ZyXEL Communications ACCESSORY-ZZ0106F Manual de usuario
Insert two radome brackets into the slots on the inner case's back
panel.
Use A, B and C to attach the bracket to the AP.
Note: Make sure the AP is turned off. Disconnect the PoE injector from the
power outlet.
Weatherproof Enclosure Kit
Mounting Kit (Sold Separately)
1
2
ENEN
Seal the inner case's wall mounting holes with two rubber plugs.
Repeat steps 3-7 of the Weatherproof Enclosure Kit Wall Mounting
QSG to prepare the AP for pole mounting.
ENEN
ENGLISH
AP and Rotating Bracket Assembly
Mounting Preparation
Repeat
Weatherproof Enclosure Kit
Wall Mounting QSG Steps 3 7~
x 2
1
x 2
1
2
Copyright © 2019 Zyxel Communications Corp. All Rights Reserved.
2/2 See the User’s Guide at www.zyxel.com for more information, including customer support and safety warnings.
Quick Start Guide
A
B
C
A
B
C
M6 Washers
x2
Hex Nuts
x2
M6 Spring Washers
x2
Wall Mounting
Weatherproof Enclosure Kit
Mounting Kit (Sold Separately)
ENGLISH
1
4
Copyright © 2019 Zyxel Communications Corp. All Rights Reserved.
2/2 See the User’s Guide at www.zyxel.com for more information, including customer support and safety warnings.
Use the four corner holes of the M bracket to mark holes on a wall.
Drill four holes in a wall.
Insert the screw anchors and screws into the holes.
Secure the M bracket to the wall.
2
3
ENEN Wall Mounting
1
2 3
95mm
95mm
C
B
A
B
C
Nylon Wall Plugs
x4
Unit: mm
25.4
8.0
x4
25.4
4.0
2.38
9
Unit: mm
Tapping Screw M4x25 mm
M Bracket
x1 A
Quick Start Guide
Use A, B and C to attach the brackets to the pole.
Use D, E and F to attach the AP with the port facing down to C on the
pole. Do not tighten the bolts too much.
1
2
ENEN Pole Mounting
1 2
A
E
Four M6 Hex Bolts x90L
x4
Four M6 Washers
x4
Secure the AP to the M bracket.
ENEN 4
D
E
F
M6 Hex Bolts x12 L
x4
M6 Spring Washers
x4
M6 Washers
x4
D
D
E
F
B
A
B
C
E
F
F
Four M6 Spring Washers
x4
Four M6 Hex Bolts x12 L
x4
DC
One M Bracket
x1
B
Two Flat Brackets
x2
Tabla de contenidos
Otros manuales de Recinto de ZyXEL Communications
