AEG Perfekt Glide-24 Manual de usuario

Perfekt Glide-24, Perfekt Glide-30

Built-in Range hood Instruction Manual

Thank you for the purchase of this product. Please read the

manual carefully before operating the appliance.

1 | P a g e

Contents

Safety Precautions

2-5

Accessories

Features

Installation Preparation

Selecting Venting Direction

Cabinet Preparation for Hood Support

8-9

Preparation for Duct Connection

Hood Installation

Controls

Specifications

Use and Care

Trouble Shooting

13-14

Installation Diagram

Warranty Information

2 | P a g e

Safety Precautions

READ AND SAVE THESE INSTRUCTIONS

WARNING –to reduce risk of fire, electrical shock, or injury,

observe the following:

oRead all instructions before using the appliance

oUse this appliance only for its intended purpose as

described in this user manual

oDo not use any accessories not recommended by the

manufacturer

oThis unit must be grounded

oDo not use this appliance for commercial use

oDo not use with any solid-state speed control device

oInstallation work and electrical wiring must be done by

qualified technicians in accordance with all applicable

codes and standards, including fire-rates construction

oSufficient air is needed for proper exhausting of gases of

fuel burning equipment through the chimney to prevent

back drafting. Follow the heating equipment

manufacturer’s guideline and safety standards

oWhen replacing an existing range hood with your new

AEG Perfekt Glide range hood, turn OFF the electrical

power to the existing unit before removal

oUnplug the unit before cleaning or servicing

oDo not repair or replace any part of the appliance or

attempt servicing. Note: if for any reason this product

requires service, please contact Euro-Parts 1-800-678-

8352

oWhen cutting or drilling into wall or ceiling, be careful

not to damage existing electrical wiring and other hidden

utilities

oDucted fans must always be vented to the outdoors

3 | P a g e

WARNING –to reduce risk of cooktop grease fire:

oNever leave cooking unattended at high settings. Boil-

overs cause smoking and greasy spillovers may ignite.

Heat oils slowly on low or medium settings

oAlways turn the hood on when cooking at high heat or

when cooking flaming food (i.e. Crepes Suzette, Cherries

Jubilee, Flambés)

oClean ventilation fans frequently. Do not allow grease to

accumulate on the fan or filter

oUse proper sized pans that correspond to the size of the

stove and the amount of food being cooked

WARNING –to reduce risk of personal injury in the event of

a cooktop grease fire:

oSmother flames with a close-fitting lid, metal tray, or

baking sheet. Then turn the burner OFF. BE CAREFUL TO

AVOID BURNS. If the flames are not put out

immediately, evacuate and call the fire department.

oNEVER pick-up a flaming pan

oDO NOT use water, including west dishcloths or towels

to put out a fire. A violent steam explosion may result

oUse a fire extinguisher only if:

a. You know that you have a Class ABC extinguisher and

know how to use it

b. The fire is small and contained in the area it started

c. The fire department is being called

d. You can use the extinguisher with your back to an exit

4 | P a g e

CAUTION!

Important –observe all governing codes and ordinances.

oFor general ventilation use only. Do not use this

appliance to exhaust hazardous or explosive materials

and vapors

oTo reduce the risk of fire, use only metal duct work

oTo avoid damage to motor or other components, keep

drywall spray, construction dust, etc. off the power unit

oPlease read the specification label on product for further

information and requirements

oTo reduce risk of fire and exhaust air, be sure to duct air

outside. Do not vent exhaust air into space within wall or

ceiling, or into attic, crawl space or garage

CAUTION!

Grounding Instructions

oThis appliance must be grounded. In the event of an

electrical short circuit, grounding reduces the risk of

electrical shock by providing an escape wire for the

electrical current. This appliance is equipped with a cord

having a grounding wire with a grounding plug. The plug

must be plugged into an outlet that is properly installed

and grounded.

oImproper grounding can result in a risk of electric shock.

Consult a qualified electrician if the grounding

instructions are not properly understood, or if doubt

exists as to whether the appliance is properly grounded.

Do not use an extension cord. If the power supply cord is

too short, have a qualified electrician install an outlet

near the appliance

5 | P a g e

CAUTION!

oDo not operate any fan with a damaged cord or plug.

Discard fan or return to an authorized service facility for

examination and/or repair

oDo not run cord under carpeting. Do not cover cord with

throw rugs, runners, or similar coverings. Do not route

cord under furniture or appliances. Arrange cord away

from traffic area and where it will not be tripped over.

