Regularly clean with mild
liquid detergent or soap
and water
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material
1.
2.
1. Mount spindle attachment to spindle. IMPORTANT:
Ensure spindles are in the off position, turn clockwise
to turn off cold and ant-clockwise for hot.
2. Place cut tile on the face of the spindle attachment,
adjust its offset until the front face of tile is 43mm
from the face of the baseplate. Tighten the grub screw.
Remove the tile again and apply a bit of silicone to the
perimeter of the tile face and to the spindle attachment.
HHow to orientate the H/C symbol
At this point note where the symbol is located when the
handle is in the off position. Mark with a pencil the position
it needs to be. Return to step 2 and adjust the base plates
orientation by the referenced amount.
1. 2.
Mark out desired location of taps in relation to spout.
Cut holes using a 35mm hole saw.
Note: If cutting a stone bench top it will need to be cut
in a controlled environment by a licensed tradesperson
as per OH&S regulations.
Note: Spout
not included.
1
3 4
21. Screw spindle into in-bench breech, followed by the brass nut
and plastic washer.
2. Push spindles through holes and secure to the bench top,
ensure the base plates are 45mm down from spindle top.
This product must be installed by a licensed plumber. This is a general installation guide - there are many factors
involved that can alter the installation method. AU/NZ: For installations within Australia and New Zealand, this
product must be installed in compliance with AS/NZS 3500. UK: For installations in the United Kingdom this
product must be installed in compliance with the Water Supply (Water Fittings) Regulations and Water Supply
(Water Fittings) (Scotland) Byelaws. Other: For installations outside these countries, this product must be installed
in compliance with the standards in your respective country.
INSTALLATION GUIDE
