Lorem ipsum dolor
Sitananita ametete, consecteturity adipisicing elit, sed do eiusmod tempor incididunt ut
Detect - Isolate - repair
The FIM-RC has two potential-free switching contacts that connect to third party
instrument or equipment. Using these triggering relay contacts, a local source
automatically overrides when emergency paging from the VACIE is applied or a
local instrument can be energised. The FIM-RC is equipped with a power
capacitor that is charged by the LDB and has enough capacity to operate at least
two emergency cycles without the need for re-charging. The LED indicator(s) on
the FIM-RC are flashing with intervals to indicate quiescent or fault condition. The
FIM has two indicators that are related to the status of either LOOP-A or LOOP-B
side (Loop feed). Please refer to the User and Installation manual V01R01 for
detailed information on the various indications of these indicators.
The FIM-RC is equipped with clearly market connectors. The FIM-RC has a
LOOP -FEED and LOOP-RETURN connection that are not sensitive to
feeding direction. LOOP has a DC-carrier for charging and communication
purposes. !
Please observe correct connectivity:!
RED = PHASE / PLUS!
BLUE = ZERO / MINUS!
Detect - Locate - Isolate
NOTE:
The T-Branch switching load is maximised to 2000W. .!
The OVERRIDE signal must be sent together with any emergency message.
The override pilots-tone must be: 20kHz / 5Vrms (by default)
WAGO-quick-fit
The FIM is equipped with WAGO push-
terminals that accept up to 2,5 mm2 core
installation cable. A special tool is provided to
quickly remove all three wires in one run.
(Release-tool is included)
Field Remote Control Module - FIM-RC
FIM-RC QIG - V02R01!
Quickguide
Trigger threshold adjustment:!
Holding the reset button for 10-sec will force the FIM-RC in measurement state.
(Fast blinking) In this state it measures any HF signal on the line (>16kHz) and sets
it trigger threshold 2Vac above measured HF signal. !
!
Confirmation of new setting: Alternate blinking of indicators BLUE (5s-Fast).!
Rejection of new setting: Alternate blinking of indicators: ORANGE (5s-Fast
Activation at Threshold: Alternate blinking of indicators BLUE Slow
