Acer TravelMate B3 Manual de usuario
1
TravelMate B3 / TM311R-31 / TM311RN-31 / TMB311-31 / TMB311R-31 /
TMB311RN-31 / TravelMate B311-31 / TravelMate B311R-31 /
TravelMate B311RN-31
Lifecycle Extension Guide
2
Self-Repair...............................................................3
Disassembly Procedures ..............................................5
Safety Guidelines........................................................................ 5
Recommended Equipment
............................................................ 5
WEEE Annex VII Component
.......................................................... 5
Pre-disassembly Instructions ..........................................................................6
Removing the Lower case
.............................................................................7
Removing the Battery
.................................................................................9
Removing the SSD
.................................................................................... 11
Removing the WLAN module
....................................................................... 12
Removing the USB board
............................................................................ 14
Removing the RJ45 board
........................................................................... 15
Removing the MB
..................................................................................... 16
Removing theTouchpad module
................................................................... 19
Removing the LCD panel
............................................................................ 21
Troubleshooting...................................................... 26
FRU (Field Replaceable Unit) List................................. 27
Exploded Diagrams .................................................. 28
To update your software ........................................... 31
To remove your personal data .................................... 31
3
Self-Repair
This chapter highlights the limited self-repair capabilities of the product.
Prior performing self-repair, familiarize yourself with the Safety Guidelines and
Recommended Equipment sections first as described in the chapter "Disassembly
Procedures".
Depending on model, the following key components are eligible for self-repair (if
applicable);
Battery pack
HDD / SSD module
DIMM module(s)
WLAN module
LTE module
If a particular key component is listed and thus would be eligible for self-repair, but is not
described in the 'Disassembly procedures' section, then this component is either not
present on the respective model, or it is present but embedded on the motherboard and
therefore not eligible for self-repair.
NOTE:
Do not attempt to replace other components than those listed above.
NOTE:
For replacement parts, always use only Acer certified components in order to
safeguard quality, optimum system performance, stability and reliability of the product.
NOTE:
Any damage to the product that occur during self-repair, or which has occurred as a
result of a careless or unsuccessful self-repair attempt, is not covered by the standard
product warranty.
Disassembly Procedures
Please refer to the chapter "Disassembly Procedures" for step by step disassembly
instructions.
System BIOS & Driver Updates
Visit http://www.acer.com/support to discover the available system BIOS and Drivers
for this product. After selecting the desired country/language, either enter the model
name or product serial number, or select the product from the list of suggested models
in order to get access to product-specific software and documentation.
4
To update system BIOS:
Download the desired system BIOS version from the website
Unzip the downloaded file to your computer
Double-click the extracted file in order to initiate the update process
The update process itself is fully automated and its progress is visualized by
means of a progress indicator
A visual notification is shown when the update is complete
NOTE:
Upgrading the system BIOS incorrectly, or intermittence of the system BIOS update
process could harm the product.
NOTE:
System BIOS upgrades or downgrades, if not performed by an Acer Service Center or
authorized Service Partner, are at own risk.
To update Drivers:
Run Windows Update in order to get the latest drivers from Acer:
select the Start button
go to Settings > Update & Security > Windows Update
Available Drivers will automatically be listed on screen., Press Download to
start the download of the respective driver
Installation of the driver will start automatically once the download is completed
Software Recovery
This product has embedded software recovery tools which can be used to either
perform a partial or full software recovery, but also to create a Factory Default
recovery media.
For more information about the software recovery options, how to perform a software
recovery or creating a Factory Default recovery media, please refer to the chapter
“Recovery” which is available in the User Manual of the product.
NOTE:
In the event of not being able to create a Factory Default recovery media, it is possible
to obtain a copy of the recovery media through Acer Customer Service
(http://www.acer.com/support)
This is not a free of charge service.
Disassembly Procedures
Safety Guidelines
This chapter contains step by step procedures on how to remove and de-install components from
the computer. Use the following safety guidelines to ensure your personal safety. Each procedure
included in this chapter assumes that you are preparing your computer for recycling and disposal.
By performing any of these procedures you acknowledge that any remaining warranty applicable
to your computer will be voided. Before you start any of the procedures in this chapter, make sure
to read the following safety guidelines and the respective instructions within the chapter.
