8
System Warnings
Read and study all instructions before using the Aerogen USB Controller
System.
Only trained persons should operate the Aerogen USB Controller System,
Aerogen Solo, Aerogen Pro and associated accessories.
If this product is being used to treat a life threatening condition, a backup
device is necessary.
During use observe for correct functioning of the nebuliser by regularly
verifying aerosol is visible and that no amber indicator lights are illuminated.
Do not use a filter or heat-moisture exchanger (HME) between the nebuliser
and patient airway.
The Aerogen nebulisers, T-pieces and accessories are not sterile.
The components and accessories of the Aerogen USB Controller System
are not made with natural rubber latex.
Only use physician-prescribed solutions that are approved for use with
a general purpose nebuliser. Consult drug manufacturer’s instructions
regarding suitability for nebulisation.
Only use the Aerogen nebuliser technology with components specified
in the instruction manuals. Use of the Aerogen nebuliser technology with
components other than those specified in the Instruction Manual may
result in increased emissions or decreased immunity of the nebuliser
system.
Do not place the Aerogen USB Controller in an incubator during use.
To avoid exhaled medication affecting the ventilator, follow ventilator
manufacturer’s recommendations for use of a bacterial filter in the
expiratory limb of a breathing circuit.
