4
2.3 Measure Temperature
2.4 Freeze and save imaging
Press Freeze/Back button to
freeze the screen, then save the
imaging. Select cancel and
confirm to back to imaging
mode. The Voice annotation
notice will be on the screen
when saving the imaging if the
voice annotation function turned
on.
Press Menu Button to change the measure
point then aim the cursor to the target, then
the target temperature will be shown at the
top-left of the screen.
The temperature will be shown as “＞
XXX℃” or “＜XXX℃” when the target
temperature is higher/lower than the
selected temperature range.
[XXX=temperature range]
