zoom buttons ( ) to select a suitable

language and press the button to conﬁ rm.

Battery Life Indicator

Icon Description

Full battery life

Moderate battery life

Low battery life

Empty battery life

Note: To avoid sudden outage of power supply, you are recommended to replace the battery

when the icon indicates low battery life.

Reading LCD indicators

Digital Camcorder mode:

1.1x

Playback thumbnail mode:

Playback full mode:

Video REC mode:

1.1x

Focus mode

Flash mode

Photo resolution

Zoom ratio

Number of pictures/ﬁles

SD card inserted

Battery life

Play mode

Recording time

Volume

Current/total recordings

Play mode

Highlight box

NightShot

Smart Zoom

File type

Video resolution

Zoom ratio

Recording time

Battery life

Focus mode

Video light

mode

Recording

NightShot

Smart Zoom

SD card inserted

Recording a video clip

1. Set the focus to an appropriate setting. Normally, you may set the focus to ( ) for most

ﬁlming conditions. Select ( ) only for close-ups.

2. Press the Record button ( ) to start recording.

3. Use the Zoom buttons ( ) to zoom in or zoom out the screen.

4. Press the Record button ( ) again to stop recording.

Taking a still picture

1. Set the focus to an appropriate setting. Normally, you

may set the focus to ( ) for most ﬁlming conditions.

Select ( ) only for close-ups.

2. Use the Zoom buttons ( ) to zoom in or zoom out the

screen.

3. Press the Shutter button ( ) to take a still picture.

Playing back your recordings

1. Press the button.

2. Use the Zoom buttons ( ) to select the Playback ( ) mode.

3. Press the button to enter.

4. Use the Zoom buttons ( ) to shift between ﬁles.

5. Press the button to review/play the ﬁle.

Press the Shutter button ( ) to delete ﬁles.

Recording a voice clip

1. Press the button.

2. Use the Zoom buttons ( ) to select the Voice ( ) mode.

3. Press the button to conﬁrm. (*)

4. Press the Record button ( ) to start recording.

5. When you are done, press the Record button ( ) again to stop recording.

When entering the Voice mode, the remaining recordable time will be displayed on the

LCD.

50cm ~

30cm ~ 50cm

Connecting the camcorder to a TV

Connect your camcorder and TV via the accessory AV cable for real-time display. You can

display your video clips, still pictures, and audio recordings directly on your TV, sharing them

with your friends and family.

Video Audio

AV-Mode

Earphone

OUT

1. Turn on your TV and switch the TV to AV mode.

The TV system is different across countries. If you need to adjust the TV-out

setting, please refer to page 8 for more information. (Taiwan: NTSC; America:

NTSC; Europe: PAL; China: PAL)

2. Connect the audio and video ends of the AV cable to the TV.

3. Turn on the camcorder.

4. Connect the other end of the AV cable to your camcorder.

Connecting the camcorder to your PC

1. Turn on the camcorder.

2. Connect the camcorder to your computer by the USB cable.

The default is set to “Disk” mode. When connected to a PC, the camcorder will

automatically enter Disk (Removable disk) mode.

If you set the USB Mode to “Menu” mode, the following screen will appear.

Please select the desired connection mode.

If you would like to change the setting, please refer to page 9 for more

information.

Mode selection

1. Turn on the camcorder.

2. Press the button.

3. Use the Zoom buttons ( ) to select the desired item.

4. Press the button to conﬁrm.

Basic operation

How to... Action

Move the highlight bar Use the Zoom buttons ( ) to move up or down.

Conﬁrm an item Press the button.

Exit menu/Go back to upper menu Press the Mode/ button (when in sub-menu).

Menu items in Camera mode (1)

Power-on → Press the button.

Item Option Description

Resolution Please refer to addendum for more information.

Selftimer On/Off

Enable the selftimer. After the selftimer is turned on, the camcorder

will have ten seconds delay before recording when the Shutter

button is pressed.

Flash

Auto The ﬂash automatically ﬁres when the lighting is insufﬁcient.

On The ﬂash is forced to ﬁre in every shot.

Off The ﬂash is disabled.

* Two-in-One On/Off This setting allows you to combine two images taken individually

into one photo.

Histogram On/Off

The real-time histogram displays the approximate luminance

distribution on the screen. You may adjust the exposure to gain

better effect.

* Photo-

Frame

1 ~ 10

This setting allows you to add customized frames to photos. 10

background frames are available on the LCD monitor.

0 The Photo-Frame function is disabled

Menu items in Camera mode (2)

Item Option Description

Video VGA Set the video resolution to VGA (640x480 pixels).

QVGA Set the video resolution to QVGA (320x240 pixels).

Stabilizer On/Off Minimize blur caused by hand shake.

Smart Zoom On/Off This setting allows you to get a clearer image during using the

zoom buttons.

Auto The camcorder automatically adjusts white balance.

Sunny This setting is suitable for outdoor recording in sunny weather.

Cloudy This setting is suitable for recording in cloudy weather or shady

environments.

Fluorescent This setting is suitable for indoor recording with ﬂuorescent lamp

lighting, or environments with high color temperature.

Tungsten This setting is suitable for indoor recording with incandescent lamp

lighting, or environments with low color temperature.

Effect

Normal Make recordings in natural color.

B&W Make recordings in black and white.

