CIB-BOS-0x
HARDWARE SPECIFICATION
CONFIDENTIAL DOC-USR-0197-01
____________________________________________________________________________________
Z3 Technology, LLC ♦100 N. 8th St. STE 250 ♦Lincoln, NE 68508-1369 USA ♦+1.402.323.0702
4.2 Connection to the DCK encoder, J3 and J4
The CIB-BOS board connects to the Z3 Technology DCK encoder system via connector J3 or J4.
The J3 connector header placed on the CIB-BOS board is a 30-pin header from JST, part number BM30B-
SRDS-G-TF. It is designed to connect to the same connector on multi-channel capable versions of the Z3
DCK encoder product line, such as the FV2K-DCK-13 and FV4K-DCK-15.
The J4 connector is a KEL micro-coaxial connector part number USL00-30L. It is meant to connect to the
KEL connector on HD versions of DCK systems.
This connection mode is NOT COMPATIBLE WITH 4K ENCODER SYSTEMS.
Please be sure to ONLY USE KEL CABLES PROVIDED OR APPROVED BY Z3 TECHNOLOGY.
NOTE:Connecting J4 to a 4K capable encoder will likely cause permanent damage to the encoder,
Boson camera and CIB-BOS board.
NOTE: Connecting J4 to the encoder using a non-approved KEL cable will likely cause permanent
damage to the encoder, Boson camera and CIB-BOS board.
Both J3 and J4 connectors carry LVDS digital and video from the camera to the encoder, power from the
encoder to the camera and bi-directional serial communication for camera control.
Table 2: shows the pin assignments for J2:
