Advantech PCM-3614I Manual de instalación y operación

1 Startup Manual All product specifications are subject to change without notice.

STARTUP MANUAL

PCM-3614I

4-port RS-232/422/485 Module

The PCM-3614I is a PCI-104 compatible module

with 4 individually configurable RS-232/422/485

ports. The PCM-3614I also features high

transmission speeds, independent/shared IRQ’s, a

high-performance 16C550 UART communication

chip with 16-byte FIFO to reduce CPU load, and

more. These function settings include Standard/

Enhance, Independent/Shared IRQ & Speed modes.

We carefully inspected the PCM-3614I both

mechanically and electrically before we shipped it.

It should be free of marks and scratches and in per-

fect electrical order on receipt.

Handle the board only by its edges. The static

charge on your body may damage its integrated cir-

cuits. Keep the card in its anti-static package when-

ever it is not installed. You can use this package to

return the card if it should need repair.

• 4 Independent RS-232/422/485 serial ports

• Automatic RS-485 data flow control

• Transmission speeds up to 921.6 Kbps

• Shared IRQ settings for each port

• Built-in terminal resistors

• LED indicators: TX, RX

• Bus interface: PCI-104

• Number of ports: 4

• UART: 16C550

• IRQ: 3, 4, 5, 6, 7, 9, 10, 11, 12, 15

• Data bits: 5, 6, 7, 8

• Stop bits: 1, 1.5, 2

• Parity: none, even, odd

• Speed (bps): 50 ~ 921.6K

• Connectors: DB-9 male

• Signal:

RS-422: TxD+, TxD-, RxD+, RxD-, GND

RS-485: DATA-, DATA+, GND

RS-232: TxD, RxD, RTS, CTS, DTR, DSR,

DCD, RI, GND

• Operating Temperature: -40~85°C (-40~185°F)

• Storage Temperature: -40~85°C (-40~185°F)

• Operation Humidity: 0% ~ 90%

|Relative Humidity, non-condensing

Card Configuration

The max configuration for the PCI bus of PCI-104

modules is FOUR plus the host board. If you stack

more than one PCI-104 module to a host board be

sure to set the modules to different PCI numbers

through SW2.

SW1 Settings

1. Use pin 5 ~ 8 on SW1 to determine mode of

port 0 to port 3 as RS-422 or RS-485. The pin

number and port number are mapping directly.

• “ON” is RS-485 mode. “OFF” is RS-422 mode.

• For example, pin 5 is mapping to port 0. So if

you set pin 5 to “ON”, it means port 0 is RS-

485 mode.

• If you set pin 5 to “OFF”, it means port 0

becomes RS-422 mode.

Introduction Specifications

Initial Inspection

Features

Notes

For more information on this and other Advantech

products, please visit our websites at:

http://www.advantech.com

http://www.advantech.com/eAutomation

For technical support and service:

http://www.advantech.com/support/

This startup manual is for PCM-3614I.

Part No: 2003361400 1st Edition

April 2013

RS-232 RS-422 RS-485

N/A 1,2,3,4,ON: Master

5,6,7,8 OFF

1,2,3,4,OFF: Slave

(Auto)

1,2,3,4,OFF

5,6,7,8 ON

All manuals and user guides at all-guides.com

all-guides.com

2 Startup Manual

2. When you set selected port as RS-422 mode, use pin

1 ~ 4 on SW1 to determine port 0 to port 3 as Master

or Auto mode.

• (Auto mode means corresponding port will auto-

matically configure itself as master or slave). The

pin number and port number are mapping directly.

• “ON” is Master mode. “OFF” is Auto mode.

• For example, when port 0 is set as RS-422 mode.

pin 1 is mapping to port 0. So if you set pin 1 to

“ON”, it means port 0 is Master mode.

• If you set pin 1 to “OFF”, it means port 0 becomes

Auto mode.

SW2 Settings

Hardware Installation

Installing the Module on a CPU Card:

1. Turn the PC power off. Turn the power off to any

peripheral devices such as printers and monitors.

2. Disconnect the power cord and any other cables from

the back of the computer.

3. Remove the system unit cover

4. Remove the CPU card from the chassis (if necessary)

to gain access to the card’s PCI-104 connector.

5. Screw the brass spacer (included with the module)

into the threaded hole on the CPU card. Do not

tighten too much, or the threads may be damaged.

6. Carefully align the pins of the PCM-3614I with the

PCI-104 connector. Slide the module into the con-

nector, do not push too hard.

7. Secure the module to the CPU card to the threaded

hole in the CPU card using the included screw.

8. Attach any accessories to the PCM-3614I.

9. Reinstall the CPU card and replace the system unit

cover. Reconnect the cables you removed in step 2.

10. Turn the power on.

Connecting to Another PCI-104 Module:

1. Insert the pins of connector CN15 into the piggy-

back connector on the other PCI-104 module.

2. Screw the PCM-3614I to the brass spacer. This com-

pletes the hardware installation

Pin Assignments and Jumper Settings

The function of PCM-3614I is adjustable by the follow-

ing jumpers.

