Advantech PCM-4862 Manual de usuario
PCM-4862
All-in-One 486 Single Board
Computer with SVGA, Ethernet,
and SSD
Copyright Notice
This document is copyrighted, 1996. All rights are reserved. The
original manufacturer reserves the right to make improvements to
the products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in
this manual is intended to be accurate and reliable. However, the
original manufacturer assumes no responsibility for its use, nor for
any infringements upon the rights of third parties which may result
from its use.
Acknowledgements
VIA is a trademark of VIA Technology, Inc.
AMD is a trademark of Advanced Micro Devices, Inc.
Award is a trademark of Award Software International, Inc.
Cyrix is a trademark of Cyrix Corporation.
IBM, PC/AT, PS/2 and VGA are trademarks of International
Business Machines Corporation.
Intel and Pentium are trademarks of Intel Corporation.
Microsoft Windows ®is a registered trademark of Microsoft Corp.
SMC is a trademark of Standard Microsystems Corporation.
RTL is a trademark of Realtek Semi-Conductor Co., Ltd.
C&T is a trademark of Chips and Technologies, Inc.
UMC is a trademark of United Microelectronics Corporation.
All other product names or trademarks are properties of their
respective owners.
Part No. 2006862020 3rd Edition
Printed in Taiwan September 1997
Packing list
Before you begin installing your card, please make sure that the
following materials have been shipped:
• 1 PCM-4862 All-in-One Single Board Computer
• 1 utility disk with system BIOS, VGA BIOS, and Ethernet
utility programs
• 1 utility disk with SVGA utility programs and drivers for
Windows 3.1 and Windows 95
• 1 utility disk with Ethernet drivers
If any of these items are missing or damaged, contact your
distributor or sales representative immediately.
Contents
Chapter 1 General Information ................................. 1
Introduction............................................................................ 2
Features ................................................................................... 3
Specifications.......................................................................... 3
Standard SBC functions ....................................................... 3
Local-bus flat panel/VGA interface ..................................... 4
Ethernet controller function ................................................. 5
Solid state disk function ....................................................... 5
PC/104 bus expansion .......................................................... 5
Mechanical and environmental ............................................ 5
Board layout and dimensions ................................................ 6
Chapter 2 Installation ................................................ 7
Jumpers and connectors........................................................ 8
Locating jumpers ................................................................. 10
Locating connectors ............................................................. 11
Setting jumpers .................................................................... 12
Safety precautions ................................................................ 13
Installing the CPU................................................................ 13
Removing a CPU................................................................ 13
Installing a CPU ................................................................. 14
CPU type select (J1-J13, J17-J19) ..................................... 15
CPU power supply select (J4, J6) ....................................... 17
CPU clock select (J1, J2, J3).............................................. 17
CMOS setup (J14).............................................................. 17
Buzzer enabled/disabled (J21) ........................................... 17
Installing DRAM (SIMMs) ................................................. 18
Installing SIMMs ............................................................... 18
IDE hard drive connector (CN12) ...................................... 19
Connecting the hard drive .................................................. 19
Floppy drive connector (CN15)........................................... 20
Connecting the floppy drive ............................................... 20
Parallel port connector (CN16)........................................... 21
Parallel port IRQ ................................................................ 21
Keyboard and PS/2 connector (CN9) ................................. 21
Front panel connector (CN4) .............................................. 22
Power connectors (CN6, CN11, CN14)............................... 22
Peripheral power connector, -5V, -12V (CN6) ................... 22
Main power connector, +5V, +12V (CN11) ....................... 22
Fan power supply connector (CN14).................................. 22
Serial ports (CN13, CN8) .................................................... 23
COM1 RS-232 port (CN13)............................................... 23
COM2 RS-232/422/485 selection (CN8)........................... 23
VGA interface connections.................................................. 24
CRT display connector (CN1)............................................ 24
Flat panel display connector (CN2) ................................... 24
Ethernet configuration ........................................................ 25
10BASE-2/10BASE-5 AUI connector (CN7) .................... 25
10BASE-T connector (CN10) ............................................ 26
Network boot ...................................................................... 26
Watchdog timer configuration............................................ 26
Watchdog timer enable/disable .......................................... 26
Watchdog timer action (J23, J24)....................................... 26
Solid State Disk Configuration ........................................... 27
Memory devices ................................................................. 28
Memory address selection (J27) ........................................ 29
I/O address selection (J27) ................................................. 29
Drive emulated (J27) .......................................................... 30
SSD device and size selection (J31, J30) ........................... 31
SSD hardware enable/disable (J29).................................... 31
DOS 5.0 .............................................................................. 32
DOS 3.3 .............................................................................. 32
Booting from the Flash/ROM disk..................................... 33
Inserting memory devices .................................................. 33
Using a memory manager (EMM386.EXE) ...................... 34
Chapter 3 Software Configuration ......................... 33
Introduction.......................................................................... 34
Utility disk ............................................................................ 34
VGA display software configuration .................................. 36
Connections for four standard LCDs ................................. 38
Connections to Sharp LM64183P
(640 x 480 DSTN MONO LCD)........................................ 38
Connections to PLANAR EL