CAUTION!
Turn off your computer and disconnect all power sources before opening the computer cover
or panels.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface at the same time as touching a connector
on the back of the computer.
Take off any metal objects on your arms or fingers such as bracelets, rings or watches and
make sure your hands are completely dry. Even if your unit is unplugged, there may still be
some remaining electric charge.
If a component does not come out easily, do not forcefully remove it. Instead, check that you
are removing it correctly and that no wires or other parts are in the way.
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself.
Some cables have connectors with locking tabs; if you are disconnecting this type of cable,
press in on the locking tabs before you disconnect the cable.
Recommended Equipment
The following equipment are recommended to do the following maintenance procedures:
Wrist grounding strap and conductive mat
Flat screwdriver
Philips screwdriver
Polydrive screwdriver
Plastic tweezers
Flat plastic pry
WEEE Annex VII Component
These
components are classified as requiring selective treatment.
Pre-disassembly Instructions
Before proceeding with the disassembly procedure, make sure to do the following:
1.
Turn off the power to the system and all peripherals.
2.
Unplug the AC adapter and all power and signal cables from the system.
3.
Place the system on a flat, stable surface.
Figure 3-1. Front View
Removing the Lower case
1.
Place the laptop on flat while lower case should be upwards. Use screwdriver to remove 10
screw of
lower case. The spec of NO 1 to NO 2 is SCREW_M2.5*6.7 mm_0.8 mm_4
mm_BLACK, the spec of NO 3 to NO 13 is SCREW_M2*5 mm_0.8 mm_4 mm_BLACK.
Figure 3-3. Lower case
Table 3-2. Lower case Screw
Step
Screw
Quantity
Screw Type
Torque/kgfcm
Remove
Lower case
SCREW_M2.5*6.7 mm_0.8
mm_4 mm_BLACK
2
2.0+/-0.1kgf.cm
SCREW_M2*5 mm_0.8
mm_4 mm_BLACK
11
2.5+/-0.1kgf.cm
2.
Open the buckle with a pick as showed figure3-4, then remove the lower case from the bottom
side as shown in picture.
Figure 3-4. Lower case
Figure 3-5. Lower case
Removing the Battery
1. Remove 2 screws from upper case.
Figure 3-6. Battery
Table 3-3. Battery Screw
Step
Screw
Quantity
Screw Type
Torque/kgfcm
Remove battery
SCREW_M2*4 mm_0.6
mm_5 mm_silver
2
1.8+/-0.1 kgf.cm
2. Remove the acetate cloth from the battery.
Figure 3-7. Battery
3. Disconnect the battery cable from the MB as shown in picture.
Figure 3-8. Battery
4. Remove the battery from the MB as shown in picture.
Figure 3-9. Battery
Battery : WEEE Annex VII component
Otros manuales para TravelMate B3
1
Este manual sirve para los siguientes modelos
8
Tabla de contenidos
Otros manuales de Computadora portátil de Acer
Acer
Acer AN515-57-79TD Manual de usuario
Acer
Acer TravelMate 4330 Series Manual de usuario
Acer
Acer Aspire One D270 Manual de usuario
Acer
Acer AO725 Manual de usuario
Acer
Acer 9410-2829 - Aspire Guía de configuración
Acer
Acer Aspire 5500 Guía de configuración
Acer
Acer TravelMate 370 series Manual de usuario
Acer
Acer Aspire 5737Z Series Manual de usuario
Acer
Acer Aspire 7551G Manual de usuario
Acer
Acer Chromebook 15 Manual de usuario
Acer
Acer TravelMate 270 Series Manual de usuario
Acer
Acer TravelMate 250P series Guía de inicio rápido
Acer
Acer Aspire 1500 series Manual de usuario
Acer
Acer TravelMate Spin B3 Manual de usuario
Acer
Acer TravelMate 3010 Manual de usuario
Acer
Acer TravelMate 4060 Manual de usuario
Acer
Acer Chromebook Spin 311 Manual de usuario
Acer
Acer Aspire 1690 Series Guía de configuración
Acer
Acer ASPIRE 5251 Manual de usuario
Acer
Acer TravelMate 8000 Guía de configuración
