Yukon Trail Puma 200 Manual de usuario
Read Instructions Before Using Your New Puma 200
DO NOT RETURN STORE. For questions regarding assembly and
use,
call Customer Service: 877-441-6999.
Table of Contents
NOTICE. . . . . . . ...........................................................2
SAFETY GEAR................................................................3
MODIFICATION OF VEHICLE................................................3
SPECIFICATIONS.............................................................
PARTS & SUBASSEMBLIES..................................................5
OPERATION ..................................................................6
FUEL VALVE.............................................................6
ENGINE STARTING AND STOPPING..................................7
SWITCHES ON THE RIGHT HANDLEBAR........................... .8
CHECK-UPS, ADJUSTMENT AND MAINTENANCE.......................9
CHANGING THE OIL....................................................10
CHECK-UP OF SPARK PLUG ..........................................10
CHECKING & CLEANING THE AIR FILTER...........................11
ADJUSTING THE THROTTLE CABLE.................................12
ADJUSTMENT OF REAR BRAKE.......................................13
ADJUSTMENT OF CHAIN...............................................1
GREASING PROCEDURES TO THE DRIVING CHAIN.................1
VEHICLE WASHING.....................................................15
INSTRUCTIONS FOR STORAGE .......................................16
RESUMPTION OF SERVICE AFTER STORAGE .......................17
TABLE AND TORQUE OF FASTENERS ...............................17
MAINTENANCE ROUTINE DIAGRAM..................................18
TROUBLE SHOOTING...................................................19
EMISSION CONTROL SYSTEM WARRANTY..........................20
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
NOTICE!
NOTICE!NOTICE!
NOTICE!
Fai ure to fo ow these instructions nu ifies any warranty, whether
stated or imp ied.
Before operating your Puma 200 Mini Bike
Warning!
A pre-operation check must be conducted, before starting the
engine, insure safety, prevent mishaps, and damage to components.
It is strongly suggested that all operators take a certified motorcycle
rider’s course prior to operating the vehicle.
Full attention is required during driving; paying close attention to the
following points to avoid any injury to you by other motorized vehicles:
Do not drive too close to other vehicles.
Never carry a passenger. This mini bike is for one operator only
Never operate this mini bike at night. Night is defined as the period of
time 30 minutes before sunset to 30 minutes after sunrise.
Driving at high speeds is the cause of many accidents; do not drive at a
speed that the actual situation does not permit.
This user’s manual contains important safety and maintenance
information. Read it carefully before riding. Failing to follow the
warnings contained in this manual could result in INJURY or DEATH.
It is important that this manual remain with the vehicle when you
transfer it to another user or owner.
All information, illustrations, photographs and specifications
contained in this manual are based on the latest product information
available at the time of publication. Due to improvements or other
changes, there will be some discrepancies in this manual. We reserve
the right to make product changes at any time, without notice and
without incurring any obligation to make the same or similar changes
to the vehicle previously built or sold.
Always avoid operating this mini bike on paved surfaces, including;
sidewalks, paths, parking lots, driveways, streets, roads, and highways.
Never operated this or any Off-Road vehicle on a public street, road or
highway where motor vehicles are in operation.
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
SAFETY GEAR
1. Never operate this mini bike without wearing a DOT approved
motorcycle helmet which fits properly. Operators should also
wear eye protection (goggles or face shield), gloves, boots,
long-sleeved shirt or jacket, and long pants.
2. Loose clothes are not suitable for motorcycle driving or
riding as they may get caught on footrest or wheel, resulting
in danger.
MODIFICATION OF THE VEHICLE
CAUTION
Never perform any unauthorized modif
ications to this vehicle.
Only use original replacement part which can be obtained
through YUKON TRAIL INC. 877- 1-6999
DO NOT RETURN STOR
E. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
SPECIFICATIONS
Description Data Description Data
Overall length
1680mm
(66.1 inch)
Cylinder bore
x stroke
6.8cm X 15. 1cm
(2.68” X 2.13”)
Overall width
800.1mm
(31.5 inch)
PTO shaft
rotation Counter clockwise
Overall height
979.9mm
(38.58 inch)
Output, max 6.5hp at 3600 rpm
Wheelbase 1162mm
( 5.75 inch)
Torque, max 9.76 ft-lbs. at
2500 rpm
Dead weight 6 . 6 kg
(1 2.1lbs.) Idling speed 1 00 +200 -150
Payload 91kg
(200 lbs)
Displacement
of cylinder 197cc
Front wheel 19 X 7 - 8
10psi Spark plug
MEIYA -F7RTC,
NGk- BPR6ES,
Champion - RN9YC
Rear wheel 19 X 7 - 8
10psi
Spark plug
gap
0.7mm -0.79mm
(.028”-.031”)
Brake Type Drum
Gap of air
valve IN
0.15 +
-
.02mm
(cold)
Capacity of
gasoline tank
.2L
(.95 gal.)