Jumper Settings of CN1~CN10

CN and COM Port Mapping

The following table and figure shows pin assignments

for the DB9 connector.

12PCINumber

OF OFF 0

ON OFF 1

OFF ON 2

ON ON 3

Warning! Turn off PC whenever you install, remove connect

or disconnect cables to PCM-3614I

RS-232

CN3,CN4,CN5

Short pins:1-2, 3-4,5-6,7-8,9-10

CN2

Short pins:1-2, 3-4,5-6,7-8,9-10

CN1

Open

RS-422

CN3,CN4,CN5

Short pins:11-12,13-14,15-16,17-18,19-20

CN2

Open

CN1

Short pins:1-2, 3-4,5-6,7-8,9-10

RS-485

CN3,CN4,CN5

Short pins:11-12,13-14,15-16,17-18,19-20

CN2

Open

CN1

Short pins:1-2, 3-4,5-6,7-8,9-10

CN Number COM Port Number

All manuals and user guides at all-guides.com

Startup Manual 3

Pin Assignments of RS-232 DB9 Connector

Pin Assignments of RS-422/485 DB9 Connector

Pin Assignments of RS-422/485 Configuration

Pin RS-232

1 DCD

2RxD

3TxD

4DTR

5GND

6DSR

7RTS

8CTS

9RI

Pin RS-422/485

1 TX-(DATA-)

2 TX+(DATA+)

3RX+

4RX-

5GND

6RTS-

7RTS+

8CTS+

9CTS-

Pin Description Pin Description

Port 0

Data- 1 TX- 2 RTS-

Data+ 3 TX+ 4 RTS+

5RX+ 6CTS+

7RX- 8CTS-

9 GND 10 NC

Port 1

Data- 11 TX- 12 RTS-

Data+ 13 TX+ 14 RTS+

15 RX+ 16 CTS+

17 RX- 18 CTS-

19 GND 20 NC

Port 2

Data- 21 TX- 22 RTS-

Data+ 23 TX+ 24 RTS+

25 RX+ 26 CTS+

27 RX- 28 CTS-

29 GND 30 NC

Port 3

Data- 31 TX- 32 RTS-

Data+ 33 TX+ 34 RTS+

35 RX+ 36 CTS+

37 RX- 38 CTS-

39 GND 40 NC

All manuals and user guides at all-guides.com

Otros manuales de Tarjeta PCI de Advantech

Advantech

Advantech PCI-1710 Manual de usuario

Advantech

Advantech MIC-3756 Manual de usuario

Advantech

Advantech PCI-1601 Manual de usuario

Advantech

Advantech PCA-6194 Manual de usuario

Advantech

Advantech PCIE-1803 Manual de instalación y operación

Advantech

Advantech PCIE-1884 Manual de instalación y operación

Advantech

Advantech MIC-3723 Manual de usuario

Advantech

Advantech PCIE-1744 Manual de usuario

Advantech

Advantech PCI-1730 Manual de usuario

Advantech

Advantech PCA-5612 Manual de instalación y operación

Advantech

Advantech DVP-7636HE Manual de usuario

Advantech

Advantech MIC-3401 Manual de usuario

Advantech

Advantech PCI-1723 Manual de usuario

Advantech

Advantech PCI-1710U-DE Manual de usuario

Advantech

Advantech PCI-1751 Manual de usuario

Advantech

Advantech PCI-1712 Manual de instalación y operación

Advantech

Advantech PCN-6351 Series Manual de usuario

Advantech

Advantech PCI-1751U Manual de usuario

Advantech

Advantech MIC-3620 Manual de usuario

Advantech

Advantech PCM-28P1AD Manual de instalación y operación

Advantech

Advantech PCIE-1758 Series Manual de usuario

Advantech

Advantech RIO-3302 Manual de usuario

Advantech

Advantech PCA-6184VE Manual de usuario

Advantech

Advantech PCI-1680U Manual de usuario

Manuales populares de Tarjeta PCI de otras marcas

ERMA

ERMA SSI 1417 Manual de usuario

SIIG

SIIG CyberSerial Dual PCI Instrucciones de montaje

Moxa Technologies

Moxa Technologies CP-102E Manual de usuario

I-Bus

I-Bus IBC2602 Manual de usuario

Exsys

Exsys EX-60102 Manual de usuario

Chelsio Communications

Chelsio Communications T5 Series Manual de usuario

Conrad Electronic

Conrad Electronic 97 46 71 Manual de usuario

Micro Innovations

Micro Innovations USB650A Manual de usuario

KTI Networks

KTI Networks KF-310 Manual de usuario

Asus

Asus SpaceLink WL230 Manual de usuario

SIIG

SIIG SC2475 Manual de usuario

TRENDnet

TRENDnet TEW-703PI Manual de usuario

Belkin

Belkin F5D7000F Manual de usuario

Pericom

Pericom PI7C7100 Manual de usuario

ADLINK Technology

ADLINK Technology cPCI-3548 Manual de usuario

Digium

Digium TE200 Series Manual de usuario

Allo.com

Allo.com 2nd Gen E1/T1/J1 Manual de usuario

Western Digital

Western Digital FireWire PCI Adapter Manual de usuario