ACTIVE CLUB POS HARDWARE SETUP 10
ACTIVE CLUB SOLUTIONS, INC.30NOVEMBER 2019
Pairing Walker Bluetooth readers
The Walker credit-card reader comes in two versions: the version obtained from EVO Payments
works from the iPad headphone jack, as described above. The reader supplied by OpenEdge is a
Bluetooth model, which must be paired with your iPad.
To set up the Walker BT card reader:
1. Look at the light on the reader.
2. When it is first turned on, it will blink red and green. When the red/green blinking stops, what
do you see?
3. If it is blinking green, you are ready to process a card or pair the reader if it has not been
done already.
4. If it is a solid green, hold the power button for five seconds and make sure it starts blinking
green.
5. Once you see that the reader is blinking green you are ready process the card or pair the
reader if it has not been done already.
6. If successful, you are done.
7. If the OpenEdge mobile app says it can’t find any readers, delete the OpenEdge mobile app
from the iPad and reinstall it from the Apple Store.
8. Try to process a card, it will open the OpenEdge mobile app and ask you to choose the
Walker BT reader (Make sure the reader is blinking green or go back to steps 1-5 again).
Choose the Walker BT reader.
9. It will search for the reader and then select the reader when it appears.
[CV]