Gap of air
valve EX
0.20+- .02mm
(cold)
Capacity of oil
tank
.5L
(.53 qt.)
Ground
clearance 139 mm (5.5”)
Drive
C
entrifugal
clutch
Ignition
means Magneto
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
PARTS & SUBASSEMBLIES
Throttle twist grip
Hand brake
Headlight
Clutch Cover
Drive Chain
Footrest
Front Shock
Front Wheel
Rear Wheel
Kickstand
Vehicle Identification Number
Decorative Tank
Seat Cushion
EPA Sticker
Air Filter
Side Panel
Gas Tank
Pull Start Cord
Brake Drum
Fender
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
OPERATION
FUEL VALVE
Fuel filling
The capacity of the fuel tank is .2L (.95 gal). Unscrew the gas cap by
turning it counter clockwise and carefully fill the tank with unleaded
gasoline through the opening. DO NOT MIX GAS AND OIL TOGETHER,
THIS IS A -STROkE ENGINE. Replace the gas cap by carefully aligning
the threads on the cap and the tank and turning the cap clock wise.
Wipe any spilled fuel from the dirt bike using a cloth and dispose of
the cloth properly. DO NOT SMOKE OR REFUEL THE VEHICLE NEAR
OPEN FLAMES OR NEAR HEATING UNITS. ONLY REFUEL THE VEHICLE IN
OPEN AREAS TO REDUCE THE LIKELIHOOD OF THE BUILD UP OF
GASOLINE FUMES.
Filler neck
Operation of the fuel valve (the valve under the fuel tank)
ON: With the handle of the fuel valve to “ON” position, the fuel
supply will flow to the carburetor.
OFF: With the handle of the fuel valve to “OFF” position, the fuel
supply is cut off to the carburetor.
Fuel valve Handle
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
ENGINE STARTING AND STOPPING
Never start the engine in a closed place as the exhausted
gas from the vehicle contains toxic carbon monoxide.
Starting Engine:
1. Place fuel valve lever to “ON” Position.
2. Place Choke lever to “ON” Position.
3. Set the ignition switch to “ ” Position.
. Pull the Start Recoil cord until engine starts.
5. After engine has sufficiently warmed up,
place Choke lever in “OFF” Position.
Procedures for stopping engine:
1. Release throttle twist grip to slow down engine.
2. Set the ignition switch to “ ” position.
3. Set the fuel valve lever (the fuel tank valve) handle to “OFF”
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
SWITCHES ON RIGHT HANDLEBAR
Ignition switch
The ignition switch is provided on the right handlebar.
When the switch is turned to “ ” (off) position, the engine will
not start or stops the engine.
When the switch is turned to “ ” (on) position, the engine can
start and the vehicle can be driven.
OFF button
ON button
DO NOT RETURN S
TORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
CHECK-UPS, ADJUSTMENT AND MAINTENANCE
Checking the Oil
Check the engine oil each time prior to operating the mini bike.
The oil level should be between the upper and lower lines of the oil
gauge.
1. Set the Mini Bike on level ground, screw off the oil gage plug, wipe
the oil gage rod clean and then insert the gage plug into the
crankcase again to check the oil level. There is no need to screw
the oil gage plug into its hole in the crankcase.
Lubricating Oil Recommended
The lubricating oil is an important factor affecting the performance
and service life of the engine. Please refer to the chart for the correct
grade of engine oil based on the environmental conditions in your
area. Do not use any other type of oil other than what is
recommended in the chart. DO NOT MIX OIL WITH THE GASOLINE.
Lubricating oils of different viscosity shall be employed in different
regions and at different temperatures.
Otros manuales para Puma 200
1
Tabla de contenidos
Otros manuales de Motocicleta de Yukon Trail
Manuales populares de Motocicleta de otras marcas
MOTO GUZZI
MOTO GUZZI QUOTA 1100 ES Manual de usuario
APRILIA
APRILIA ETV MILLE CAPONORD - PART1 02-2001 Manual de usuario
Yamaha
Yamaha 2006 YZF-R1V Manual de usuario
KTM
KTM Freeride E-XC 2021 Manual de usuario
Fantic
Fantic Enduro 125 Manual de usuario
Ducati
Ducati Supersport 750 desmodue Manual de usuario