Classic Make recordings in sepia-toned color.

Exposure -2~+2

Manually adjust the exposure to gain better effect when the preview

image appears too bright or too dark. A positive value indicates the

image will be brighter than usual; while a negative value makes the

image dimmer.

NightShot On/Off

This setting allows you to take a photograph with a dark

background. Since the shutter speed will slow down when taking

photographs at a dark place, we recommend using a tripod to

eliminate blurring from hand shake.

Video Light On/Off The setting allows you to add extra light when the lighting is

insufﬁcient during recording video clips

The Two-in-One and Photo-frame function will be disabled when the resolution is set

to 10M/12M.

Menu items in Playback mode

Power-on → Press the Mode button → Enter the Playback ( ) mode → Press

the Shutter button ( ).

Item Option Description

Delete One Yes/No Delete current ﬁle.

Delete All

Yes/No

Delete all pictures and video/audio ﬁles stored in the memory.

Menu items in Setting mode (1)

Power-on → Press the Mode button → Enter the Setting ( ) mode.

Item Option Description

Beep

On/Off

Enable beep sound on/off.

Flicker

50Hz/60Hz

Set ﬂicker frequency to 50Hz or 60Hz. For more information,

please refer to the “Flicker Settings” table.

TV-out

NTSC

Set TV system compatibility to NTSC. This option is suitable for

America, Taiwan, Japan, and Korea areas.

PAL

Set TV system compatibility to PAL. This option is suitable for

Germany, England, Italy, Netherlands, China, Japan, and Hong

Kong.

Icon

On/Off

Enable/disable OSD icons to display on the screen.

LCD Bright

0 ~ 4

Set LCD brightness. A greater value makes the LCD brighter;

while a smaller value makes the LCD dimmer.

Volume

0 ~ 10

Set the volume. (0: mute, 1-10 levels)

Format

Yes

Format the storage medium. Note that all ﬁles stored in the

medium will be gone.

The serial number of the ﬁle name (PICTxxxx) will be restarted.

Cancel action.

Auto Off

Off

1min/3min/

5min

Set how long the camcorder will automatically shut down when

staying inactive. Setting to [Off] will make the camcorder stay

powered on until it runs out of power.

Tabla de contenidos

Idiomas:

Otros manuales de Videocámara de AIPTEK

AIPTEK

AIPTEK POCKET DV 8800 NEO Manual de usuario

AIPTEK

AIPTEK Pocket DV 5100M Manual de usuario

AIPTEK

AIPTEK PocketDV 3300 Manual de usuario

AIPTEK

AIPTEK AHD-H12 EXTREME Manual de usuario

AIPTEK

AIPTEK V2T6 Manual de usuario

AIPTEK

AIPTEK AHD Z700 Extreme Manual de usuario

AIPTEK

AIPTEK Pocket DV5900 Manual de usuario

AIPTEK

AIPTEK AHD Z700 Extreme Manual de usuario

AIPTEK

AIPTEK POCKET DV M1 Manual de usuario

AIPTEK

AIPTEK AHD T8 Pro Manual de usuario

AIPTEK

AIPTEK DV T100 LE Manual de usuario

AIPTEK

AIPTEK PocketDV 4100 Manual de usuario

AIPTEK

AIPTEK MZ-DV Manual de usuario

AIPTEK

AIPTEK AHD-H23 Manual de usuario

AIPTEK

AIPTEK AHD200 Manual de usuario

AIPTEK

AIPTEK AHD-H23 Manual de usuario

AIPTEK

AIPTEK V5Z25 Manual de usuario

AIPTEK

AIPTEK Pocket DV6800LE Manual de usuario

AIPTEK

AIPTEK DV Z200 Pro Manual de usuario

AIPTEK

AIPTEK IS-DV Manual de usuario

AIPTEK

AIPTEK T8 Manual de usuario

AIPTEK

AIPTEK Go-HD Manual

AIPTEK

AIPTEK POCKET DV Z300 HD Manual de usuario

AIPTEK

AIPTEK Pocket DV VGA Guía

Manuales populares de Videocámara de otras marcas

Toshiba

Toshiba CAMILEO Z100 Manual de usuario

Panasonic

Panasonic NV-VS40B Manual de usuario

Canon

Canon RC 260 Manual de usuario

Sony

Sony Handycam DCR-DVD7E Manual de usuario

Brinno

Brinno TimeLapse TLC200 Manual de usuario

JVC

JVC GR-SXM68AC Guía de inicio rápido

Panasonic

Panasonic AG-HMC152EN Manual de usuario

Insignia

Insignia NS-DCC5HB09 - Camcorder - 720p Manual de usuario

MYDLINK

MYDLINK DCS-6100LH Manual de usuario

Sony

Sony video Hi8 Handycam CCD-TR555 Manual de usuario

SECURECOM

SECURECOM V-5014B Manual de usuario

Panasonic

Panasonic HDC-SD100 Manual de usuario

Sharper Image

Sharper Image U-VIDEO Manual de usuario

JVC

JVC AA-V15EG Manual de usuario

Canon

Canon LEGRIA HV40 Manual de usuario

Sony

Sony Handycam DCR-VX2000 Manual de usuario

RCA

RCA CC616 Manual de usuario

Panasonic

Panasonic NVM40 Manual de usuario