(640 x 480 AD4 EL)........................................................... 39
Connections to Toshiba LTM09C016
(640 x 480 TFT Color LCD) .............................................. 40
Connections to Sharp LM64C142
(640 x 480 DSTN Color LCD)........................................... 41
Ethernet software configuration......................................... 42
Chapter 4 Award BIOS Setup .................................... 45
System test and initialization .............................................. 46
System configuration verification ..................................... 46
AWARD BIOS setup............................................................. 47
Entering setup..................................................................... 47
Standard CMOS setup........................................................ 48
BIOS features setup............................................................ 49
CHIPSET features setup .................................................... 50
Power management setup ................................................... 51
Load BIOS defaults............................................................ 52
Change password ................................................................ 53
Auto detect hard disk ......................................................... 54
Save & exit setup................................................................ 54
Exit without saving............................................................. 54
Chapter 5 SVGA Setup............................................... 55
Simultaneous display mode ................................................. 56
Sleep mode ............................................................................ 56
Software support .................................................................. 57
Driver installation ................................................................ 58
Windows setup ................................................................... 59
AutoCAD R12.................................................................... 62
Lotus 1-2-3 and Lotus Symphony...................................... 64
VESA ................................................................................. 66
Word ................................................................................... 67
WordPerfect ........................................................................ 68
Appendix A Programming the Watchdog Timer .... 71
Appendix B Installing PC/104 Modules .................... 73
Installing PC/104 modules................................................... 74
Appendix C Pin Assignments ................................... 77
CRT display connector (CN1)............................................ 78
Flat panel display connector (CN2) ................................... 78
PC/104 connectors (CN3, CN5)......................................... 79
Front panel connector (CN4) ............................................. 80
Peripheral power connector (CN6)..................................... 80
10BASE-2/10BASE-5 AUI connector (CN7) .................... 80
COM2 RS-232/422/485 serial port (CN8)......................... 81
Keyboard and mouse connector (CN9) .............................. 81
Ethernet 10BASE-T connector (CN10) ............................. 82
Main power connector (CN11)........................................... 82
IDE hard drive connector (CN12) ...................................... 82
COM1 RS-232 serial port (CN13) ..................................... 83
Fan power connector (CN14) ............................................. 83
Floppy drive connector (CN15) ......................................... 84
Parallel port connector (CN16) .......................................... 85
Appendix D Optional Extras ..................................... 87
PCM-10586-1 Cable kit for PCM-4862/5860.................... 88
PCM-20486-1 Boot ROM binary files for............................
PCM-4860/4862 ................................................................. 88
Chapter 1 General Information 1
1
General
Information
This chapter gives background informa-
tion on the PCM-4862.
Sections include:
• Card specifications
• Card layout and dimensions
CHAPTER
2PCM-4862 User's Manual
Introduction
The PCM-4862 is an enhanced, all-in-one single board 486
computer with an on-board Ethernet interface, local-bus SVGA
controller and solid state disk. The PCM-4862 offers all the
functions of an AT-compatible industrial computer on a single
board, but it fits in the space of a 5¼" floppy drive (only 5.75" x
8"). For maximum performance, the PCM-4862 also supports 2nd
level cache sizes from 128 KB to 512 KB (32 KB x 8, 64 KB x 8,
or 128 KB x 8).
On-board features include two serial ports (RS-232 and RS-232/
422/485), one parallel port, an enhanced IDE hard-drive controller
(for up to two drives), a floppy-drive controller and a keyboard/PS/
2 mouse interface. The board's watchdog timer can automatically
reset the system or generate an interrupt if it stops due to a program
bug or EMI problem.
An on-board solid state disk (SSD) emulates a floppy drive using
EPROM or Flash memory devices. You access the SSD using
standard DOS commands or BIOS I/O. The system can even boot
from the SSD. Disk capacity is up to 1.44 MB, depending on the
size of the memory chips. If you use Flash memory, you can read
and write to the disk just like a floppy. If you use EPROM, the disk
is read-only and you must program the chips with an EPROM
programmer.
The PCM-4862 also complies with the "Green Function" standard
and supports three types of power saving features: Doze mode,
Standby mode, and Suspend mode.
All display and Ethernet configuration is done through software. A
single Flash chip holds the system BIOS, VGA BIOS and the
network boot ROM image. This minimizes the number of chips and
eases configuration. You can change the display BIOS or install a
boot ROM simply by programming the Flash chip.
If you need any additional functions, you can add up to six
industry-standard PC/104 expansion modules. For those who
require special functions, we have developed a PC/104 to ISA
adaptor so you can use your standard ISA card.
Otros manuales para PCM-4862
1
Tabla de contenidos
Otros manuales de Placa madre de Advantech
Advantech
Advantech PCI-6870F Manual de usuario
Advantech
Advantech PCA-6743 Manual de instalación y operación
Advantech
Advantech AIMB-744 Series Manual de usuario
Advantech
Advantech PCM-3864 Manual de usuario
Advantech
Advantech PCM-5820 Series Manual de usuario
Advantech
Advantech ASMB-782 Manual de instalación y operación
Advantech
Advantech SIMB-M01 Manual de instalación y operación
Advantech
Advantech AIMB-210 Manual de usuario
Advantech
Advantech SOM-6868 Manual de usuario
Advantech
Advantech WISE-DB1500 Manual de usuario
Advantech
Advantech RSB-6410 Manual de usuario
Advantech
Advantech MIO-5270 Manual de instalación y operación
Advantech
Advantech PCM-9550F Manual de usuario
Advantech
Advantech AIMB-213 Manual de usuario
Advantech
Advantech PCE-5126 Manual de usuario
Advantech
Advantech ASMB-913I Manual de instalación y operación
Advantech
Advantech PCM-9575 Manual de usuario
Advantech
Advantech AIMB-214 Manual de usuario
Advantech
Advantech AIMB-785 Manual de instalación y operación
Advantech
Advantech AIMB-340F series Manual de usuario
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
