Aercus WH31 Manual de usuario
WH31 MULTI-CHANNEL
THERMOMETER/HYGROMETER
Aercus Instruments™ - WH31 2 | P a g e
WH31 Wireless Multi-channel
Ther o eter/Hygro eter Sensor
Contents
1. Introduction ................................................... 3
2. Get Started ..................................................... 4
3. Overview ........................................................ 5
4. Setup Guide ....................................................
5. Sensor Placement......................................... 10
6. Specification ................................................. 12
. Contact Information ..................................... 13
Aercus Instruments™ - WH31 3 | P a g e
1. Introduction
Mode d'e ploi en français
Téléchargez ce manuel d'instructions en français
sur aercusinstruments.com/manuals/
Manuale Operativo in italiano
Scarica questo manuale di istruzioni in italiano da
aercusinstruments.com/manuals/
Thanks for purchasing this WH31 wireless
thermometer and hygrometer sensor. This
device measures temperature and humidity and
operates on one of 8 channels, meaning you can
measure eight distinct areas. The data can be
viewed on a WeatherMaster HP2550 weather
station console or can be streamed by GW1000
Wi-Fi Gateway and can be viewed on the WS
View App after configuration.
Aercus Instruments™ - WH31 4 | P a g e
Please read this manual and retain it for future
reference.
2. Get Started
One Multi-channel Temperature/Humidity
sensor
One User Manual
Aercus Instruments™ - WH31 5 | P a g e
3. Overview
Figure 1: Multi-channel Thermo/hygro Sensor
Aercus Instruments™ - WH31 6 | P a g e
Figure 2: Sensor LCD display
(1) Temperature
(2) Units (°C or °F)
(3) Channel number
(4) Relative humidity (%)
Aercus Instruments™ - WH31 | P a g e
4. Setup Guide
1. Remove the battery cover on the back
of the transmitter by sliding downwards,
as shown in Figure Error! Reference
source not found.3 .
Figure 3: Battery installation
Aercus Instruments™ - WH31 8 | P a g e
2. Before inserting the batteries, find the
dip switches above the battery
compartment and set the temperature
units and channel number:
Te perature Units: To change the transmitter
display units between °C and °F, change dip
switch 4, as referenced in Figure 4.
Channel Nu ber: This device supports up to
eight channels. To change the channel number,
set dip switches 1, 2 and 3, as referenced in
Figure 4.
Switch in down position. Switch in up
position.
Aercus Instruments™ - WH31 9 | P a g e
Figure 4: Dip Switch diagram
3. Insert two AA batteries.
4. Verify the correct channel number (CH)
and units of measure (°C or °F) are
displayed.
5. Close the battery door.
Aercus Instruments™ - WH31 10 | P a g e
5. Sensor Place ent
The sensor is ideally mounted in a location
that never receives direct sunlight. Also, avoid
locations with a nearby radiant heat source
(radiator, heaters etc.) Direct sunlight and
radiant heat sources will result in inaccurate
temperature readings.
The unit is weather resistant. If you are
placing it outside, please select a covered,
sheltered location in the eves or under an
awning.
To mount or hang the unit on a wall or wood
beam either:
Use a screw or nail to attach the remote
sensor to the wall, as shown in Figure 5,
-or-
Tabla de contenidos
