2
Chapter I: Overview
Dear Valued Customer,
Thank you for purchasing 3nStar products. We are committed to continuously maintaining the
product quality and providing better after-sales service. In order to take full advantage of our
devices, we recommend reading through this manual before the driver installation.
1.1 Safety Information
●TRM006 is fully compliant with the relevant requirements of the national standard
GB/4943-2001 IT equipment security.
●Make sure the electricity meets the power requirements (such as voltage, frequency)
before installation and power outlet are properly grounded.
●Lightning may damage the product. Unplug the network cable, power cable or any
other conductors during lightning storms.
●Do not unplug the components and connections (except for the USB device) when the
power is on.
●Do not open the cabinet of the product by a non-professional technician.
●Do not leave any item or liquid inside the product. Do not place any objects into the
ventilation holes, it may cause short-circuit of the internal components and may cause
fire or electric shock.
●In accordance with the national standards GB/T9813-2000 microcomputers general
specification, after the computer is below the temperature of 10 ° C, place the machine
in room temperature (10-35 ° C) conditions for more than two hours to avoid damage
from low temperature. In the meantime, please do not remove the casing but allow the
computer to restore the natural temperature. Avoid heating the unit up too fast because
the computer may generate frost and condensation that might damage the electrical
components.
●This unit is in strict compliance with the electrical appliance standards.
●Safe use voltage range: 100V ~ 240V & 50Hz/60Hz.
●Verify that the power outlet is available to connect to a reliable ground circuit.
●Keep the device clean, dry, away from dust, moisture and direct sunlight.
●Do not share the same power outlet with high-power consumption electrical devices.
Keep distance from high level magnetic interference.
●Turn off the power to the monitor after use to extend useful life.
