Acurix X52-HN Manual de usuario
WLAN 802.11 A/B/G/N MINI-PCI
WIRELESS RADIO MODULE
USER MANUAL
MODEL: X52-HN
Version 1.0 –27 August 2010
© 2010 Acurix Networks
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 3 of 31
Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
form or by any means, whether electronic, mechanical, photocopying, recording or otherwise without
the prior written consent of the publisher.
Windows™XP/Vista are trademarks of Microsoft® Corp.
Pentium is trademark of Intel.
All copyright reserved.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates; uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter.
If this device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor
environment only.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Important Note:
This module is intended for an OEM integrator. The OEM integrator is still responsible for the FCC
compliance requirement of the end product, which integrates this module.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 4 of 31
20cm minimum distance has to be able to be maintained between the antenna and the users for the
host this module is integrated into. Under such configuration, the FCC radiation exposure limits set
forth for an population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment.
Users Manual Of The End Product
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be
available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Label On The End Product
The final end product must be labeled in a visible area with the following "Contains FCC ID: UWT-X52-
HN". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement
has to also be available on the label:
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 5 of 31
Table of Contents
Copyright Statement........................................................................................................3
FCC Statement .................................................................................................................3
Users Manual Of The End Product ....................................................................................4
Label On The End Product ................................................................................................4
1. Introduction.................................................................................................................6
1.1 System Requirements.......................................................................................................... 6
2. Driver/Utility Installation / Uninstallation.....................................................................7
2.1 Installation........................................................................................................................... 7
2.2 Additional Setup Processes ............................................................................................... 11
2.3 Uninstallation .................................................................................................................... 11
3. Connecting to an Existing Network ............................................................................. 15
4. Additional Note for Windows XP ................................................................................ 19
5. Modifying a Wireless Network.................................................................................... 24
5.1 Infrastructure Mode and Ad Hoc Mode ............................................................................ 24
5.2 Modifying a Wireless Network .......................................................................................... 25
5.3 Default Settings Windows XP Zero-Configuration............................................................. 30
Appendix A: FAQ about WLAN........................................................................................ 31
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 6 of 31
1. Introduction
Thank you for purchasing the WLAN 802.11 a/b/g/n mini-card Module that provides the easiest way
to wireless networking. This User Manual contains detailed instructions in the operation of this
product. Please keep this manual for future reference.
1.1 System Requirements
A laptop PC containing:
50 MB of free hard disk space (minimum)
256 MB of RAM or later (recommended)
900 MHz processor or higher
Microsoft® Win™2000/XP/Vista
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 7 of 31
2. Driver/Utility Installation / Uninstallation
2.1 Installation
Note: The Installation Section in this User Manual describes the first-time installation for Windows. To
re-install the driver, please first uninstall the previously installed driver. See Chapter 2.3
“Uninstallation”in this User Manual.
Follow the steps below to complete the driver/utility installation:
1. Install you card in your laptop and insert the Installation Software CD into the CD-Rom Drive.
2. Click “Next”.
3. Read the License Agreement and choose “I accept the items of the license agreement”, then click
“Next”.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 8 of 31
4. Choose this option to install the driver and client utilities, and click “Next”.
5. Click “Next”to continue or click “Browse”to choose a destination folder.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 9 of 31
6. Click “Next”to continue or change the name of the program folder.
7. Click “Next”.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 10 of 31
8. Choose the configuration tool for your client card and click “Next”to continue.
9. Click “Yes”to continue.
10. Click “OK”to continue.
Acurix Networks - User Manual X52-HN
Confidential. © 2010 Acurix Networks
Page 11 of 31
11. Installing process.
12. Reboot your computer.
2.2 Additional Setup Processes
During software installation procedure, each operating system may prompt different specific options:
1. Windows 2000/XP/Vista: Select “Install the software automatically”when the window with this
option appears, and then click “Next”to continue installation.
2.3 Uninstallation
Note: Before uninstallation, please close all running programs.
1. Click Start>Programs>Control Panel >Install/uninstall program>Atheros client installation program>.
Otros manuales de Unidad de control de Acurix
Manuales populares de Unidad de control de otras marcas
Festo
Festo Compact Performance CP-FB6-E Manual de lista de piezas
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manual de usuario
JS Automation
JS Automation MPC3034A Manual de usuario
JAUDT
JAUDT SW GII 6406 Series Guía rápida
Spektrum
Spektrum Air Module System Manual de usuario
BOC Edwards
BOC Edwards Q Series Manual de usuario