Accessories

Range hood accessories provided:

o1 x Range hood

o4 x Range hood screws

o4 x Washers

o2 x Filters

o1 x User manual

Check to make sure that all parts and accessories are present

and in good condition. If you find that they are not in good

condition or missing, please contact Euro-Parts for assistance

1-800-678-8352

6 | P a g e

Features

oThis appliance is manufactured from top quality

materials, and offers superb streamlined effects

oWith high suction power and low noise, it is designed to

remove cooking fumes from your kitchen quietly and

effectively

Installation Preparation

Note: this procedure will require 2 people for easier

installation

General Preparation

oRemove range from packaging and lay upside down on

table covered with cardboard or paper to prevent

scratching of the hood or table

oBe sure the power switch is set to OFF

Tools needed for installation:

oDrill

o1/8” drill bit for pilot holes

o1-1/4” wood bit for drilling electrical wiring access hole

oPhillips head screwdriver

oFlat-head screwdriver

oPliers

oPencil, ruler and level for marking range hood location

oHand saw or jig saw for cutting the wall or cabinet

openings

oDuct tape

oElectrical tape

oConnector clamp

7 | P a g e

Selecting the Venting Direction

The range hood can be used for either vertical or ductless air

discharge. It is set up for vertical discharge.

Vertical Discharge - Vertical discharge is

the most common method of hood

installation. If your kitchen has an attic

space above, the ducting may be run

through the cupboard and the attic to a

roof cap. Use a 7” round duct (not included).

Another option, if your kitchen has a soffit above the

cabinet, is to run the duct up into the soffit and then

discharge the air horizontally through the outside wall to a

wall cap.

Ductless –In ductless installations, air is

vented back into the kitchen through

the opening in the range hood grille. If

you do not anticipate heavy cooking, this method is

preferable. Ductless installation requires the use of charcoal

filters* to remove odors, which should be replaced at regular

intervals depending on use. Check with your local retailer or

dealer for replacements. Note: This filter is not dishwasher

safe!

*If hood is to be installed non-ducted, install a charcoal filter, purchased separately.

When venting ductless, you must remove

the vent cover from the slots on the front

of the range hood. Save the vent cover for

possible future use. Use the 70mm rail

instead of 40mm rail.

8 | P a g e

Cabinet Preparation for Hood Support

The range hood should be mounted at a distance of 600mm

from an electric or induction cooktop, and 762mm above a

gas cooktop for safety and optimum performance.

If you install the hood with a duct,

you will need to provide a hole for

the duct. Please use the template

provided to locate the hole.

Use the diagram below for proper placement of ductwork

and electrical cutout in cabinet. For a non-ducted

installation, DO NOT cut a duct access hole.

Warning! When cutting or drilling into wall or cabinet, be

careful not to cut existing electrical wiring.

1. If the bottom of the cabinet is recessed above the

bottom of the cabinet door, then it is necessary to

install wood strips on each side of the recessed area

on the bottom of the cabinet where the range hood

will be mounted. The wood strips should line up with

the 4 keyhole slots on the top of the range hood.

9 | P a g e

Fasten the wood strips with wood screws about 3” in

from each end.

NOTE: the thickness of the wood strips should be

slightly more than the recessed dimension. The

length should be cut to size.

2. Measure and mark the electrical wiring opening in

the wall or the cabinet. If the hood is to be vented,

also mark and measure the duct opening in the wall

or cabinet.

Preparation for Duct Connection

Remove the appropriate ducting knockout by inserting a

screwdriver under one end and prying it up. Then snip or

break the attachment points.

Before installing the range hood, please first fix the outlet on

the air duct hole of the hood.

Otros manuales para Perfekt Glide-24

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Campana de ventilación de AEG

Manuales populares de Campana de ventilación de otras marcas

emmeti

emmeti RECUPA MED A-140 Guía

Nibe

Nibe F135 Manual de usuario

Kuppersberg

Kuppersberg INTRO 60 Instrucciones de instalación y mantenimiento

Zephyr

Zephyr Spruce AK9834BS Guía de instalación

Hisense

Hisense MH6INBG Manual de usuario

Miele

Miele DA 1255 Manual de usuario

Broan

Broan 46000 Manual de usuario

GE Profile PV977 Instrucciones originales

FALMEC

FALMEC FFRIA24W5FS Manual de usuario

Whirlpool

Whirlpool RH2600XL-1 SERIES Manual de usuario

Küppersbusch

Küppersbusch DX ISLA Manual de usuario

ETNA

ETNA AV360RVS Manual de usuario

JUNO

JUNO JDF603E6 Manual de usuario

Miele

Miele DA 6708 D Manual de usuario

Tricity Bendix

Tricity Bendix LE 150 Manual

Smeg

Smeg KSEV97X Manual de usuario

Nibe

Nibe S Series Guía del usuario

Caple

Caple CCH100 Manual