Preface
ML510Dx Installation Guide v
General Safety Summary
1.
Read and follow all warning notices and instructions marked on this product or included in this manual.
2.
All installation, repair or replacement procedures must be performed by qualified service personnel.
3.
Before attempting to operate or repair this product, make sure product is properly grounded.
4.
This product uses an external power source. Do not touch exposed connections, components or wiring when
power is present.
5.
Do not operate this product with panels removed or with suspected failure or damage to electrical components.
6.
Do not operate or repair this product in wet or damp conditions or in an explosive atmosphere.
7.
Keep product surfaces clean and dry.
8.
Provide proper ventilation.
9.
Observe all ratings and markings on the product. Before making connections to the product, consult the
appropriate chapters of this manual for further ratings information.
10.
Many of the cables for this product are supplied by Actelis Networks. Cables that are supplied by the customer
must comply with the regulatory inspection authorities and are the responsibility of the customer. To reduce the
risk of fire, make sure all cables are UL Listed or CSA Certified.
11.
This equipment must be installed according to country national electrical codes. For North America, equipment
must be installed in accordance with the US National Electrical Code, Articles 110–16, 110–17 and 110–18 and the
Canadian Electrical Code, Section 12. If necessary, consult with the appropriate regulatory agencies and inspection
authorities to ensure compliance.
12.
Over-current Protection: It is recommended to incorporate in the building wiring, a readily accessible listed branch
circuit overcurrent protective device rated to 2A min. and 5A max.
13.
The equipment shall be connected to a NON-GROUNDED POWER supply system.
14.
When using a fiber optic port, never look at the transmit laser while it is powered on. Also, never look directly at
the fiber TX port and fiber cable ends when they are powered on.
Prevention of Electrostatic Discharge (ESD) Damage
1.
When working with electronic components, wear a commonly grounded antistatic wrist strap to discharge the static
voltage from your body in accordance with approved standards.
2.
Do not use any devices capable of generating or holding a static charge in the work area where you install or remove
electronic components. Avoid handling electronic components in areas that have a floor or benchtop surface capable
of generating a static charge.
3.
Do not slide electronic components over any surface. Do not touch exposed connector pins. Handle electronic
components as little as possible.
4.
Transport and store electronic components in an approved static-protected bag or container.
Consumer Notice
The purchased Actelis' product is subject to Directive 2002/96/EC of the European Parliament and the Council of the
European Union on waste electrical and electronic equipment (WEEE) and, in jurisdictions adopting that Directive, is
marked as being put on the market after August 13, 2005 and should not be disposed of as unsorted municipal waste.
Please utilize your local WEEE collection facilities in the disposition of this product and otherwise observe all applicable
requirements.
